SOURCE: 1996 mercury villager transmission won't go in reverse
You can have a shop diagnose the problem by checking for a computer code that should tell them about the conditon of the sensor or solenoid. You shouldn't have to start over with a new trans, but get referrals to a good shop first. Always check your fluid levels first, make sure they are what they should be and that the fluid looks good and red, not dark and dirty. Sometimes it's the easy stuff that gets overlooked.
SOURCE: car stalls while moving, then after 2-5 minutes starts back up
disconnect the fuel filter at both ends to see if the filter is clogged. If you are not getting any fuel on either end then you should get a new fuel pump.
SOURCE: Code reader knock sensor where is it located
According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.
108 views
Usually answered in minutes!
×