Question about 2006 Toyota Solara
The gauge that shows what your average mpg should be. up by the clock and temp guage.
The battery was changed so power was lost. After turning the car back on the mpg guage keeps changing from 5mpg up to 99. how can this be reset
If you refer to the owner's manual the reset info is in there. If you don't have a manual, go to the Toyota website and see if you can download one there.
Posted on Jun 23, 2016
Check the manufacture's Cold Cranking Amps (CCA) rating. Some manufacturers recommend a minimum CCA. If your CCA is below the manufacturer's specs, it can cause your car to run erratically. This also can cause problems with your computer and give you faulty DTC's. (Diagnostic Trouble Codes - Service Engine Soon Light) This especially causes problems with General Motors cars. I'm always hearing of people with these problems. Let me know how it works.
Posted on Feb 02, 2009
I get many calls a week for this procedure...
This is really easy! Follow these directions:
Turn the key ON
Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.
Turn the key OFF.
Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.
Turn the key ON, do not start the engine
Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.
Release the black trip meter reset stick.
This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.
Hope this helps!
Posted on Feb 06, 2009
Those cars have a frequency sensor that is attuned to the exact sound frequency of breaking glass. Are there any noises nearby that resemble glass shattering? Wind chimes? Any type of extraneous noise at the freq of glass breakage will set off the alarm.
Posted on Feb 27, 2009
Previous Post dead wrong...
Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.
Turn ignition OFF
Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.
Posted on Jun 27, 2009
Tips for a great answer:
Oct 26, 2014 | 2008 Toyota Camry Solara
Sep 09, 2014 | 2006 Toyota Corolla
Apr 08, 2013 | 2006 Ford F-150
Oct 10, 2010 | 2006 Toyota Solara
Oct 01, 2010 | 2004 Toyota Camry Solara
Jul 12, 2010 | 2006 Toyota Solara
Mar 22, 2010 | 2007 Volkswagen Passat Sedan
Aug 11, 2009 | 2005 Chevrolet Cavalier
Jun 29, 2009 | 2006 Honda Civic Hybrid
Apr 03, 2009 | 2000 Volkswagen Beetle
639 people viewed this question
Usually answered in minutes!