Question about Cars & Trucks

Open Question

Reset proton arena remote key

Replaced key battery and am unable to reset the alarm

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: new battery, can't reset alarm

remove the alarm,their might be a passive switch on the alarm to turn it off with a special key,if you dont have the key break the lock so you can turn it off or try to open case of alarm and look at wires and then dertimine which ones to join or break,every alarm inside is different so you will have to work it out.

Posted on Nov 28, 2008

mcgyver468
  • 710 Answers

SOURCE: Does any body know how to reset the ML350 alarm??....The remote control doesn't work after i replaced a new battery to the remote control. I couldn't even use the remote to lock/unlock the car. I was

SOME OF THE REMOTES REQUIRE THAT THE KEY BE IN THE IGNITION, IN THE ON POSITION. TAKE THE BATTERY OUT AND WAIT 10 MINUTES. THEN PUT THE KEY IN THE IGNITION AND INSTALL THE BATTERY WHILE THE KEY IS TURNED TO THE ON POSITION. HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 18, 2009

  • 119 Answers

SOURCE: Unable to unlock Subaru Impreza 2006 via the remote key

sounds like battery is dead good luck

Posted on Jul 14, 2009

  • 1 Answer

SOURCE: 2001 Jeep Grand Cherokee Laredo. Alarm sets off

I found a solution on another site showing if i turn the ignition on and hold the reset button on behind the alarm light untill it turns to solid blue light then turn off the ignition , it will disable the alarm.

Posted on Dec 13, 2009

  • 105 Answers

SOURCE: key remote will not lock unlock set the alarm,

you can manually relearn your key. heres how- put the key in ignition turn key and ignition to run (not start) and hit unlock on the key. repeat this 4 times and you will here the doors unlock then hit the lock button and the doors will lock and your key will work properly.- note the ignition and unlock sequence needs to be done quickly. you may need to do it a couple times to get it right.- hope ths helps you

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2005 colbalt ..i dont hv the remote key..everytime i open the door with key or not alarm goes off..first like a horn sound then louder it goes off and sometimes not untill u turn key on


thats how its suppose to work the key resets alarm ==by a fob online for a few dollars and program to car [free program] ==when you use key to unlock and enter vehicle you have a few seconds after opening door to turn vehicle on or start it and doing so resets alarm when you leave vehicle and lock it alarm is active

Jul 25, 2016 | Cars & Trucks

1 Answer

How do I reset my car alarm for 2002 ford explorer? replaced battery and now the alarm wont turn off


With your remote unlock the door if you dont have a remote with your door key unlock the passager door and the rear hatch

Mar 10, 2015 | 2002 Ford Explorer

1 Answer

2001 Chevy express van replaced battery, security alarm will not shut off, van will not start


Hi. Is it a key or separate remote based alarm.if it is key based then there may be reset info in the owners hand book. Some cars are reset using the drivers door key barrel, turning left and right to simulate a number series on a pass card. If separate remote, I would try new batteries. Good luck

Jul 26, 2014 | Cars & Trucks

1 Answer

How to start a proton savvy with no chip in key housing


If not the battery (replacement) then check to make sure the transponder is not missing from the remote. Should be a small plastic to slot in the key. If still not working then you may need to reprogram it. It can only work if you have 2 set of keys to put in the ignition:

[1] Take the key that needs programming put it in the ignition and turn to the on position and then press and hold in the alarm reset button..

[2] While still holding in the reset button turn the ignition off and remove the key..

[3] Re-insert the key and turn the Ignition to the ON position.

[4] Release the alarm reset button and then press it in once..

[5] Now with the ignition still switched on take hold of your SPARE key and press the lock button on your spare key..the alarm should "BEEP" once..

[6] Now press the Lock button on the key that has lost its programming..alarm should "BEEP" again..

[7] Switch ignition off.

Try that it should work

Feb 21, 2013 | Cars & Trucks

1 Answer

Does any body know how to reset the ML350 alarm??....The remote control doesn't work after i replaced a new battery to the remote control. I couldn't even use the remote to lock/unlock the car. I was


SOME OF THE REMOTES REQUIRE THAT THE KEY BE IN THE IGNITION, IN THE ON POSITION. TAKE THE BATTERY OUT AND WAIT 10 MINUTES. THEN PUT THE KEY IN THE IGNITION AND INSTALL THE BATTERY WHILE THE KEY IS TURNED TO THE ON POSITION. HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

May 18, 2009 | 2007 Mercedes-Benz ML350

1 Answer

Jeep one year old. Keyless just stopped working. Engine starts for a second then cuts off. Replaced battery in key/remote and still doesn't work. Now alarm sounds if opened with the key the old...


Assuming you have a second key try using that one to deactivate the alarm, if not replace battery in remote. Does lock and unlock work now? you will need to get the remote operational to disengage the security feature that will not allow car to start.
if not disconnect the car battery let sit for 15 min to reset system try again..make sure bettery in remote is installed properly.

Nov 28, 2008 | Jeep Wrangler Cars & Trucks

1 Answer

New battery, can't reset alarm


remove the alarm,their might be a passive switch on the alarm to turn it off with a special key,if you dont have the key break the lock so you can turn it off or try to open case of alarm and look at wires and then dertimine which ones to join or break,every alarm inside is different so you will have to work it out.

Oct 30, 2008 | 2000 Mitsubishi Montero

1 Answer

My battery died after recharging it the alarm buttom needs to be reset. I need to know where the reset buttom is


HI ! I haven' t researched your car for you just yet !

I thought Id quickly mention the common method for reprogramming your alarm & remote, If you still require assistance then just ask me and I will find more about your car :)

Common Methods for resetting/re-learning code

  • Factory Fitted Alarms/ Central Locking / remote comes on ignition key.

Insert ignition key , turn key to accessories / red , press & hold lock/unlock for a few secs.remove key,exit vehicle and try un/lock doors &/or alarm (Some models differ slightly & require engine on or manual use of door locks whilst resetting.

  • Aftermarket /Non-Factory / remote is separately operated
Most use a small back-up battery usually located within the loudspeaker/Alarm unit itself under the bonnet,
Remove this battery for a short period to reset the remote code


The access panel for the backup battery is never in an obvious place. look carefully :)

Jul 14, 2008 | Hyundai Sonata Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...