Question about 1995 Chevrolet S-10 CA Edition

1 Answer

I have a 1995 s10 pickup and the check engine light has come on,

Is this a serious promblem or can still drive the truck

Posted by on

  • pmetell937 May 11, 2010

    Has there been a change in the truck performance?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,201 Answers

You need to have a code scanner hooked up to it to find out why that light is on. If you have an autozone parts store near you,go to them, and they can hook one up, if not there are other ones that can do it. Once the code is retrieved, it tell you what it is.

Posted on Jan 27, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1995 Chevrolet S10 will not shift out of second gear is this limp mode if so how do I turn off limp mode

You will have to get a Chevy mechanic to plug it into a specialist diagnostic computer. If it is in 'limp' mode the engine management system has found a SERIOUS problem with car. Get it checked as soon as possible! You could be doing EXPENSIVE damage to you car when driving in 'limp' mode!!

Jan 02, 2018 | Chevrolet Cars & Trucks

3 Answers

When driving my Why would my s10 just quit

sounds like a loose power connection or bad wiring in the engine compartment. Check battery cables and ground connections at both ends of wires and cables first. If the problem remains, test equipment and a wiring diagram would come in handy.

Jan 11, 2015 | 1998 Chevrolet S-10 Pickup

1 Answer

Where is the oil pressure sensor lacted on a 1996 s10 2.2 Pickup

How much below 30 is it dropping? Oil pressure when in DRIVE at idle on a hot engine, is NORMAL at around 18 to 20 Psi. The warning lamp does not come on until around 7 Psi.

With that said, the oil pressure switch (for the light) is located on the lower left front of the engine. The fuel pump oil pressure switch and sender (for the gauge and fuel pump operation) is on the lower right front of the engine.

May 20, 2012 | Cars & Trucks

2 Answers

My 1999 s10 4.3 sputters when I give it gas ?

Check the fuel pressure regulator, a common problem for that model year

Dec 07, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1995 s10 pickup 4wd just replaced fuel pump, won't start.

replace the wireing harnes to the fuel pump gm had problems with them cost around $15 to 26 at autozone

Nov 18, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

2002 s10 manual trans 2.2 engine knock (low end?)

check out your knock sensor , just a thought.

Mar 07, 2009 | 2002 Chevrolet S-10

3 Answers

1995 S10 Pickup lacks power and makes a pinging noise

Engine ping can be a bad valve or berring so if there is a bad valve or berring your going to have to have the engine opened up. If its just dirty and from being clogged up, you can try useing products like Seafoam. Caution special note. you can go to Utube and look up how to do this. its not hard to do, it can be dangerous. If you play with things that light on fire, there is always a chance of getting hurt or doing damage.

You must make your own decision to try this to fix it.

Sometimes when the engine is just dirty and needs to get cleaned up a litle, this can help a lot. but if dirt is the only thing holding something together. when you clean it, it will break on you. So please consider if you really want to do this first.

I have done this on a regular basis and the Seafoam seams to work pretty good.

Hope I have helped and given you something to think about.


Feb 27, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1984 s10 2.8 manual trans. flywheel causes engine to vibrate

no should be same engine. check your engine mounts and tranny mount. how bad a vibration? sometimes after installing engine the trans gets shifted around and if mount was worn it will allow it to hit crossmeber and vibrate.

Jan 16, 2009 | 1984 Chevrolet S-10

Not finding what you are looking for?
1995 Chevrolet S-10 CA Edition Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides