Question about 1989 Oldsmobile Eighty Eight Royale
New fuel pump, new ignition control moduel, new mass air flow, new catalytic convertor, shall i go on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
could it be the A/C pump kicking in. might be boging down the motor or electrical circuit, not letting the injectors get enough power. This could happen if the bearings are going bad in th A/C pump or there is a short in it. Just an idea. sounds like you have done the main components.
Posted on Apr 16, 2009
Find coil pack I think it is on the front passenger side. Disconnect negative battery cable. Remove electrical connector from module. Remove the four or six bolts that fasten the coil pack/module to the motor. Mark location of coil packs before removing from module. Replace in reverse order.
Posted on Mar 11, 2010
Put a crank sensor on it to fix. They get hot and stop working. Next time it stops pour or spray some water on it and try to start it. Old trick to solve problem
Posted on Jan 28, 2011
Testimonial: "Thanks for the advice we did that and found that the cables for the ing. module were shorting out with each other. We went ahead and replaced the connector. So now only time will tell if the problem is solved, and once again thanks"
Tips for a great answer:
Jan 22, 2011 | 1989 Oldsmobile Eighty Eight Royale
Oct 17, 2010 | 1993 Oldsmobile Eighty Eight
Jul 22, 2010 | 1995 Oldsmobile Eighty Eight
May 08, 2010 | 1989 Oldsmobile Eighty Eight Royale
May 02, 2010 | 1989 Oldsmobile Eighty Eight Royale
Oct 11, 2009 | 1991 Oldsmobile Eighty Eight
Mar 14, 2009 | 1990 Oldsmobile Eighty Eight
115 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: