Question about 2001 Honda Passport
My heater blower went out. Is it common for the fuse to blow, or more likely that the blower motor went out?
As above check all fuses, connections, etc..but before replacing the entire blower motor it would be wise to inspect or even replace the blower fan resistor. This is usually the fault but only stops the fan working on full speed.Check to see if the fan is not blowing on all 4 speeds first. If only the fastest speed is not working its gotta be the resistor.
Posted on Jan 24, 2013
Testimonial: "Fuse was fine. And it does blow on all 4 speeds, it is just hit and miss. Usually when the motor is cold and the truck is at a stand still it doesn't blow. Once the vehical is in motion, it starts up and won't shut off until the truck is turned off. "
Normally when the blower motor goes out it has trouble a few days before and cuts in and out so I would check fuses first but I may be wrong and if the fuses are fine the I would change the motor
Posted on Jan 22, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
if your not getting any air coming out of the vents then your problem is your blower motor. test the wire harness to see if its getting power,if it is then your blower motor is bad if its not getting power then check your relay.
Posted on Jan 17, 2009
you need to remove your glove box assy.(beleave only 2 screws and pivot clips) make sure its not anything from glove box that has slipped behind. once box is out uf way you can access easier the blower motor assy. it actually attaches into blower box from bottom side. when looking at you will find three screw/bolts fastening motor to casing. remove those and then slowly lower motor and fan cage(attached to motor shaft) out from housing. sometimes it takes a little convincing to come out but not real tough. once out you most likely find the object causing noise in fan cage or resting up on lip area of housing unit. once found install in reverse order. let me know if this helps or if we need to dig a little deeper into! good luck!
Posted on Feb 02, 2009
Tips for a great answer:
Nov 23, 2015 | Mitsubishi Cars & Trucks
Dec 10, 2013 | Cars & Trucks
Dec 19, 2011 | Cars & Trucks
Nov 14, 2011 | 2004 Renault 181
Nov 10, 2011 | 1991 Mazda 323
Nov 30, 2010 | 2001 Dodge Stratus
Feb 10, 2010 | 1995 GMC Jimmy
Jan 02, 2010 | 1997 Ford Contour
348 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: