Question about 1990 Mercury Grand Marquis

1 Answer

Where does the top part of shock mount on 1990 mercury grand marquis?

Need to know where top of shock mounts on 1990 mercury grand marquis

Posted by on

1 Answer

Strut tower in plain site, if you open the hood,
should have 3 nuts to remove for top bearing plate

The rear ones may be in the trunk

Posted on Jan 22, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 74896 Answers

SOURCE: 2007 Mercury Grand Marquis required oil weight

If u have a moderate climate, 10W-30W, if cold climate 5W-30W, do not use any heavier weight of oils.

Posted on Dec 15, 2008

  • 78 Answers

SOURCE: 1990 mercury grand marquis odometer gears

ther isnt a "manual"for this. see my reply to your other post. I hope it helps you. Ive done this kind of repair many times!!

Posted on Dec 25, 2008

  • 87 Answers

SOURCE: rear shocks on a 1996 Mercury Grand Marquis

2 bolts on the top of shocks and 1 bolt on the bottom but the top 2 bolts are a pain in the neck

Posted on Mar 10, 2009

olds97_lss
  • 1 Answer

SOURCE: Mercury grand marquis 1997 temperature control

I'm not sure if yours is identical to mine since yours is second gen and mine is third gen, but with mine (1998 MGM), the heat was stuck on all the time. Full heat would practically cook your feet and you couldn't shut it off.

It was a servo/servo arm that controls the hot/cold mix door. The part was $15. The labor was $700. They had to take the entire dash out of the car to get at the part. Required two more visits due to a missed electrical connection to a daylight sensor and a vacuum issue that made the car stall when put into reverse.

My car had 150K on it at the time. Has 165K on it now. Still runs great and looks great. It's now my wife's auto and I drive a 2006 MGM.

Posted on May 13, 2009

  • 564 Answers

SOURCE: how to replace starter +1993 Mercury Grand Marquis

disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,,

Posted on May 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 grand marquis airbag code 21. need trobleshooting info.where is control module mounted?


You do not want to be messing with airbags unless you are well trained with them. You have a resistance problem indicting an airbag fault on the passenger side from what info I could find. That indicates in a crash that that airbag will not be functioning properly or at all. Find a professional as airbags are very dangerous if you do not know what you are doing.

Jan 16, 2014 | 2004 Mercury Grand Marquis

1 Answer

Change head gasket on 2006 grand marquis


Leave the motor mounts allone, they are fine where they are. Your torque sequence usualy start at the center of your head and working a circle outwards usualy.

Mar 03, 2013 | 2006 Mercury Grand Marquis

1 Answer

Fuel filter location 96 grand marquis


For 1996 Mercury Grand Marquis 4.6L SFI 8cyl the Fuel Filter is located: Under vehicle, passenger side, below seating area, near fuel tank, mounted on frame rail in fuel line

Hope helps (remember to rate this answer).

Mar 19, 2011 | 1996 Mercury Grand Marquis

1 Answer

Where is the fuel filter located on my 1993 mercury grand marquis


1993 Mercury Grand Marquis 4.6L SFI 8cyl
The Fuel Filter is located: Under vehicle, driver side, below seating area, front of rear wheelwell, mounted on chassis in fuel line .

Hope helps (remember rated this).

Jun 15, 2010 | 1993 Mercury Grand Marquis

1 Answer

I need to know how to remove the intake off of a 1990 mercury grand marquis 5.0


is it fuel injected or carburated usually its just a matter of pulling off the carb or plenum from the top of the intake and then the valve covers and move all the wires and **** out of the way then you should have access to 10 or 12 bolts un bolt them and use a thick flat tip to pry the intake from the heads. but make sure all the bolts are out before that and pop should come right off

Oct 01, 2009 | 1990 Mercury Grand Marquis

3 Answers

Rear shocks on a 1996 Mercury Grand Marquis


2 bolts on the top of shocks and 1 bolt on the bottom but the top 2 bolts are a pain in the neck

Mar 10, 2009 | 1996 Mercury Grand Marquis

1 Answer

How do i know which spark plugs are right for my car?


auto zone has them. "autolite platinum ap2545",very cheap$$.

Dec 25, 2008 | 1990 Mercury Grand Marquis

Not finding what you are looking for?
1990 Mercury Grand Marquis Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...