Question about 2007 Mazda CX-7 Grand Touring

Open Question

2007 Mazda CX-7 electricity stalled out

While driving down the street, my 2007 Mazda CX7 just quit. None of the lights in the dash, no headlights, no electricity at all. I sat on the side of the rod for about 30 minutes. The car started again, but the Slip Indicator Light came on and would not go off. I couldn't pick up speed very well at all at first. Eventually I got back up to full speed, but the Slip Indicator Light still would not go off. I finally made it home, and was afraid to turn the car off, but did anyway. I then re-started the car and the Slip Indicator Light had gone off.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1998 mazda 626 stalls

I have a 91 mazda 626, runs great cold, but after 5 mins it stalls and won't start. After a few hrs it will start again, and 5 mins later it stalls and won't start.

Posted on Jan 06, 2009

Ad
  • 1986 Answers

SOURCE: 2007 mazda cx7

They're charging you for it? Since your car's only 2 years old, they should be covering it under warranty. Timing Chains don't break normally, and when they do, usually it's on a much older car. Mazda should be covering the costs for this under the power train warranty (which is good for 48 months or 50,000 miles, whichever comes first)



Posted on Sep 22, 2009

Gort007
  • 1187 Answers

SOURCE: Check engine light intermittently flashing, car jerking.

Could be fuel or electrical related. Since you may not know the history, this may take a while.
Any amount of smoke from exhaust? White, Blue, Black?
Start with most obvious and inexpensive:
1. Fuel filer clogged (replace fuel filter).
2. Could be the ECM (Electronic Control Module). It controls the ignition spark timing.
A few other things... consider other expert solutions...

Posted on Sep 25, 2009

  • 1 Answer

SOURCE: Mazda 626 'HOLD' light after gear box oil seal was replaced

I have the same problem with my car I think its the torque converter clutch but you should visit a diagonestic machine just to find out

Posted on Nov 12, 2009

theautoguy
  • 69 Answers

SOURCE: mazda cx-7 2008 left headlight stopped working,

check the wiring from the headlight. You want to find the ground wire which is usually a black wire thats secured to some metal part of the car. Basically just check that all your wires are in tact and tightly secured. A bad ground is a very common electrical problem.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adjust headlights


In my CX-9 on the left side of the drivers dash, below the steering wheel, there is a little adjustment wheel for headlight up and down adjustments. I believe it has 3 or 4 positions. Check out the video at 1:13 mins in.
2011 2007 Mazda CX 9 Automatic Xenon Exterior Lights Tutorial

Jun 02, 2014 | 2007 Mazda CX-9

1 Answer

Replacing struts on Mazda CX7


There are 3 Nuts inside the Engine Compartment, There is one Bolt on the Lower Arm and you have to remove the ABS and Torsion Rod. You need a Spring Compressor to do this job.

Apr 15, 2013 | 2007 Mazda CX-7

1 Answer

I have a 2008 Mazda CX7 the light on the dash is on saying that my tire is low. I checked each tire the lowest is 23 the rest are about 29. What is the accurate tire pressure?


set all the tire pressures at 32-35 and drive the car as it may take a little time for the system to reset itself.there should be a decal on the drivers door that has the tire pressure on it.

May 05, 2011 | 2008 Mazda Cx 7

1 Answer

Timing belt same clicking noise 2007 mazda cx7


vvt actuator and you are driven by timing chain not belt common problem in cx-7

Feb 11, 2011 | 2007 Mazda CX-7 Grand Touring

1 Answer

How do i replace a headlamp on a 2007 mazda cx7


un plug the cable socket at the back side of the headlight then remove the rubber cover at the same place and then there is a steel wire clip carefully remove it (as you have to put it back again) the lamp can be removed easily you have to put the new one in the same direction again so remember what you remove

Jan 20, 2011 | 2007 Mazda CX-7 Grand Touring

2 Answers

PROGRAMMING THE GARAGE OPENER ON MY REAR VIEW MIRROR ON A 2007 MAZDA CX7


GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

May 12, 2010 | 2007 Mazda CX-7 Grand Touring

2 Answers

How do I change the bulb in the low beam headlight in my 2007 Mazda CX7?


Removing the bulb in a CX7 is a real PITA. If replacing the right bulb, turn the steering wheel all the way to the right, or do the opposite for the left side. (or you can opt to remove the entire wheel on the corresponding side) You'll need to remove 3-4 of the fender well clips with a phillips screwdriver being careful not to break them. Once the screws are removed, pry back the wheel well cover to access the back of the headlamp to change the bulb.

Nov 04, 2009 | 2007 Mazda CX-7 Grand Touring

1 Answer

I am trying to replace the low beam bulb on the passenger side of a 2007 Mazda CX7 . Can't seem to figure out how to get to it. Any help?


Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.

Jun 08, 2009 | 2007 Mazda CX-7 Grand Touring

Not finding what you are looking for?
2007 Mazda CX-7 Grand Touring Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...