Question about Ford Cars & Trucks

Open Question

How do i replace a u joint on a ford escape? - Ford Cars & Trucks

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ford escape Rear Suspension With Coil Springs - out of joint?

It is a 4x4. The "yellow" looking item in between/inside the black spring coil seems to be out of its joint. When I compare the left vs the right, the left side is sitting up high, while the right side appears to be settled into place.

Posted on Nov 13, 2008

  • 3911 Answers

SOURCE: How do you replace cvs joints on a 2001 ford

you take it to a shop and have them replace the front drive shafts. there is a CV joint on each end. you need special tools, knowledge, and a lift to get this job done. get yourself a repair manual on ebay and scope it out before you put a wrench to it. they charge extra if you worked on it first.

Posted on Dec 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

09 Ford Escape, Is it possible to replace CV joint without disconnecting the strut mount fom the seering knuckle? I ask because I managed to do it on 92 Pontiac Transport and curious if I can repeat the...


some vehicle s you can and others you cannot . It depends on the length of the axle from the cv joint as to be able to get it out of the stub section.. Sometimes removing the steering rod ball joint may allow extra turn of the wheel to pull it out but I doubt it.. Any workshop manual will tell the story.

Apr 21, 2014 | 2009 Ford Escape

1 Answer

How do I replace drivers side front axle on a 2003 Ford Escape ?


remove the right front wheel. remove the axle nut. remove the ball joint bolt and nut. remove the ball joint from the knuckle. drive the axle out of the hub. remove the 2 carrier bearing nuts. pull the axle out. make sure you torque all bolts and nuts.

Sep 17, 2011 | 2003 Ford Escape

1 Answer

How do you replace cvs joints on a 2001 ford escape


you take it to a shop and have them replace the front drive shafts. there is a CV joint on each end. you need special tools, knowledge, and a lift to get this job done. get yourself a repair manual on ebay and scope it out before you put a wrench to it. they charge extra if you worked on it first.

Dec 11, 2010 | 2001 Ford Escape

1 Answer

Is the any parts to grease on my 2005 escape in the front end


There shouldn't be any tie rods or ball joints to grease, unless they have been replaced. Many aftermarket parts come with grease fittings, including the sway bar links, lower ball joints and outer tie rods.

Nov 18, 2010 | 2005 Ford Escape

1 Answer

How i change the joint ball on escape 2002


I have a 2002 Escape. The front lower ball joint is integrated into the lower control arm. You will need to replace the control arm. The good news is that the control arm is fairly inexpensive $30-50(?). I found the dealer had the lowest cost (weird).

You have to safety lift the car and get the tire off the ground.
Remove the tire/wheel, to get some room and light.
You need to remove the the ball joint connection first.... it's usually the hardest.
Remove the cross bolt and nut from the ball joint at the knuckle.
You may need to spread the "split" a little with a big chisel and hammer.
The ball joint stud needs to slide out of the knuckle.
Remove the other two connections to the "frame".
Here's a picture outside the car:

zeevert_15.jpgzeevert_16.jpg

Oct 20, 2010 | 2002 Ford Escape

3 Answers

2005 ford escape awd shutters very badly upon take off up to about 30 miles per hour then gets progressively better. Is the center drive shaft bearing bad and is it repairable . Ford says the driveshaft...


Have a 2005 ford escape XLT 4WD and when I get between 45-60km per hour the vehicle shakes like I'm driving on a washboard. Took it to Ford - they told me I need a new drive shaft - $1200 with taxes and labour. I already replaced the alternator in 2007 - that was over $800 because of where it is positioned. Takes hours and hours to get at it because it is buried under the motor. I think Ford needs to give us all a discount. Sounds like these are common problems with the Ford Escape.

Oct 07, 2009 | 2001 Ford Escape

2 Answers

Ford escape Rear Suspension With Coil Springs - out of joint?


you didnt say if it was 4x4 but here is a pic
can you7 tell me what socket is out of joint?
cdf09f2.jpg

Nov 13, 2008 | 2003 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...