Question about Dodge Ram 1500

Open Question

My 2006 dodge ram 1500 4.7 engine has rough idle, and slugish performance overall almost ready to stall, has new sparks, new o2 sensor, and air intake sensor

Ran a scanner and it says p0172 system to rich (bank 1) also I checked the air filter and it had a load of creamy looking substance smelled like fuel perhaps. need help bad!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 22 Answers

SOURCE: 1999 Dodge Ram 1500 runs ok til warm, then..

Have your battery tested. When the battery has a problem the dodges will act this way.

Posted on Dec 04, 2008

  • 1 Answer

SOURCE: 1998 FORD EXPLORER SPORT 4X2 4.0 OHV

I have 98 explorer im getting same codes ive worked on cars all my life I havent replaced anything but my fuel filter so far on the explorer and that wasnt it.I know people tell you to replace all that other stuff,but if you know cars and how the stuff works thats on a car then you can fix anything with out people telling you;you need to buy this and then this and there just fishing when the dont know there as* and whole in the ground.Im going to replace my lower and upper intake seals like he says above.At least theres one more smart one out there and not someone that thinks they know it all like people that work in the parts places and some dealers.

Posted on Jan 23, 2009

  • 1071 Answers

SOURCE: Failed O2 sensors? or fuel filter?

i would point to the actual fuel pump when they go weak they cannot supply enough fuel and it will miss and set o2 faults fuel filters usually cause a jerking under a load and will lose all power

Posted on Aug 20, 2009

  • 571 Answers

SOURCE: Check engine light (emission system service required) Help?!?!

There may be problem with the mass air flow sensor (very common with Volvo). This causes the fuel system to malfunction.

You may have noticed increased fuel consumption, loss of power and general 'lazyness'.

Better to take it to authorized Volvo service for a checkup/fix.

Posted on Jan 16, 2010

ZiggynSC09
  • 79 Answers

SOURCE: My 1996 jetta has a check engine light P0172 Bank 1 too rich

Try to clean the mass air flow sensor

Posted on May 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Dodge Ram 1500 4.7 Engine. Starts fine, Idles fine, but when engine shifts into high gear and RPM lowers engine runs really rough under load


Have you checked for a broken valve spring. Repaired a dodge engine with the same running issue as you have described and it was a broken intake valve spring.

Feb 22, 2015 | 2005 Dodge Ram 1500

2 Answers

2004 dodge ram 1500 hemi 5.7 engine dies when stopping, or idles irradic at low speeds when accelarating


Check/clean the MAP sensor and throttle position sensor. This should fix the issue. Its a common problem with Chrysler products.

Oct 26, 2012 | 2004 Dodge Ram 1500

1 Answer

Dodge ram 1500 5.9 idles rough and stales out


This truck has problems with the cover inside intake leaking vacuum and causing rough idle and oil usage , its hard to say what your problem is with out testing, have you had the check engine light scanned for codes? what year is this dodge?these also had intake leak problems. try starting the engine and let it idle and then with some carburator cleaner spray around intake gasket and see if idle changes if it does then you have a intake gasket leak, another problem may be a leaking injector, try some sea foam in the gas tank and run a half tank of gas and see if that helps, otherwise a fuel injection system cleaning would be the way to go but this is only if its an injector problem, if this truck is 1996 or newwer have the computer scanned at an auto parts store for any codes. if there are codes let me know what they are even list the code and #. good day

Aug 27, 2012 | 1998 Dodge Ram 1500 4WD

1 Answer

I had a P0138 code after a diagnostics test on my 2006 dodge ram 1500 4X4, what does this mean?


P0138 DODGE - O2 sensor 1/2 Circuit highxicon.jpghttp://engine-codes.com/p0138_dodge.htmlForum CodePossible causes- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Rear Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks Tech notes Replacing the rear O2 Sensor bank 1 usually takes care of the problem.

Jul 09, 2012 | 2006 Dodge Ram 1500

2 Answers

2003 dodge ram 5.7L intermittently has a rough idle and an idle rpm of 500 I think the normal is 650. When I put it in gear the idle picks up and smooths out. Sometimes it will do this in gear and stall...


okay, the o2 code can cause problems, theres a problem with one of the o2 sensors, theres 2 or 4 sensors,the repair was not done right or theres another bad o2 sensor, next thing i would check is the idle air control motor,this sounds like it sticks at time or just stops working,start with these things first,

May 19, 2010 | 2004 Dodge Ram 1500

1 Answer

Why does my dodge ram 1500 4.7l magnum cut out when turning slowly in car parks and braking slowly to a stop ? ITS YEAR 2002. IS THIS A LAMBDA PROB? 


O2 SENSORS NEVER CAUSE THIS PROBLEM, A DIRTY IDLE SPEED CONTROL VALVE DOES, DO THE PROCEDURE BELOW TO CLEAN THE IDLE SPEED CONTROL SYSTEM
I want you to get a can of intake cleaner (ABOUT $5.00) from any local auto parts store like NAPA or Carquest, do not use carburetor spray, intake cleaner only or u will damage the Teflon coating inside the throttle valve and air bypass valve, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

May 19, 2010 | 2004 Dodge Ram 2500

1 Answer

1998 ram 1500 5.9 gas rough idle,hissing sound from air filter,missfires after each start for 2-3 minutes every time.if driving need tap gas pedal to make it run,on idle sometimes stalls,no dtc codes at...


SHOWING MISFIRES ON SCAN TOOL?IF NOT,ENGINE CONTROLLER HAS NOT LEARNED MISFIRE MONITOR..WILL HAVE TO BE DRIVEN A BIT FOR RELEARN..IF YOU CAN SEE MISFIRES..MISFIRING ON MORE THAN 1 OR ALL CYLINDERS?CHECK UNDERSIDE OF IGNITION COIL FOR CRACKS..IF NOT CRACKED,YOU MAY HAVE A FAULTY CRANK SENSOR..ANY CORRODED PLUG WIRES AT DISTRIBUTOR CAP?ALSO CHECK IF ANY OIL PRESENT IN INTAKE MANIFOLD..GASKET ON BOTTOM OF INTAKE MAY BE BROKEN CAUSING AN INTERNAL VACUUM LEAK

Jun 15, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

Dodge ram 1500 engine rpms surge at freeway speed


those sensors could cause the issue, clean the MAF 1st, also clean the idle system using the following procedure, the IAC can cause cruise surge. I use this to cure these problems all the time.

Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve (IAC) and throttle valve, they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Jan 13, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

2004 Dodge Ram 1500 4.7l


Code p0113 is for the intake air temp sensor. It probably did not get plugged in during the egnine replacement. That will not cuase it not to idle. I need more information for that concern.

Aug 01, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...