Question about 2006 GMC Yukon Xl Denali

Open Question

Where To Add Power Steering Fluid GMC Denali - 2006 GMC Yukon Xl Denali

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: power steering fluid leaked out of 2000 GMC Jimmy

well it went somewhere, check all the lines and look for signs of recent fluid leaks, it will be very apparent if u lost that much fluid, most likely it will either be the power sterering hoses or the front shaft seal of the pump.

Posted on Mar 30, 2009

Ad
  • 11 Answers

SOURCE: drain and replace power steering fluid in my gmc

generally there is 2 hose going to the reservior , usually the small one it the inlet, take that off anbd put a blocked off hose in place. put into a bucket, have a few liters handy turn the car on and have some1 fill it keeping it full, warning it will come out fast. and have some1 turning the steering wheel lock to lock. untill clean, the turn car off

Posted on Jul 11, 2009

  • 113 Answers

SOURCE: Front End Rattle

I am guessing it is still under the factory warranty. Take it to the dealership and have them fix it for free.

Posted on Aug 03, 2009

  • 135 Answers

SOURCE: Screeching noise when I turn the wheel. What type

plain power steer fluid or auto trans fluid.

Posted on Aug 05, 2009

Molson02536
  • 3854 Answers

SOURCE: how do i add differetial fluid to A 2005 GMC

There is fill plug on the passenger side of the differential drive shaft side where the axle tube meets the differential housing. Your going to need a 3/8" ratchet with the extension and a hammer. Once you get the ratchet with the extension on the fill bolt, which is a square bolt that the extension fits right in. Use the hammer to tap the ratchet to break the bolt loose from the differential, remove the bolt once it has loosen enough with just the ratchet. The Canyon must be leveled to fill the differential, fill till the fluid starts to flow out and reinstall the fill plug. Don't over torque for future fluid check, the bolt is tapered so it will not leak. Good luck and hope this helps.

Standard Differential, Front......GL-5
ALL TEMPS......75W-90
Synthetic lubricant, GM part no. 12378261,or equivalent product formulated to meet GM specification 9986115.

Standard Differential, Rear......GL-5
ALL TEMPS......75W-90
Synthetic lubricant, GM part no. 12378261,
or equivalent product formulated to meet GM specification 9986115.


Differential, Front..........1.5 liters
Differential, Rear..........1.6 liters

Differential capacities varies between 1.6L-1.8L (3.4-3.8
pints) on the rear differential



Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Power steering loss


have a pressure test done on the pump and if faulty then replace it.

Jan 09, 2014 | 2002 GMC Yukon Denali

1 Answer

We have a 2003 yukon denali xl and just turned real hard to back out of a field and now you can hardly turn steering wheel to drive..


Have you checked the power steering belt and the fluid level in the power steering reservoir? The belt may be slipping or the hard turn may have caused a leak in one of the hoses that power the unit.

Oct 26, 2013 | 2003 GMC Yukon XL

1 Answer

How to add power steering fluid


There is a reservoir under the hood that stores power steering fluid. That is where you add the fluid. Most likely, yours will be located directly behind a drive belt pulley, attached directly to the power steering pump, and the cap should be marked for power stering fluid. It will contain a dipstick that has marks stating minimum and maximum fluid levels with the fluid either hot or cold. If you have to add to it often, you have a leak that needs to be repaired.

Oct 05, 2012 | 1993 GMC Sierra K1500

1 Answer

My power steering is low and my yukon is making a noise when i turn. i dont have any power steering fluid right now can i use atf instead until i can get some.


I would get power steering fluid and not substitute ATF... I'm sure there's a fuel station or convenience store nearby you can locate PS fluid from. Also when you top it up, with it running turn steering from stop to stop (side to side) not holding at stops for anything longer than a second or two to get air out of system, then retop.

Feb 22, 2011 | 2006 GMC Yukon Xl Denali

1 Answer

The power steering does not work all the time


could be you belt or fluid low do you hear a whinying noise?

Jan 24, 2011 | 2004 GMC Sierra Denali

1 Answer

How do you know if your power steering fluid is low?


On switch on there is an indication of the steering fluid which must go off when the engine starts up-- usually it is yellow.
If the lamp stays on the fluid must be checked or a possible fault in the power steering.

Sep 27, 2010 | 2005 GMC Yukon Xl Denali

1 Answer

I have a 2002 Denali pickup with quad-steer and the steering wheel is very hard to turn to the right. I have switched to 2 steer and have the same problem. Could it be the steer box or the pwr steering...


it should have a pump is there any whining noise when steering if so ad power steering fluid and check for leaks your owners manual will tell you what fluid and the pump will be on the front side of engine

Apr 30, 2010 | 2002 GMC Yukon Denali

1 Answer

Steering problem


More than likely is your rack n' pinion, never the less open the power steering reservoir check for circulation, before taking it to 1 place always get at least 3 different opinions and choose that one thats more logical...get somebody that can warranty everything they do this way you'll know if they know what they are doing instead of starting the bill..scan if they are really concern about you more than geting in your pocket

Mar 24, 2010 | 2005 GMC Yukon Denali

1 Answer

Where is the Block Heater on my 2003 GMC Yukon?


The cord is located on the driver's side of the engine compartment, near the power steering fluid reservoir; See page 2-24 of your Owner's Manual. On my truck, the dealer used a wire tie to clip the plug to the front grillwork. It may be hard to find if the black plastic plug it is tucked away behind the black grill plastic.

Dec 13, 2009 | 2003 GMC Yukon Denali

1 Answer

1997 Jimmy


Your power steering tank will not hold more than 2 pints. First check with your owners manuel to be sure of the proper fluid. With the small bottle of steering fluid, add slowly. check every so often with the dip stick until it says full.
Bill

Nov 18, 2008 | 1997 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...