How do i set the alarm on my 2013 hyundai elantra

SOURCE: 2002 hyundai elantra

no timing to set

SOURCE: 2005 hyundai elantra alarm keep going off

check door switches,trunk switch,hood switch sounds like dirty contact after you set alarm if any of these contacts lose contanuity your alarm will go off alarm system thinks doors,hood,trunk has been opened

SOURCE: 2003 Hyundai Elantra.. Numerous problems with the alarm.....

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

SOURCE: 2003 Hyundai Elantra - diable alarm

YES!... with various system operating difference. Disconnecting the alarm does not disable it.. it only silences the alarm. You will still need the Keyless Entry System Remote to RESET the alarm to start the vehicle.

Reynaldo Andico

• 2431 Answers
• Posted on Aug 20, 2011

SOURCE: how to disconnect car alarm

You have a aftermarket alarm if you want to disable it it would be safer just to jump the origianl splice made at your alarm, go under the dash at the steering coulumn there follow the ignition wire you will see a relay there Now here the fun part the vehicle ignition wire is a solid or stripe wire there the alarm installer cut it and attached it to a relay where they made the cut you will go and restore it back to the original condition leaving the rest alone if you decide to use a but connection make sure it is connected properly if you solder the connection make sure you protect it with electrical tape so it wont short out you may have to disconnect the alarm horm under the hood and not the car horn it that simple