Question about 1994 Mazda 2WD B Series Pickup

1 Answer

Truck broke how do i change a front weel baring in a 94 mazada b4000 4x4

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Remove outer grease cover,if there is one,then remove the cotter pin holding thr lock nut in try turning the nut clockwise or counter clockwise depending on which side of the vehicle it is.then you can wiggle the wheel side to side to loosten the bearing.that should do it.make sure to re-grease and reverse the procedure

Posted on Mar 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 94 bravada

check eng. lite?intake hose no cracks and installed correctly and tight to throttle body. a must check fuel pressure regulator,can pull vac line while running will leak fuel,replace.exaust restriction?

Aug 25, 2014 | Cars & Trucks

1 Answer

No 4 weel drive

Put it neutral and then hit the button for 4 Wheel drive. It should work then and do the same to take it off 4 wheel drive.

Jan 31, 2014 | 2003 Ford Explorer

1 Answer

Strange noise in front weel

Probably a front hub failing. Does the noise change or reduce if turning right or left? If yes, it is the hub opposite to the turn.

Apr 06, 2013 | 2002 GMC Envoy

1 Answer

How do i change the ac belt on mazada 1998 626 4 cylender

How do i change the ac belt on mazada 1998 626 4 cylender car

Aug 19, 2012 | Mazda 626 Cars & Trucks

1 Answer

Overheating. heater blows cold air. all coolant comes out overflow. I already changed the thermostat.

Lower Intake Manifold Gaskets good? Look for small build ups of oil around the LIM. Mine you could barely hear, hissing out can be pinpointed with a long straw or something similar by holding it to your ear and serching for the leak. Also may want to watch your weel hole to see of water pump is good. the system may also be plugged.

Dec 02, 2011 | 2000 Pontiac Grand Am GT

1 Answer

Which type of ABS brake system was used on the year and type of truck

the problem on that year of the pick up if the abs sistem is not working right the rear weels lock up with just touchin the brake pedal there are three sensors one on the rear end and one on each front weel most of the time the front sensors get dirty and that afect the sistem that truck is runing 13 year time to clean those sensors the one on the rear end had to be clean wen you change the oil

Dec 19, 2010 | 1997 Chevrolet S-10 Pickup

2 Answers

How do you change alternator belt on 1997 mazada 626

heres a diagram to help you, loosen the bottom bolt a few turns then loosen the top bolt then loosen adjusting bolt to loosen belt, use the adjuster to tighten the new belt then tighten top and bottom bolts, hope this helps,8a841eb.gif

Oct 04, 2010 | 1997 Mazda 626

1 Answer

Hi, I have a 94' Chevrolet Corsica, and the engine temp gauge light came on. It was making a weird clicking noise. When I pulled over to park, my car stalled. The engine and stering weel it seemed like,...

Check your serpentine belt. If ok then check engine coolant if that is ok take off radiator cap start engine and watch to see if the coolant in the radiator starts to circulate when engine reaches operating temp. If it don't change engine thermostat if all fails to get coolant moving then you will have to change the water pump.

Sep 17, 2010 | 1994 Chevrolet Corsica

1 Answer

2003 Mazada Protege Battery issues

battery 4 years old i wouldn't think twice in changin battery.. i wouldn't even test it you need to change it no matter what,,,,,winter time is coming....after changing battery i think all will be ok... if not write me back for more help

Aug 31, 2009 | 2003 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides