Question about 1995 Ford Taurus

2 Answers

Dashboard Removal 1995 Ford Taurus?

Car has an air freshener in middle fan want the thing out. Do you need special tools to remove dashboard and where do you start?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 840 Answers

No special tools/ the vent should come out at side/Please rate my response. Thank you !

Posted on Jan 27, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 443 Answers

The dash is actually easy to remove just get fingernails ahold of it and start pulling around that lip . Dont get crazy just apply even pressure till you get it removed .

Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 ford taurus air conditioner is leaking water into the passanger side


Hi,
You either have the box for the A\C a-coil cracked whitch can be glued with epoxy or the drain tube is missing, pugged or off the nipple on the end of the box / catch pan. The box containing the coil is under the passenger side dashboard. A little investigation will reveal it. If tube is missing or off, repair / replace. If it is on and box is intact, take hose off and use compressed air to blow out the obstruction. With A/C running, you should then see water (condensation, which is normal) dripping from the bottom of car on the passenger side near the firewall / engine compartment. Please remember to rate this answer.
Thanks, Mike

Jun 12, 2011 | 1995 Ford Taurus

1 Answer

Do i need a special tool for changing water pump on 95 crown victoria at home


depends on if it has a clutch fan or electric... if its electric the no you dont need any special tools but if its a clutch fan then you need a clutch fan removal tool

Jan 21, 2011 | 1995 Ford Crown Victoria

2 Answers

Do i need a special wrench to change serpentine belt on 2003 ford taurus?


yes serpenten belt removal tool can be rented at some autoparts.

Nov 18, 2010 | 2003 Ford Taurus

1 Answer

Need information on the removal and replacement of air conditioner condenser and pulley for 97 Taurus


This is a professional job. You need to drain & reclaim freon so it does not get into atmosphere. Then evacuate system with a vacuum pump for 30 minutes, then refill with R134a freon in the proer amount. Need special tools too. Probably a $500 job.

Oct 30, 2010 | 1997 Ford Taurus

2 Answers

Cant get fuel filter removed


Ford needs a special tool to unhook the connections, can be purchased at part stors.

May 11, 2010 | 1995 Ford Thunderbird

1 Answer

What is the gear with ! in it on Ford Taurus 2001 dashboard


That is a transmission warning light. You need to take it to a transmission shop where they have a special code reader that will tell you what the problem is. My car did the same thing was lucky found out it was just a solenoid in the transmission that needed replaced and not the trans itself.

Mar 06, 2010 | 2001 Ford Taurus

2 Answers

How do I remove the dashboard from my 2000 Chevy Astro Van?


Paul is right you can go to radio shack or autozone schucks or any parts store and ask for the removal tool it cost $20.00 tops. Trust me you don't want to undo the dash as the air bag could detonate if you shorted the two wires that can control it and it could kill you.

Sep 22, 2009 | 2000 Chevrolet Astro

1 Answer

Heater blowing hot air when dial on cold


2 possibles: 1- blend door actuator, or 2- blend door broken, both require removal of the dashboard assembly to access....GL

Jul 05, 2009 | 1999 Ford Taurus

1 Answer

I need to change the bulb in the analog clock in my 1999 Lincoln Towncar. How do I go about getting to it without tearing apart the dashboard?


you need a special tool to get the radio out. It has pins that spread out spring clips so the radio can pull out.

please rate as solved if this helps.

SECTION 413-00: Instrument Cluster and Panel Lighting — General Information 1999 Town Car Workshop Manual
REMOVAL AND INSTALLATION Bulb —Electric Clock
Special Tool(s) Radio Removing Tool
T87P-19061-A

2242b54.gif
Removal
  1. Disconnect the battery ground cable.
  1. Pull out the radio using Radio Removing Tool.
1475891.gif
  1. Remove the radio.
    1. Disconnect the electrical connectors.
    1. Disconnect the antenna cable.
    1. Remove the radio.
  1. Remove the instrument cluster finish panel bolts.
c7eab47.gif
  1. Remove the instrument cluster finish panel bolts.
054ed10.gif
  1. Pull out and position aside the instrument cluster finish panel.
cc71028.gif
  1. Disconnect the electric clock electrical connector.
  1. Remove the instrument cluster finish panel.
    1. Disconnect the headlight switch electrical connector.
    1. Disconnect the dimmer switch electrical connector.
    1. Remove the instrument cluster finish panel.
  1. Remove the electric clock illumination bulb.

Apr 23, 2009 | 1999 Lincoln Town Car

1 Answer

95 taurus ball joint


no special tools are needed ,a pickle fork will make things easeir but not nessasary

Jun 12, 2008 | 1995 Ford Taurus

Not finding what you are looking for?
1995 Ford Taurus Logo

Related Topics:

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...