Question about 1992 Ford Tempo

1 Answer

Dont work rear door locks

Rear door locks are locked permanently

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Ford Master
  • 1,249 Answers

Your Tempo is equipped with early child-proof rear door locks...(cannot open from the inside when locked) Open the doors from the outside and look near the door catch for a small switch that moves back and forth...if still labeled it should show "Lock...Unlock" marks...leave on unlock for normal opening from inside. Hope this helps.

Posted on Jan 21, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: Rear door dosn't lock

the problem is the lock actuator . it needs to be replaced and its no easy job

Posted on Apr 21, 2009

kalei02EXC
  • 62 Answers

SOURCE: Rear Door will not Lock

After researching this problem, I suspect it is the door lock actuator located in each affected door. They can be purchased online. If you also suspect this and want to fix it yourself by removing the door panel and the old actuator, then installing the new actuator, test the locks, then install the door panel. Or for more detailed information, go to this website for a how to with pictures and written instructions. http://www.ford-trucks.com/user_gallery/displayalbum.php?&albumid=12198

Posted on Jan 23, 2009

  • 1 Answer

SOURCE: 2000 Ford Focus electric locks/acuator failure recurring problem

I would follow their recommendation as I had the same problem with my car. They unhooked the power to that door and it was fine. The problem was a short in the wiring in the door that was causing the problem. So maybe get them to check the wiring in the door as well.

Posted on May 26, 2009

  • 166 Answers

SOURCE: 2002 Ford Explorer - Drivers side door lock, rear

Aside from the fuses, your drive side power door lock may be failing to work because of a bad door-lock relay system, or, alternatively, the locking switch/button, itself, is not malfunctioning and in need of replacement.

A great handyman site that specifies the above probable causes and more is the following link:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Locks_Power_Locks_Do_Not_Lock_When_Pressing_Locking_Switch_Button.htm

Good luck!

Posted on Jul 18, 2009

  • 1 Answer

SOURCE: my power door locks dont work can not get into the

1998 door locks wont work neither does keyless entry

Posted on Feb 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why don't the rear door locks work anymore?


first is fuses are they good.?
the locks on cars are solenoids.
im guessing all ways to open it fail,
keys, key fobs, and internal controls panels?
no childern locks set (some are hidden on cars)
no drivers, panel , master lock, he pushes it and all locks freeze?
this is a general statement.
so you use a thing like a volt meter. $10 at walfart.
we check for 12vdc across the 2 solenoids.
12vdc when active is good.
0v is bad,
if you get 12v then the solenoid is bad or jammed.
if you get 0v, the controls are bad.
its that simple. and electro magnetic solenoid, is easy to test.
with any voltmeter made.
if the controls are bad we use the same method to check them.
12vdc to the switch it must be.
then you push the rear switch and 12vdc leaves this switch.
if not the switch is bad.(input good)

Jul 16, 2015 | 1995 Isuzu Rodeo

1 Answer

Rear doors dont lock with auto lock switch on ram 2500 slt


Check the wiring harness into the rear doors - they tend to get crimped and break the wires

Feb 04, 2013 | 2006 Dodge Ram 2500

2 Answers

LDV Maxus 3.5 Drivers door lock initially wouldn't unlock with fob, will work with key. Now will not lock or unlock on fob. Back door will unlock with fob, but does not lock, it has to be locked


The problem is not the actuators, the fault lies in the central locking control unit under the dashboard, behind the glovebox, on the firewall. The CLCU is mounted with the connection terminals to the top resulting in condensation going onto the printed circuit board inside, if the damage started a while ago there is only 3 ways to go.

1. specialist firm to repair the CLCU.
2. Replace.
3. (As I did) buy a cheap remote control receiver with keyfob/s. Cut all wires off the multiplug, there are four pairs, a permanent live and permanent earth. Test each wire to earth on the van to identify the permanent earth FIRST. Then test pairs of wires across 12v/Earth noting which pairs actuate which lock.Isolate in pairs noting which wire has to be live to lock, (Reversed it will unlock) wire each pair into the relay on the remote receiver using the relay to changeover the polarity to each pair You will then be able to Lock/Unlock all the doors, throw the old CLCU away and mount the RCReceiver eslewhere to keep it dry. each door individually. I bought a 2 way RCReceiver and can lock/Unlock front doors seperate the the rear ones which is of far more use! Any decent electrician will tell you how to wire the relays. Job Done..... (100% Sure)

603d3609-f326-41be-a38e-a00bb8d6bdab.jpg

Feb 02, 2013 | Cars & Trucks

1 Answer

Buick 2002 LaSabre Custom all windows do not go up and down, door lock/unlock switch drivers side does not work(passenger & rear doors lock/unlock door switches work, trunk release button does n


coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Oct 24, 2012 | 2002 Buick LeSabre

1 Answer

2001 VW Cabrio's Power Locking Issue.


You need to the BCM (body control module) scanned, it may be defective.

Jun 15, 2017 | 2001 Volkswagen Cabrio

1 Answer

The rear locks dont work with my key pad nor with the unlock button in the front but the fronts locks work


Not sure the rear make or model of this car but this sounds like you may have bad lock actuators, these are the small motors that lock and unlock the door locks. there is one in each door. good day,

Mar 23, 2012 | 2008 Chevrolet Impala

2 Answers

Rear hatch 2005 chevy tahoe is locked & won't open


my 06 tahoe just got this problem...all other doors lock and unlock with the fab and door switch...but the hatch is in permanent locked mode. i cant even unlock the hatch window. why is this happening?

Jan 27, 2010 | 2006 Chevrolet Tahoe

1 Answer

Golf gti left rear door locking system


it is probably your door lock has gone into safe mode.you need a new door lock.try using the lock/unlock button on your remote or on the drivers door button and gently tap the door handle with your hand while pressing the lock/unlock button,carefull not to dent your car.if that does not work,try disconnecting the cars battery for a few minutes,but note the vehicle might pick up fault codes which need a diagnostic machine to clear...good luck

Nov 09, 2009 | 2001 Volkswagen Golf

Not finding what you are looking for?
1992 Ford Tempo Logo

313 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...