Question about 2001 Cadillac Sts

Open Question

2006 sts brake pedal stiff

Can't start 2006 sts because pedal is stiff and can't push down

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bluebirdmate
  • 1190 Answers

SOURCE: I get a No Farb

Hello, There is a small pocket on the side of the glove compartment in the dash on the passenger side. Open the glove compartment insert the fob in the pocket, if the car starts replace the battery in the fob.

Posted on Dec 14, 2010

  • 286 Answers

SOURCE: step on brake pedal an no brake lights on a cad

Hi,
Check bulbs ,,,, automatics vehicles tend to have less usage of hand brake and more reliance of foot break! Hense shorter life on brake light. bulbs, Visually check bulbs or replace (to be sure) and see what happens. Generally fuses don't blow unless there has been "an incident" . Good Luck

Posted on Dec 15, 2010

dttech
  • 4803 Answers

SOURCE: I have a 2005 Cadillac sts v8 that the brake pedal

Sounds like a bad master cylinder and/or brake booster to me.

Posted on Jun 03, 2012

  • 645 Answers

SOURCE: 2006 cadillac sts battery dead can't access car because uses a pod instead of key?

Most of the time, newer cars are going to be faster than older cars, unless they have been completely restored.-----------------------------------------------------------------------
FGTech Galletto 2

Posted on Dec 14, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 05 sts driver side break ligth dont work


Never push the brake pedal down when the spring brakes are on. If you do, the brakes could be damaged by the combined forces of the springs and the air pressure.


----------------------------------------------------------
FGTech Galletto 2-Master EOBD2

Dec 18, 2012 | 2005 Cadillac STS

1 Answer

Kia Spectra feels like brakes are locked or too tight


See a mechanic. Gas prolly loose or need new clutch if its a standard

Sep 29, 2012 | Kia Cars & Trucks

2 Answers

2006 pontiac vibe brake light


All the lights stopping at the same time is not likely a fuse, it would be the brake light switch, the brake light switch is over the brake pedal near top of brake pedal arm under the dash. To test take a 12 volt test light ($5.00 at any auto parts store) and see if both side of the switch light the test light when the brake pedal is pushed, one side is hot with 12 volts without pushing the brake pedal down. The fuse location is in the owners manual but I am 99% sure that isn't the problem.

Jun 20, 2012 | 2006 Pontiac Vibe

1 Answer

Hummer H3 airbag light wont go off


Airbag light on in a Hummer H3 Dashboard???Here is the fix...
Start the engine of your car, set the parking brake, hold the regular brake pedal down with your right foot. Push down the parking brakepedal to its fully-applied position with your left foot. Now while you are still holding the regular brake pedal down. Quickly release the parking brake, Pull the bottom edge of the lever, located above the parking brake pedal, with the parking brake
symbol, directly rearward to release the parking brake. Make sure pedal snaps hard all the way back releasing the parking brake... If this doesn't work the first try, try it 3-5 times and it shall work... The airbag light will go off...


NOTE: The parking brake pedal is located to the left of the regular brake pedal, near the driver's door.
&

The parking brake lever is located above the parking brake pedal, with the parking brake symbol.

May 28, 2012 | 2006 Hummer H3

1 Answer

Break pedal is hard to push


its usually a bad brake booster that makes pedal hard or stiff. just type in on computer, ' power brake symtoms " in search bar. this should lead you in the right direction.

May 01, 2012 | 1992 Buick LeSabre

2 Answers

Traction control won't disengage.


You can pull the fuse for now. The traction control pump could be faulty or the wheel sensors are dirty and need to be cleaned with brake parts cleaner

Jan 18, 2010 | 2006 Cadillac STS

1 Answer

93 dodge dynasty brake pedal stiff wont apply brakes


your power brake booster needs replaced ,it work off engine vacuum and when the seal inside leak there is no power assist for the brakes

Mar 06, 2009 | 1993 Dodge Dynasty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...