Question about Volkswagen Cars & Trucks
Its a 2010. just started and it has never been this loud
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Squeaking noise at low speeds
take the front wheels off and look between the brake scratch plate and the rotor. - a stone trapped there will cause this noise. Also between the driveshaft and the hub, where the shaft enters the hub at the back. l
Look too for either a support bracket for a brake line or ABS wiring touching the driveshaft. Also there is an antisqueal spring on the back of the brake calipers someotimes this will touch the outside of the brake rotor, you'll see a shiny mark on the rotor if something is touching. Also the scratch plate on the back of the rotor can touch the inside of the wheel rim, again look for a shiny mark all the way around the inside of the rim. Lastly look at the face of the brake rotor for a circular scratch - indicates a stone stuck in the brake pad. Have fun!
Posted on Jan 07, 2009
Your transmission and cv axle is running dry. Grease it up, fill it up and try it again. And tighten whatever is loose that is allowing it to leak.
Posted on Apr 27, 2009
HI, i would inspect the strut assembly for loose structure asap. i would also inspect the wheel knuckle and rotor and tie rod ends for loose fit as well. inspect thoroughly.
Its most likely the CV-joint assembly. the boot may have slipped off, allowing the joint assembly to dry up. i advise to inspect all the above before looking at the CV-half joint assembly and boot.
Posted on May 25, 2009
caster,camber and, wheel bearings
have your car 4 wheel aligned this will adjust your rear caster and, camber.
have your wheel bearings checked
Posted on Sep 06, 2009
You are the bestt person to identtify the source of the sound before we can go about a long check list. so open up the bonnet if you think it is from the engine side. Look for possible noise from
1. water pump
2. Alternator bearings
3. Idler pulley
4.AC clutch pulley
5. Belts..Tip Is: try to pour some water over the belt to confirm
6. main crank pulley
Hope you check this out. Helpful I hope. Good day
Posted on Aug 19, 2010
Tips for a great answer:
Jul 28, 2016 | 1999 Plymouth Grand Voyager
Dec 10, 2012 | 2000 Cadillac DeVille
Nov 27, 2012 | Cars & Trucks
Sep 21, 2012 | 2001 Volkswagen Jetta TDI
Mar 25, 2011 | 1998 Toyota Sienna
Dec 08, 2009 | 1999 Dodge Ram 2500 4WD
Oct 14, 2009 | 1995 Honda Civic
Dec 25, 2008 | 2001 GMC Sierra 1500HD
Jul 26, 2008 | Ford Taurus Cars & Trucks
52 people viewed this question
Usually answered in minutes!