Question about 2009 Dodge Journey

Open Question

Replace water pump for dodge 2009 journey

Replace water pump on a 09 dodge journey

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jturcotte
  • 7754 Answers

SOURCE: How do I check the transmission fluid on a 2009

below is info from the owners manual. I do not have a repair manual, but you may be able to buy one that would say how to check the transmission fluid on the 3.5L. It sounds like they don't expect you will need to check it.

Fluid Level Check - Vehicles with 3.5L Engine

The automatic transaxle has no dipstick and is dealer

serviced only.

Fluid Level Check - Vehicles with 2.4L and 2.7L

Engines

Use the following procedure to check the automatic

transaxle fluid level properly:

1. Park the vehicle on level ground.

2. Run the engine at curb idle speed for a minimum of 60

seconds.

3. Apply the parking brake fully.

4. Place the shift lever momentarily in each gear position

ending with the lever in PARK.

5. Wipe the area around the dipstick clean to eliminate
the possibility of dirt entering the transaxle.

6. Remove the dipstick and determine if the fluid is hot

or cold. Hot fluid is approximately 180°F (82°C), which is

the normal operating temperature after the vehicle is

driven at least 15 mi (24 km). Hot fluid cannot be held

comfortably between the fingertips. Cold fluid is at a

temperature below 80°F (27°C).

7. Wipe the dipstick clean and reinsert until seated. Then,

remove dipstick and note the reading.

a. If the fluid is hot, the reading should be in the

crosshatched area marked "HOT" (between the upper

two holes in the dipstick).

b. If the fluid is cold, the fluid level should be between

the lower two holes in the area marked "COLD."

If the fluid level is low, add sufficient fluid through the

filler (dipstick) tube to bring it to the proper level. Do not
overfill.

Posted on Oct 04, 2010

bikinimechan
  • 220 Answers

SOURCE: Replaced brake pads on 2009 Dodge Journey, but now

Well you need to check your fluid level on the master cylinder first. Then I suggest that you bleed the brake system. Always start bleeding from the wheel furthest away from the master.

Posted on Nov 22, 2010

SOURCE: how to replace rear rotors

They should last for 5 years or more
Maybe machine every 60,000 to 80,000 miles

If you ever did any brake work, I don't see
a problem

Posted on Dec 08, 2010

Transdoc
  • 829 Answers

SOURCE: 2009 dodge journey...rear brake

If the e-brake cable is attached to caliper the piston is threaded. I use a very inexpensive tool i bought at the parts store . you will need to turn and press the piston at the same time. be aware that the two different sides are threaded oposite of each other.If the e-brake cable is not attached to caliperr the a c clamp should do the job.

Posted on Jan 11, 2011

radar001
  • 1051 Answers

SOURCE: How to replace the front rotors on a 2009 Dodge

While I could explain what to do, it may be better if you have detailed step by step instructions with illustrations on hand. You can get these free by registering for free at www.autozone.com Once registered you'll have access to a variety of DIY repair manuals.

Posted on Jan 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why did the compass quit showing on the EVIC on my '09 Dodge Journey SXT?


Go to the dealer- The compass module is already installed in the car, however, the Infotainment system wasn't configured to acknowledge/control it. Have the technician flash an updated version of the software.

May 02, 2015 | 2009 Dodge Journey SXT

1 Answer

Fuses diagram


If you need 2009 dodge journey fuse box diagram and fuse box details,then please click the link below and view the diagram:-----
http://www.gresk.com/2013/09/dodge-journey-fuse-box-diagram.html
------------
This will help.
Thanks.

Sep 29, 2013 | 2009 Dodge Journey

2 Answers

How do I compress both front and rear caliper pistons on an 09 Dodge Journey? I s there a special tool or technique?


You will need a brake caliper piston tool. Available at most part stores. $20-$50 depending on brand.

Mar 06, 2011 | 2009 Dodge Journey

1 Answer

We had to pay for our first service on our dodge journey is that normal practice as i just thought it was free for the first one


Your new vehicle is covered for everything the first 36,000EXCEPT oil changes tires and windshieldwipers .
I have had every service covered ths far on my 09 Journey
The drive train ------------engine & trans is life time

Dec 19, 2010 | 2009 Dodge Journey

2 Answers

09 dodge journey 4cl. enging how much weight could it pull?


legal limit of the state/country your in .This differs between countries but normally about 2/3 thirds of the towning vehicle also weither this trailor has brakes of its own or not.

Jan 10, 2009 | 2009 Dodge Journey

Not finding what you are looking for?
2009 Dodge Journey Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...