Question about 2006 GMC Sierra

Open Question

Passenger-side mirror turn signal does not work

The turn signal, locaated in my side mirror, does not light up. Where is the bulb located?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

betz73
  • 298 Answers

SOURCE: Replacing passenger side outside mirror

open the door, on the opposite side of the mirror there is an interior panel, remove it, there are 3 nuts in there remove those, the mirror should come off, if it is power be sure to unplug it.

Posted on Oct 07, 2008

  • 56 Answers

SOURCE: Rear turn signal bulb on passenger side of 1997

Open your rear door and on the inside jam where the light is remove the two screws.There either a philips or torx head.Rotate out a little and litely pull the other side tabs out of the notches in the quarter panel side.Once you remove the light you will see a circut board with two more screws.Your bulbs are on the inside of the circut board.If your new bulb doesnot work,you may need to replace the circut board,there known to burn out.Hope this helps.John.

Posted on Mar 09, 2009

  • 75 Answers

SOURCE: Passenger side mirror glass is cracked. Will this

the ceapest way to fix that is to get a new one at certi fit they are the cheapest

Posted on Aug 17, 2009

  • 14036 Answers

SOURCE: tail lights work on both sides. turn signal and

check fuse to driver side turn signal lamp.check brake light bulb or replace bulb on driver side.also replace the front driver side turn signal bulb that is flashing fast.

Posted on Dec 14, 2009

  • 1 Answer

SOURCE: 99 yukon denali drivers side

The circuit board needs to be replaced. Which is the board that the bulbs sit in. If you remove the turn signal bulb. You will notice the bulb socket will be slightly burnt inside. I had the same problem with my 99 Denali and replaced the circuit board for $35.00. Now everything is fine.

Posted on Feb 02, 2011

Testimonial: "Thanks! That was the problem & my local Napa store had the part in stock and for that price."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger side front turn signal/DRL do not work.


Dear Alex,
The problem is in the bulb, or the socket, or the wiring to these.
Whenever a turn signal flashes fast, know that one of the bulbs is not working.
You have already identified the problem as being the front one. Problem could be the hot wire, or the ground wire, or the ground connection to this bulb.
Start by taking a tester to the hot wire, and see if it is receiving electrical impulses when the turn signal is on.
( It probably is, unless the car has been in a wreck and has been improperly repaired.)
Then check the socket or the wires to is and see if the bulb is grounded.
I suspect the ground is defective, and either a new socket or a repair to the ground wire should fix you rights up.
God bless your efforts.

Aug 02, 2016 | 2002 Pontiac Montana

1 Answer

2007 Ford Focus front passenger side turn signal blinks fast. Works fine with head lamps off, doesn't work when headlamps are on.


faulty earth wire on the wiring cluster for the heat light check with a meter and fix the earthing point.

Mar 19, 2014 | 2007 Ford Focus (3 Door) Hatchback

1 Answer

Right rear turn signal does not work


check the bulb there some bulbs have two elements in them the turn signal element might be broken change the bulb

Sep 19, 2012 | Cars & Trucks

1 Answer

Turn signal bulb was working, now it isnt


its is not uncommon for the contacts in the sockets to become corroded or just expand to the point of where they do not contact the bulb,try to test the socket with a multimeter for voltage,if it has voltage then its most likely the contacts,which sometimes can be rebent,but replaceing the sockets is a better solution,and can be picked up at most stores or 4x4 shops and junk yards.

Dec 14, 2011 | 1998 Jeep Cherokee

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

4 Answers

Front driver side turn signal light doesn't flash.replaced bulb,replaced socket,all other lights work on emergency flasher,except front driver side.rear driver side turn signal light works,but flashes...


replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher

May 09, 2009 | 1998 Buick Century

1 Answer

Replacing burned out turn signal bulb in passenger side mirror.


I'm pretty sure the light is part of the glass. The mirror glass is available seperately. Check Ebay or tascafordparts.com for a discounted part. Or, car-part.com for used one. Page with * is lowest price.

here is 2003 Nav. I don't have 2004. May be similar. please give good rating if this help. Good luck
-----
Removal and Installation
  1. Position the mirror glass to obtain a gap at the top edge of the mirror and carefully pull the top edge of the glass away from the mirror housing.

  1. Disconnect the heated mirror electrical connectors.
47533d6.gif
  1. Remove the exterior mirror motor screws and exterior mirror motor.
    • Disconnect the electrical connectors.
29728ca.gif
  1. To install, reverse the removal procedure.


-------

Mar 29, 2009 | 2004 Lincoln Navigator

1 Answer

Replace passenger side power mirror clearance lamp (bulb only).


If you are facing the passenger side mirror adjust the top (large) mirror so that it is turning in towards the truck as far as it will go. Then look behind the mirror in the bottom righthand corner (outside bottom corner) and you will see a silver metal clip. Take a straight head screw driver and push on that clip and the lens will pop out. Then you simply unscrew the bulb holder from the lens and replace your bulb. Good luck!

Oct 16, 2008 | 2008 Ford F-350

Not finding what you are looking for?
2006 GMC Sierra Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...