Question about Ford Escape

2 Answers

Vwhat cylinder is coil d on for 2001 ford escape with a 3.0 vin 1

Posted by on

  • Anonymous Jan 22, 2013

    Front middle coil I should have said

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Ford Master
  • 1,632 Answers

Number 4. Cylinder

Posted on Jan 22, 2013

Ad

A,B,C,D,E,F etc

1,2,3,4,5,6,7,8,

D same as #4

Front left as you open the hood

1,2,3 firewall side
3,4,5,radiator side front to back
of motor

Posted on Jan 22, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 373 Answers

SOURCE: 2001 hyundai santa fe 6

HI......
OK. just follow the number on the ignition coils.
And the number on the cylinders are.
The FIREWALL side are 1,3,5, Starting from the belts location.
The RADIATOR side are 2,4,6, Starting from the belts location.
The coil with number 1 go to cylinder 1. as the same way the rest of the coils and cylinders.

OK... I hope this solve your question .

THank you for use fixya.

Posted on Jul 25, 2008

warlock61
  • 659 Answers

SOURCE: locate cylinder number 1 on a 2002 Ford Escape

If it is a 3.0L it is the rear bank, the one closest to the pass side

if it is a 2.3L it is the one all the way to the left

Posted on Jan 10, 2009

landsend
  • 1066 Answers

SOURCE: ABS on 2001 Ford Escape .

could you have a low or odd sized tire on the car?  have you bumped a sensor?  Is the light on?

Posted on Apr 01, 2009

  • 8 Answers

SOURCE: I am trying to find out how to replace the thermostat on my 4 cylinder.


Here You go this should help a lot.

Posted on Jun 01, 2009

bschilz
  • 2049 Answers

SOURCE: location of the bank 1 sensor 2 O2 sensor on a 2001 ford escape

B1 means the sensor is located on the same bank of the engine that has the #1 cylinder. B2 is located on the opposite bank.
S1 means the sensor is located BEFORE the catalytic converter
S2 means the sensor is located AFTER the catalytic converter

You didn't say which engine you have, so I've included the diagrams of both 4 cyl and 6 cyl so you can see the banks

7acfed1.gif
d9eb1af.gif

Posted on Oct 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a 2003 ford escape starring wheel fit a 2006 ford fusion


as long as the engine codes match they will fit. 2003 Ford Escape 2.0L VIN "B" 2003 Ford Escape 3.0L VIN "1" 2004 Ford Escape 2.0L VIN "B" 2004 Ford Escape 3.0L VIN "1" 2005 Ford Escape 2.3L VIN "H" 2005 Ford Escape 2.3L VIN "Z" Hybrid 2005 Ford Escape 3.0L VIN "1" 2006 Ford Escape 2.3L VIN "H" 2006 Ford Escape 2.3L VIN "Z" Hybrid 2006 Ford Escape 3.0L VIN "1"

Apr 21, 2018 | Ford Cars & Trucks

1 Answer

Cylinder 1 misfire


Have you tried clearing the code and go from there? Also maybe try unhooking the negative battery cable for awhile and that will reset it as well then see if it comes back to cylinder one. It's usually best to do all plugs and wires at the same time. Coils get expensive so I can see only replacing them when needed

Aug 20, 2012 | 2001 Ford Escape

1 Answer

My 2005 ford escape v6 is only firing on cylinder 1 and 6


Your an 2005 Ford Escape 3.0L, you don`t have a distributor. Each cylinder has it`s own coil and is controlled by the PCM. You need to scan the PCM to determine which cylinder is loosing power ( misfire). P0301 cylinder #1, P0302 Cylinder #2 and so on. The coils are common problems with this vehicle, but pay close attention that the drivers in the PCM are not at fault. #1 cylinder is on passenger side near the firewall passenger compartment. firing order as follows, Bank #1 1-2-3 front of engine to rear. nearest the passenger compartment. I`m an ASE Master with 30 years experience. Be careful, don`t waste money on unneeded parts! I own my own company. 805-369-4589 Jerry Bryant. Advise is free, but like reading a diagnostic manual does not mean the problem is solved. Correct diagnoses and system inspection and testing is what needs to be done so you don`t waste money!

May 11, 2012 | 2005 Ford Escape XLT

1 Answer

On my 2003 Ford Escape 3.0L VIN 1 I have the following codes, PO316,305,306,300,304. Are these codes caused by a possible vacuum leakl? If so what would be the likely spot?


Forget the 300 & 316

The 304,305 &306 are ignition coil codes for
#4 ,#5 ,#6 cylinders

Doubt you have more than 1 bad coil

Check for Vacuum Leaks -- they wouldn't
help any, but are the cause of 80% of all
O2 Sensor Codes.

You may luck out & if any coils are bad, you won't
have to remove the upper intake (this time around)

You will get at least one bad coil a year on all fords

Have the intake manifold Smoke Tested with an EVAP
Smoke Machine,for leaks

Jul 03, 2011 | 2003 Ford Escape

1 Answer

This question is for a 2001 ford escape 3.0L v6 i need the number order for the ignition coils 1 to 6


Hello! The firing order is; 1-4-2-5-3-6...Left bank, from front to rear=1-2-3...Right bank,from front to rear=5-6-4....

Guru...................Saailer

Aug 10, 2010 | 2001 Ford Escape

1 Answer

Cylinder mis fireing


2001 Ford Expedition 4.6 liter V-8 VIN "W"

d2a46b2.gif


2001 Ford Expedition 5.4 liter SOHC V-8 VIN "L"

bf1788f.gif


Hope this help (remember comment and rated this).

Jul 30, 2010 | 2001 Ford Expedition

1 Answer

I have a 2001 ford expedition do not whitch cly is number 5


2001 Ford Expedition 4.6 liter SOHC V-8 VIN "6" / 5.4 liter SOHC V-8 VIN "L"Cylinder # passenger side radiator to firewall 1-2-3-4
Cylinder # driver side radiator to firewall 5-6-7-8

Good luck and hope this helps.

Dec 22, 2009 | 2003 Ford Expedition

1 Answer

Where is # 1 cylinder on 2001 frd taurus 3.0 engine


2001 Ford Taurus
3.0 liter V-6 VIN "2"
Cylinder # passenger to driver firewall side 1-2-3
Cylinder # passenger to driver radiator side 4-5-6

Dec 22, 2009 | 2001 Ford Taurus

1 Answer

What is the firing order on a 1997 ford expedition


1997 Ford Explorer 2WD / 4WD
4.0 liter SOHC V-6 VIN "E"

Firing order 1-4-2-5-3-6
cylinder # passenger side front to back 1-2-3
Cylinder # driver side front to back 4-5-6

Coil pack # passenger to drivers side firewall 1-2-3
coil pack #passenger to drivers side radiator 5-6-4


Dec 09, 2009 | 1997 Ford Expedition

2 Answers

Need a diagram pitcure of firing order for a 2001 Ford Escape


you didn't say which engine so here it is for both
2001 Ford Escape 2WD
2.0 liter DOHC L4 VIN "B" 92714651.gif
2001 Ford Escape 2WD
3.0 liter V-6 VIN "1" 92725094.gif

Jul 18, 2009 | 2001 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...