Question about 2003 Chevrolet Impala

Open Question

Equinox door lock diagram

Can you show a diagram of the automatic door lock for a chevrolet equinox

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 79 Answers

SOURCE: 2006 Chevrolet Equinox Driver's door will not open the door

Sounds like the release rod came off of either the main latch or the inside release handle. My guess would be the latch since I don't see many problems with the inner handles. To check you have to remove the door panel. Follow the rod to the latch area. There should be a plastic type of clip that the rod came off of in the general area of the end of the rod. The rod may just push back into place.

Posted on Dec 18, 2008

Ad
  • 260 Answers

SOURCE: Auto door locks will not unlock.

I would check the relay for the locks. Has this been a recent issue?

Posted on Apr 18, 2009

Sean80000
  • 1867 Answers

SOURCE: 2005 Chevrolet Silverado Automatic door locks

I assume you mean that the central locking system will not lock the doors but you can do so manually.

Get inside the vehicle and close all doors.

On each rear door, lock and unlock the mechanism manually a couple of times. In other words do not use the key pad.

Then leave both rear doors in the locked position (manual locking) and operate the lock button on you key pad to operate the central locking system. Wait a few seconds then hit unlock on your key pad and a few seconds later hit lock on your key pad.

If the system fails to lock your rear doors you will need to get the vehicle to an auto electrician to check out the issue and rectify it for you. There are a number of possible causes which cannot be identified without physically checking the system. So you will need to have this rectified by a professional.

Posted on Dec 04, 2009

  • 752 Answers

SOURCE: I'm looking for a braking

For

Posted on May 21, 2011

dttech
  • 4803 Answers

SOURCE: I need a routing diagram

See if this works for you. Please take a moment to rate this FREE answer.

dttech_194.gif

Posted on Sep 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2011 Equinox. While driving the doors unlock and lock and car goes into neutral for a couple of seconds. Drove for a few days without the problem, then it happens 7 or more times in 1 day.


did the doors normally lock when you started driving and unlock when you parked. (automatic feature)
If so, this could be an issue with the shifter linkage and during a normal drive, it could think you have parked, or just started driving.

I would get this addressed my a local mechanic quickly for safety reasons.

Jan 02, 2017 | 2011 Chevrolet Equinox

2 Answers

2005 Chevy Equinox Driver & Passenger Door Unlock Relay. How To Remove & Install. They Are Power Locks. Front Doors Must Roll Windows Down Use Hand To Open Thanks. Ms. J. C.


Door Lock and Unlock Operation
When a door lock switch is activated in the lock or unlock position the BCM will receive a voltage signal on either the door lock switch lock or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will switch the appropriate lock relay control circuit(s) to battery positive voltage. This will energize the appropriate lock or unlock relay(s). The relay will supply voltage to the door lock actuator lock or unlock control circuits to one side of the lock actuator. Since the opposing side of the lock actuators are connected to ground through the other lock actuator control circuit and the normally closed contacts of the lock or unlock relay, the doors and liftgate will then lock or unlock appropriately.
Three relays are used to operate the lock. Driver door unlock, passenger door unlock and all door lock. This is done to isolate the driver door lock actuator so it can be unlocked by itself using the keyless entry transmitter.
Your door locks are controlled by the BCM - body control module (a computer ) . An a scan tool is a must to diagnose system operation . Your best bet would be to take your vehicle to a qualified repair shop . The only way you could try to fix this is by changing parts ! Suppose you find an replace a door lock/ unlock relay an that doesn't fix it ? There could be DTC'S stored in the BCM . Do you know what a DTC is ?
?€¢
DTC B3132 All Door Unlock Circuit Low


?€¢
DTC B3133 All Door Unlock Circuit High




Your

Aug 10, 2016 | Cars & Trucks

1 Answer

Aside from Driver Window Switch, where can I find a RAP-OFF wire Gray/Black in a 2012 Equinox?


Each door ajar switch sends a signal. The signal goes through the window switch for that door, probably be easiest to access the ajar signal wire at the window switch connector on any door.

Nov 02, 2015 | 2012 Chevrolet Equinox LS 4dr SUV 2.4L...

2 Answers

Suddenly, my automatic door unlock button on remote for my 2005 Chevrolet Equinox will not unlock doors and alarms goes off if I manually open driver's door and don't start car right away. Wh


I tried replacing battery in my remote. Sometimes it work and sometimes it doesn't. I think it could be a wiring problem in the remote. I know it's a major paun having to hurry up and put key in ignition befofr alarm starts going off.

Oct 30, 2012 | 2005 Chevrolet Equinox

1 Answer

2006 equinox drivers door lock not working


Test to see if you have power going to the door lock motor, if you do, then motor is bad, if you don't then there is a shorted wire or switch

Jun 09, 2012 | 2006 Chevrolet Equinox

1 Answer

My wife and I swear that when we first bought our pre-owned 2005 Chevrolet Equinox the doors would unlock when I put it on park. After regular maintenance at Midas we both asked each other how come the...


The door locks can be "Personalized" through the BCM (Body Control Module) The dealer can do this, or you may find it in your owners manual how to.

Nov 15, 2010 | 2005 Chevrolet Equinox

1 Answer

2005 chevy equinox rear hatch not locking


I've had the exact opposite issue with my 2005 Equinox.
My rear door is locked and will not unlock.

Mar 23, 2010 | 2005 Chevrolet Equinox

1 Answer

My 05 Equinox drivers electronic door lock doesn't work with the remote only locks/unlocks with the key. All the other door locks work.


YOUR REMOTE BATTERY NEEDS REPLACING.TAKE IT TO DEALERSHIP.THEY WILL REPLACE REMOTE ENTRY BATTERIES AND REPROGRAM THE DOOR LOCKS.

Jan 18, 2010 | 2007 Chevrolet Equinox LS New Cars

1 Answer

2007 Chevy equinox door lock latches engaged


Did you unlock doors and pull handles like to open, then try?

Mar 13, 2009 | 2006 Chevrolet Equinox

Not finding what you are looking for?
2003 Chevrolet Impala Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...