Question about 1997 GMC Jimmy
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1996 jimmy gmc fuse box
Look on the driver's side fender well under the hood. Should be a long black rectangular box there. That is the power center or fuse block. The relays and fuses are inside. The top is not hard to remove. Hope this helped and best wishes.
Posted on Sep 01, 2009
SOURCE: set timing 1997 jimmy
Ok that's pretty simple Put cylinder # 1 on TDC= top dead center on the (compressionstroke piston all the way up). Mark on metal part of distributor (with marker) where the number one is on the cap( that's where the number 1 wire plugs in) Then in-plant distributor make sure that rotor point is pointed to #1 on the cap, turn distributor shaft until this is achieved or as close as possible try to center shaft so you can adjust... ****** or advance to fine tune after you in-plant distributor if needed. Contact if you need more help . Good Luck
Posted on Jan 06, 2009
I believe it's the middle relay in the glove box. You should feel the relay click on when you turn the key's, but you only have 2 seconds.
Posted on Apr 05, 2009
there are four nuts that you must remove at the front of the pulley between the fan. remove fan, fan shroud,loosen accessory belts. remove water pump pulley and the pump bolts will be exposed. check belts for replacement while you have them loose. reverse procedure to install.
Posted on Apr 29, 2010
Tips for a great answer:
Jun 23, 2012 | Cars & Trucks
Feb 11, 2011 | 1997 GMC Jimmy
Jan 25, 2010 | 1997 GMC Jimmy
Oct 29, 2009 | 1984 GMC S-15 Jimmy
Jan 23, 2009 | 1997 GMC Jimmy
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: