Question about 2005 Jeep Liberty

Open Question

Clicking noise from heater blower motor

Clicking noise from 2010 jeep liberty blower motor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 137 Answers

SOURCE: Inoperable Power Window 2006 Jeep Liberty

the window regulator needs to be replaced

Posted on Jan 19, 2009

Brian032472
  • 150 Answers

SOURCE: 2003 Jeep Liberty heater fan problem

It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

Posted on Feb 01, 2009

  • 2 Answers

SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty

You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.

Posted on Apr 06, 2009

keithheavili
  • 410 Answers

SOURCE: My blower motor only works on high speed its a

Your blower motor resistor has gone bad. Everytime these go out (definitely happens a lot on Jeep) you will lose every speed except for the highest one. Replace your resistor and you will be back to new. Let me know if you have any further questions. Thanks for using FixYa!

Posted on Aug 25, 2009

  • 3640 Answers

SOURCE: how to replace 2006 Jeep Grand Cherokee fan Heater

the blower motor is under panel near glove box. remove connector then the 3 mounting screws that hold it in. if changing the motor, use old fan cage from blower to new one, remove retainer clip to take off of motor shaft. CARL,

Posted on Jan 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 jeep blower stays running after button off


changing the blower motor was a waste of time and money, you have power going to the blower after the switch (button) is turned off, could be a bad switch

Jul 14, 2014 | 2010 Jeep Liberty

1 Answer

2010 jeep liberty heater blower not working


There are 3 reasons a heater blower will not run. I will list them in most common cause order.
1. No power to the motor.
Check the fuse (it is listed in your owners manual).
Check for power at the motor.
If the fuse is good and there's no power at the motor then it gets complicated and you should take it to someone with experience in fixing these.

2. Motor is bad
Remove the motor and apply power (12 volts) to it. If it is good it is going to spin fast, so better hold on tight. These things can hurt when they are loose and turned on.

3. Something is blocking the fan.
Remove the motor and look for the pencil (or whatever) may be stopping the fan from turning.

If what I've written doesn't make sense, then I would suggest either take it to someone who has experience or buy a repair manual (and other tools) and plan to spend some time reading and experimenting.

Jun 26, 2014 | 2010 Jeep Liberty

2 Answers

Where is the blower motor relay located on a 2010 jeep liberty


on all speeds, is it dead sounding or only no air flow???
wow no symptoms posted only this goose chase deal.

use the scan tool yet? see all DTC errors.
2008 cars can report most cause of lost power etc,
not scanning, invites expensive gue$$ing.!!

HVAC 101: (
gdoes the motor have 12vdc on high? at connector to it>?
on all speed's (now that is a KEY FACT there)

  1. defeat air bag first or die , fiddling these parts.
  2. do the HVAC calibration yet? per FSM.
  3. scan it yet ,if not you will guess wrong. I promise,
  4. i have to stop my online page ,is missing the wiring sections.

calibrate damper:
Use this procedure to ensure that the A/C-heater control is correctly calibrated to the blend door actuator. If the calibration is not correct, the heating-A/C system may experience a condition where full heating or cooling capabilities cannot be obtained.

Many steps can not be done with out a real jeep scan system.
sorry, cant.

Apr 16, 2013 | 2010 Jeep Liberty

1 Answer

I have a 2008 Jeep Liberty. The heater/air blower just quit working, I checked the fuse and that was good. What's the problem?


most likely its the blower motor unless it has a relay that you cant check you just have to replace it. sometimes you will have a few relays that are the same and you can use one just to see if thats the problem,but make sure its not one that controls anything major.

Dec 10, 2012 | 2008 Jeep Liberty

1 Answer

Heater blower is not working


cheek blower motor and fuse,

Dec 06, 2012 | 2010 Jeep Liberty

1 Answer

My 2002 jeep liberty 3.7L the heater stop blowing it was working on the number 4 setting now it dont work at all. no heat


this sounds like the heater motor resistor has gone bad and needs replacing.this controls the amount of voltage that goes to the blower motor to give you the different speeds.if it was the blower motor it wouldn`t have worked on #4 setting before stopping.this us located in the air box as it uses the air flow from the motor to help keep it from getting too hot,usually in the area of the motor and has about 5wires connected to it.

Oct 19, 2011 | 2002 Jeep Liberty

1 Answer

2002 jeep liberty , heater blower resistor i know was going bad , cause it only worked on setting 4 , but now its not working at all , its not blowing out period . so could it still be the heater blower...


maybe check the heater fan motor by hooking it direct to power and if it blows full power then it has to be the resistor or maybe the switch for the speed control is burned up.

Jan 25, 2011 | 2002 Jeep Liberty

1 Answer

We have a 2002 jeep liberty. The heater and defrost only works sometimes what are some possible causes.


If you mean that the heater "fan" only works sometimes, there is heater blower resistor mounted to the heater motor, (behind the glove box) and if it goes bad, you normaly have high speed only. These are common to go bad, and not expensive.

Jan 02, 2011 | 2002 Jeep Liberty

1 Answer

My Jeep 2003 Sport, heater only works on #2 &


You heater only works on speeds #2 & 4 because the blower motor resistor pack is defective. Replace it.

Jan 02, 2010 | 2003 Jeep Liberty

1 Answer

Heater only works on 3 and 4 setting


Your heater motor speed selector only working on a couple levels is caused by a faulting blower motor resistor.This part is located on the evaporator case next to the blower motor itself.Two bolts remove the resistor and an electrical pigtail finishes it off.The location of this is underneath the dash on the pass front side.Happy Holidays!!

Dec 10, 2009 | 2004 Jeep Liberty

Not finding what you are looking for?
2005 Jeep Liberty Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...