Question about Toyota HiAce

Open Question

Oil change light on dash toyota hiace year 05 staying on

Need to change oil will i haave to change filter as well

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: oil change light

Turn the key on. Observe the odometer. Is "ODO" displayed? If not, push the trip meter button until "ODO" is displayed, with the total mileage travelled shown.
Turn the key off.
Push & HOLD the trip reset button until advised to release it.
Turn the key to "ON" (do not start engine)
Observe the ODO display.
You should see 5 dashes, then 4, then 3, then 2, then one, and finally, five zeros.
The original mileage that you observed should be redisplayed.
Release the trip reset button.
The proceedure is now complete.

Posted on Sep 22, 2008

Ad
Caesarfix
  • 141 Answers

SOURCE: Toyota Hiace 99 Fuel filter change

Look first right rear back under fuel tank,< If not, follow fuel lines from fuel tank one main line, one return line, traveling parallel to frame all the way to the motor compartment on front, can be front under right passenger side, first by the filter at the auto parts, that way you will know what to look for

Posted on Jan 21, 2009

  • 373 Answers

SOURCE: oil filter locatin tdci engine

Did you try auot zone

Posted on Feb 08, 2009

  • 4044 Answers

SOURCE: what do the dash lights on a toyota landcruiser

I don't have one of those vehicles but in the Path Finder it meant Low oil pressure or low oil. If your oil level is correct get the oil pump checked out before the engine is damaged.

Posted on Aug 27, 2009

badnad
  • 1 Answer

SOURCE: How do you disassemble toyota hiace 2006 dash?

Its easy, The only tool you need is a plastic lever tool. Or can be done with big head screw driver (but car for the trims for it can get damaged)
Lever both side vents out, then pull on the trim gently outwards. (long piece from glove box to the end of the radio before the instrumental dash panel) Then pull the main inturmental dash out towards you as well. There may by plugs connected to the front panel. Disconnect that and it exposes the digital meter, I think it then takes only 2 x 10m bolts and the dash is out.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the gap setting for a Toyota Hi Ace, 1992 Commuter. Engine Number 2RZ 0248 127


spark plug settings? ' IH8MUD Forum

https://forum.ih8mud.com > ... > Vehicle Tech Forums > 95-older Toyota Truck Tech
  1. Cached
Apr 6, 2007 - i changed my spark plugs and feel my truck is running worse. i was told ... of the gap in my old plugs. any one know if that is the right setting or not? ... ps most Toyota plugs come pre gaped!! hehe!! ... 1992-86 L-4 22RE 1233 .032 9799 .... Flat Land Cruisers · NM- High Desert Cruisers · OK- Green Country ... Missing: ace ‎commuter

TOYOTA ' denso

www.denso.com.au/sparkplug/make/10/toyota
  1. Cached
  2. Similar
150+ items - Model, Engine, Year, Standard Plug, Gap (mm), Iridium Power ... Engine Year Standard Plug ? 3VZE VZN130 V6 1991 on K16RU 3.5L? 2GRFE V6 11/2006 on FK20HR11

Toyota HiAce 89-05 2.4L NGK Spark Plug Set BPR5EY

https://www.fullforceracing.com.au/toyota-hiace-89-05-2-4l-ngk-spark-plug-set-bpr5...
  1. Cached
NGK Spark Plug Set Suitable For Use With -Toyota HiAce 08/89 - 05/05 2.4L ... Notes, It is recommended that all spark plug gaps be checked prior to instalation. Missing: 1992 ‎commuter

Toyota Manuals - Workshop manual store

www.theworkshopmanualstore.com/Toyota-Manuals/index.php
  1. Cached
  2. Similar
Sep 8, 2011 - Keywords: http://www.workshoprepairmanual.com.au/Item/toyota-hi-lux-ln-series- ... It utilized a typical truck setup of A-arms plus coil springs inside front along with .... 2.7559 2.1654 SPARK PLUG SPARK PLUG DISTRIBUTOR IGN. ...... inside 1990 plus 1992) Juha Kankkunen (Champion inside 1993) plus ...
gap setting for Toyota Hi Ace 1992 Commuter Google Search

Nov 15, 2016 | Toyota HiAce Cars & Trucks

1 Answer

Yellow oil light with exclamation mark


time for a service. or oil to low. time to top up.

Apr 01, 2014 | 2007 Toyota Hi-Ace 220

1 Answer

Toyota hiace first gear very hard when changing


hi it can be the clutch is not totaly disengageing i dont know the year of your hi ace check the hydralic oil for the clutch or if its a very old truck the clutch cable can also be syncronizers 1gear or no gear oil in trans" newer models use atf oil

Nov 28, 2013 | Toyota HiAce Cars & Trucks

1 Answer

Changing transmission oil in toyota hiace 2003


remove the bottom drain plug and allow the oil to drain out. replace the plug tight
on the side of the box about 1/2 way up and a bit to the front ( mostly on the lhs of the box there will be another plug
remove and put the oil in there ( use a oil syringe of squeezable plastic bottle with a plastic tube attached) add oil until it starts to run out of the hole.
allow excess to drain out then refit the plug tight

Feb 21, 2013 | Toyota HiAce Cars & Trucks

1 Answer

Reset dpd light on toyota hiace


in hiace kdh201 have 5 pin socket under the left hand side in dash panel. find it and red/yellow wire connect with ground after 2s it will start to flushing ,some time it want to more than one flushing to clean DPF filter.be careful because this white smoke cause to censers and don't operate A/C ,headlight,and accelerate position .it will stop your DPF cleaning process.good luck

Aug 19, 2012 | Toyota HiAce Cars & Trucks

1 Answer

I have a Toyota hiace 2004 2.5 d4d. I have recently changed the oil as the oil change light had come on. I reset t he oil light on the dash which was fine. I now find tho that every time I turn the...


Make sure that you are using the correct oil viscosity for this engine recommended by the manufacturer, it should also be indicated on the oil filler cap.

Nov 09, 2011 | 2004 Toyota Highlander

1 Answer

How to change gearbox oil on a toyota hiace van


Creating Gears Problem 1st and 3rd sleeping gears, how to romove this problem

May 16, 2010 | Cars & Trucks

1 Answer

Main reop light in dash


Hello, and welcome to FixYa.

The 'Maint Reqd' light indicates that you are due for an oil change. It will blink 4,500 miles since the light was reset at your last oil change, and stay on steady after 5,000 miles.

If you recently had an oil change, all you need to do is reset your maintenance reqd lamp. The procedure is here on this site inthe 'tips and tricks' section, and it is also in your owner's manual.

Feb 22, 2010 | 2004 Toyota Camry

1 Answer

Maitance light stays on


It is in the manual. Hold trip button in and turn key to on pos. Hold the button til the blinking dashes disappear. done

Jun 30, 2009 | 2005 Toyota Highlander

2 Answers

Oil light comes on


Yellow oil can lit means you need to top up the oil. Red oil can means you have lost oil pressure.

Jul 11, 2008 | Toyota Passenger Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

327 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...