Question about Cars & Trucks

Open Question

JCB 530 70 bleeding fuel - Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I switch on my jcb js 130 excavator the eighteen warning indicator lights are not going off


How to reset the service light on a JCB JS 130 Excavator ...

www.fixya.com/.../t1428872-reset_service_light_jcb_js_130_excavator
Dec 25, 2008 - how to reset the service light on a JCB JS 130 Excavator Hi I have serviced our JCB JS 130 ... my self and I am woundering if there is away of switching off the service warning light ... Helpful 41; Not Helpful; 1 Comment; Flag ... Posted on Feb 18, 2009 ... What kind of brake fluid goes into a jcb 3cx 1985/86?

Oct 29, 2015 | Cars & Trucks

1 Answer

Bleed jcb 2cx brakes


-You mean how to bleed brake fluid...?
If so. Here is a basic to do. (Doesn't matter front or rear)
-Most car's bleeder screws fit 10mm combination wrench.
Here thing that you need:
-Wrench
-A jar (Glass or plastic. Doesn't matter)
-A Clear vinyl tubing 1/4" inside diameter by 12" to 18"
-a helper.
-A bottle of new brake fluid. (Buy the big one)
Now locate the bleeder screw, lose it then tight it back just little to prevent leaking. (Only lose DO NOT TAKE IT OUT)
-Hook up the tube to it, 1 end into the jar.
-Ask helper to press brake pedal all the way to the floor then HOLD right there and lose the bleeder screws to let the fluid come out then tight it BEFORE RELEASE THE PEDAL.
Repeat this step until you see clear fluid come out. You're done this one. Then go to the next one.
MAKE SURE CHECK THE RESERVOIR VERY OFTEN. DO NOT LET IT RUN OUT OF FLUID!!! If it has ABS YOU'LL HAVE BIG TROUBLE.
Here the fast way to do. Empty the fluid reservoir and fill new one before bleed the system.

Good Luck


Mai

Aug 28, 2015 | Cars & Trucks

1 Answer

Jcb problems.?


Most likely the master cylinder is bad...be sure to bench bleed prior to installing...Hope this helps.

Aug 28, 2014 | Cars & Trucks

1 Answer

Jcb telehandler 532


jack up the front wheels ,fit safety stands with engine running , move wheels from lock to lock several times to bleed out air. top up oil tank.

Aug 15, 2014 | Cars & Trucks

1 Answer

Have jcb skid steer that was running and then shut down at idle. it will not restart. have plenty of battery and the starter is working fine.


Check the fuel solenoid stop control on the injection pump in case the wire's off/loose. This can be tested by a length of wire and 2 croc clips direct from the pos terminal on the batt. If it fires up, the supply via the harness is lost somewhere. It needs a supply to keep the pump running.
Bleed the fuel system, if it fires up, its drawing air into the system. Check seals/o rings on fuel filters and any loose unions.

Oct 17, 2012 | Cars & Trucks

1 Answer

Jcb 530/70 won't start.turns over fine,changed


you should check your battery at first!!!

_____________________
bmw b800

Jun 11, 2012 | Cars & Trucks

1 Answer

I have jcb type digger and there is deisel entering the oil sump any ideas


check the injector pump fuel may be entering the oil thrue the timing case cover also check the fuel pump if maniacal thay go bad the baffle go bad they get pin holes in them and allow diesel to pass thrue to the crank case

hope this helps you
good luck
bob

May 06, 2011 | Ford Transit Connect Cars & Trucks

1 Answer

My 1972 911 wont start


IGNITER, RIGHT SIDE CORNER OF FIREWALL

Dec 26, 2008 | 1972 Porsche 911

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...