Question about 2001 Kia Sportage

1 Answer

2000 kia sephia car will not move in drive but will in second if i rev up the rpm. will move in reverse and first gear

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Your transmission is in need of replacing.

Posted on Jan 31, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

StormStrikes
  • 104 Answers

SOURCE: Transmission fluid capacity for 2000 Kia Sephia?

The four speed automatic shows a total fill (that is all the fluid it can hold) is 5.7 Quarts. So if you just dropped the pan and relplaced the filter, you shouldnt need more than 4 quarts and likely you would have a little extra with that.

Posted on Dec 30, 2008

  • 3 Answers

SOURCE: 2000 kia sephia clutch

this is a big job for someone who is not mechanically inclined but....here it goes go buy a new clutch new tranny fluid and a haynes manual at the auto parts store your going to have to drain and drop your tranny ... BUY THE CLUTCH WITH THE TOOL theres an alignment tool needed to align the plates n bearings start by pulling off both tires, brakes and both cv axels be sure to remove the intermediate shaft from the tranny on the passenger side (should come out with the axel passenger side only) so do yourself a favor and buy an impact gun with at least 500 ft lbs torque youll need it also have handy your 14mm 17mm and 19mm impact sockets and remember this job usually runs around 1,200 bucks at firestone also DO NOT remove the bolt in the middle of the front springs under the hood just the four around it and the will pop out no prob and wont need to be clamped remove the starter behind your engine its under the oil filter also if your new to this sorta thing its gonna take you about 3 days to do it buy the impact gun if ur in a hurry look at a pawn shop have your flywheel machined its going to be accessible and it needs it hope this helps dont forget the book which you should already have bought anyway its good for your torque specs which you will also need a torque wrench for the clutch also dont crack open ur tranny this isnt a honda

Posted on Jan 05, 2009

  • 1 Answer

SOURCE: Overdrive light keeps blinking and sometimes won't shift

O/D light blinking won't shift into 3rd or 4th error codes are P1624,P0733,P0734. could this be solenoids? can i replace it at home?

Posted on Mar 27, 2010

  • 1 Answer

SOURCE: No power, no acceleration, spits & sputters

Clean out clogged fuel injectors

Posted on Oct 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The 2000 Toyota 4runner will not move after engaging the drive gear


sounds like the torque convertor and you need a transmission shops help

Jul 21, 2016 | 2000 Toyota 4Runner

1 Answer

What could have happen i drove my car no problem when i returned to drive it i put in drive nothing won't move no response in rev or other gears 1999 kia sephia auto tran help


did you check fluid level if low could have burnt up transmission-check fluid level also check color if brownish and smells burnt fluid either was low or overheated and possible filter problem---internal failure with a gear----selector cable damaged or disconnected

May 21, 2014 | 1999 Kia Sephia

1 Answer

2000 Kia Sephia engine runs fine, but does not move in drive, low or reverse


Never heard of a transmission control reset, but after much research, I found they can be reset by removing both battery terminals, then touching both terminals together for 5 to 10 seconds, then seperate and reattach the terminals to battery. Evidently the transmission control has an internal memory. Try that first, then i sould suspect transmission control module. the control module controls every aspect of transmission shifting. Hope that helps!

Dec 16, 2013 | 2000 Kia Sephia

1 Answer

Feels like slipping transmission / transfer case


either your rear driveshaft is missing, your rear axle is pooched. the same transmission drives both ends.

Jul 23, 2017 | Chevrolet Blazer Cars & Trucks

1 Answer

2001 Kia Sephia automatic trans seems to be stuck in second gear, when manually shifted into first, starts off perfectly fine. When in drive, very sluggish on the take-off and does not shift out of the...


Alot of people have the same problem, including me. Changing the transmission fluid is not going to help this problem. THe transmission filter is not something you change as much as you clean and reinstall, its just a metal screen. Call Kia and ask for an "OVERDRIVE SHIFT SOLENOID" they will need the last 8 digits of your VIN, vehicle identification number, to locate your part. I am in the process of changing mine. The part number should be something like 46313-39051. That number is for a 2001 Kia Optima, with the 4 cylinder. There are three shift solenoids bolted to the bottom of your transmission should. I'll let you know what the difficulty level when I am finished.

Apr 05, 2012 | 2000 Kia Sephia

1 Answer

I have a 2000 Kia Sephia with an automatic transmission. It starts and runs fine, but all of a sudden, it won't shift into any gear. It won't make a noticeable sound or action while shifting from...


all of a sudden- lkike your driving down the road and it stops working? or your stuck at home? so what I gather is you have a good running car that wont move.... a couple of things to check.. look under the hood at your transmission... there is a link from your shifter to the tranny. have someone else move the lever from frive to low gear to park etc.. then you look under the hood and make sure the cable is still attatched to the trans. if it is attatched and not moving you might have a freyed cable... if none of this is working you prob. need a new tranny
hope this helps

Jan 22, 2011 | 2000 Kia Sephia

2 Answers

My kia sephia 2000 turn signal comes on and then stops alot then after driving for awhile it comes on normal can you tell me whats wrong


I have a 2000 kia sephia, i have went through 3 alternaters including brand new in 2 days. The alternaters are not charging my battery and burning the alternaters up with in minutes of putting them on. My engine light is blinking about 40 times. When i turn the trun signals on my speedometer an rpm gage jump up and down.

May 20, 2010 | 2000 Kia Sephia

2 Answers

How to replace knock sensor 2000 kia sephia


remove intake manifold support bracket. unpug the sensor then take the bolt that holds it out then reverse to relace

Apr 05, 2010 | 2001 Kia Sephia

Not finding what you are looking for?

Open Questions:

See all 2001 Kia Sportage Questions

2001 Kia Sportage Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...