Question about 2006 GMC Yukon
I checked the voltage from the wire and it's only 9 volts. i opened the mechanism and put it to the wire and pressed the keyfob tho motor moves a little bit..i think it was on the supply voltage.. the motor cannot push the lock/unlock button because the supply voltage is low.. but why the supply is low..i really need help.. i searched for the wiring diagram on this but i can't find...
Check voltage at the 20amp locks fuse. If good, check voltage coming out of door unlock relay. One of the locks is likely pullig down the voltage due to partial short in solenoid coil.
Posted on Aug 05, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: My 2006 Yukon tailgate will
I have the same problem. This is a faulty actuator switch according to GMC which controls the tailgate and the hatch window. My 2006 has 90,000 miles on it (I purchased new). Warranty is not an option and cost is estimated @ $600.00 in Arizona. As far as I am concerned, it is safety related issue and should be a recall since there isn't a mechanical way to open the tailgate or window as an escape route in the event of failure.
Posted on Nov 16, 2008
The best way to get a good diagram would be to get a haynes book from an autoparts store. They often lend them out for a small deposit. Depending on the motor i could give more information.
Posted on Apr 17, 2009
The Actuator is not functioning anymore, check to see if there is a fuse for it first. If that is ok then remove the actuator and test it outside using some wire and your car battery to see if actually moves or doesent this will tell you if you need a replacement.
Posted on Jul 15, 2009
Harris, did you find a solution to your problem? I am having the same issue on my 04 denali. Rear doors and tailgate wont lock but the unlock fine. Front door function normally? let me know.
Posted on Nov 18, 2009
Could be the latch mechanism for the door is sticking. You could try using some white grease on the latch and the contact where the latch hooks to. You can purchase the grease from most auto parts stores. You will not need to use alot. Just apply a small amount to the mechanisim and then work it in using the manual handle. Then open and close the door several times to feel the "action". Then apply a little more and repeat. This should loosen the latch and get it working again. Also make sure that none of the tension springs have come loose on the latch. And check the seal around the door and make sure it is not pinched and has a proper fit.
Posted on Dec 29, 2009
Tips for a great answer:
Mar 30, 2013 | 2007 GMC Yukon
Sep 24, 2012 | 2006 GMC Yukon Xl Denali
Jun 22, 2010 | 2006 GMC Yukon Xl Denali
Feb 27, 2010 | 2006 Land Rover LR3
Jan 02, 2010 | 2003 GMC Yukon
Dec 29, 2009 | 2006 GMC Yukon Xl Denali
Jul 09, 2009 | 2005 GMC Yukon Xl Denali
Nov 18, 2008 | 2006 GMC Yukon
Oct 05, 2008 | 2006 GMC Yukon
34 people viewed this question
Usually answered in minutes!