95 ford explorer xlt, all the blinkers quit working after I had an oil change and new tires installed. We bought a blinker relay [for the hazard lights] but can not find where it is.
Just fixed my flashers today on my 95 explorer, All my lights worked but no turn signals or emer flashers. First make sure all lights are working. Next check the fuses on the left side of the dash, I believe # 10 & # 11, if all is good you can replace the flasher relay, which actually called a flasher unit, or just flasher, Note : that did'nt work for me, but it is located under the dash even with the stering column, it is a small yellow or green box, mine was attached by plastic clips, just twist back an forth till it comes off, now let it hang down , being carefull not to pull on the wires, and use a screw driver to disconnect the box, its not very easy, the New flasher unit will have 5 prongs and the old will probibly have 6 prongs, don't worry the small 6th one doesn't connect to anything anyway. just plug the new one in and put it back up under the dash. My Problem was simply the emer flasher button on top of the stering column it must have a loose connection, because all I did after all that was to lift it up with the key on and jiggle it then pushed it back down , I turned the turn signal on and nothing, then left the turn signal on and jiggled the emer flasher button again when it was down, and I had turn signals, no problem since, but remember to leave the button down!!
Dec 11, 2008 |
1995 Ford Explorer