Your problem is more than likely the sensors in the doors. spray all the doors with electronic spray cleaner found at any auto parts store for about 5 bucks this should help clear the dirt and gook of the sensors inside the doors make sure you start with the front doors first
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The dome light feed comes from the ETACS ECU. There are four fused inputs: 7.5A multipurpose fuse 2, 15A multipurpose fuse 14 and, in the enngine compartment relay box, 10A DEDICATED fuses 17 and 18. One of these four should apply to the dome light
Look in your Owners manual for the dome light fuse. They make clips and fuses with extended terminals on them. Remember to use the correct side of the fuse holder to provide a fused circuit to that assemble if it does not have its own in-line fuse.
If you do not know which fuse is the correct one, it will probably be small, like 5 amps, and then just remove the small fuses until you find the one that cuts power to the dome light.
Let me guess? You cut the wires. You are supposed to disconnect all of them in the old door and pull them through. Then you remove door. Remove wires from donor door. Install donor door and pull the original UN-CUT wires through and re-connect.
hello,interior light you means front dome light?front dome get power supply from control unit under your fuse box,if you want remove your dome light, check wiring color light brown in socket mark c if no voltage,check wiring for continuity up to control unit,if you think it complicated,send to your dealer,ty
The diode for the interior dome light is located behind the driver's side kick panel. You have to remove the kick panel or get access to the wires behind the panel. The diode is located in the wrapped wires just to the left of the fuse box area. When you feel around the wrapped wires with your fingers, you will feel a small hard rectangular plastic piece behind the tape wrapping the wires. Carefully cut the tape at the spot and locate the diode. Remove the diode and replace with a new one (about $13-18 at Kia dealer) and test. Retape with electrical tape and replace kick panel and you are done. About a 15 minute job.