Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Ok ready to stand on your head under the dash?
It's doable... there is a flange connected to the gearshift lever under the steering column. If you remove the lower dash cover where the fuses are, you should be able to see it when you move the gear shift lever... look around on the floor of the truck to see if you dropped a star-headed bolt or two... these bolts worked loose on my superduty and made shifting very difficult..it was an easy fix... let me know how you do on it.
Posted on May 10, 2009
I believe that the cable has to be adjusted. Most cases, the cable adjustment is off. Worst case senario, is the bushing in tranny is worn out.
Posted on Jun 22, 2009
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
Posted on Oct 08, 2009
the linkage has slipped and is not in the notch on the shift lever so slide he shift lever into place then tighten the bolt down so it will hold the shifter on the trasnmisson, this is caused by a loose nut on the shifter nut.
Posted on Jul 04, 2010
Tips for a great answer:
Oct 01, 2016 | Citroen Cars & Trucks
Feb 15, 2016 | Cars & Trucks
Mar 04, 2015 | Citroen Cars & Trucks
Dec 31, 2014 | Citroen Cars & Trucks
Oct 02, 2014 | 2005 Citroen C3 1.6
Apr 27, 2014 | 2005 Citroen C3 1.6i
Jan 22, 2013 | 2006 Citroen C3 1.4i
Sep 21, 2017 | Pontiac Cars & Trucks
144 people viewed this question
Usually answered in minutes!