Question about 1999 Dodge Ram

2 Answers

Transfer case wont engage

I have a 95 dodge ram 1500. I can engage the fransfer case by using the floor shifter to 4hi and 4low, but i jacked the front driver tire off the ground and can spin it with my hand. Any ideas what is wrong?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Shift into 4wd and move truck a couple of feet.
if light is still off, park truck block the wheels set the park brake jack right front wheel and try to hand spin the wheel if wheel doesn't turn 4x4 is functioning properly but there is a wiring problem use an ohmmeter to check the 4x4 switch wiring fuse and bulb
if wheel turns freely the front axle or transfer case is not engaged
attempt to hand spin the front driveshft if the driveshaft will spin the transfer case is not engaged check the transfer case shift linkage, problem is in linkage or transfer case internals
if the driveshaft will not spin the transfer case is engaged properly
with trnsmission in neutral or park start engine measure vacuum on the two vac lines at front axle shift motor . one line should have approx 20" vacuum. other line should have none
if no vacuum measured look for vac leak or bad vac switch
if both lines have vac look for a bad vac swithc or ruptured cad actuator diaphragm
if one line has 20" +- VAC
move transfer case lever to 2wd measure vac again lines should have swapped vac signals
if no vac switch bad or 4wd shift likage needs adjusting
if yes vac motor bad or stuck or shift fork stuck
remove vac shift motor from the axle attach vac lines to shift motor engage disengage 4wd
does shift motor plunger move at least 1/2 inch
no shift motor bad
yes check axle shift fork and vac motor for binging

Posted on Jan 27, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1998 dodge 1500 4 wheel drive will not pull in any gear 2 w or 4 w drive line good put in any gear trys to pull but pop out took back drive shaft ingage transfer still no go

Posted on Apr 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a diagram of the fronr axle


About 1,160,000 results (0.60 seconds) Search Results

    Dodge Ram 1500 Questions - 4WD not engaging all the ...

    www.cargurus.com > Questions > Dodge > Ram 1500

    CarGurusAsked by mudslingin Oct 18, 2013 at 01:00 PM about the 2001 Dodge Ram 1500 ... to get it into 4LOW is to 1st get it into HI and then stop and shift it into LOW. What's ... I have a 98 Dodge Ram 1500 that I can not get the 4 wheel drive to engage. ... what web site can i go to so i can see how the inside looks on timing gears.

    NEED HELP! DODGE WONT GO INTO 4x4 SNOWS FALLING [Archive ...

    www.plowsite.com > ... > Commercial Snow Removal

    Jan 22, 2005 - 23 posts - ‎14 authors
    My 1997 dodge ram 2500 wont go into 4x4. I shift the transfer ... Because on mydodge the light doesnt come on in 4 wheel drive sometimes.

    Diagnosing 4WD Engagement Problems on Dodge Ram ...

    dodgeram.org/tech/repair/4X4/4x4_engagment.htm
    Nov 1, 2000 - This shift will be easier if you momentarily release the accelerator pedal. Apply a ... Do not attempt to shift to or from 4L while transmission is in gear or clutch is engaged. ... OK, now when you shift into 4WD it gets a little more complicated. .... I have a 97 RAM 1500 Club Cab Sport 4 X4 and I am having‎CAD operation - ‎CAD alternatives - ‎Hard Low range shift

    my 2001 ram will not engage into 4wd nor will 4 low. no light ...

    www.justanswer.com > Dodge

Feb 08, 2016 | Dodge Cars & Trucks

1 Answer

2001 dodge ram 1500 will not go into four wheel drive


About 1,160,000 results (0.62 seconds) Search Results

    Dodge Ram 1500 Questions - 4WD not engaging all the ...

    www.cargurus.com > Questions > Dodge > Ram 1500

    CarGurusAsked by mudslingin Oct 18, 2013 at 01:00 PM about the 2001 Dodge Ram 1500 ... to get it into 4LOW is to 1st get it into HI and then stop and shift it into LOW. What's ... I have a 98 Dodge Ram 1500 that I can not get the 4 wheel drive to engage. ... what web site can i go to so i can see how the inside looks on timing gears.

    NEED HELP! DODGE WONT GO INTO 4x4 SNOWS FALLING [Archive ...

    www.plowsite.com > ... > Commercial Snow Removal

    Jan 22, 2005 - 23 posts - ‎14 authors
    My 1997 dodge ram 2500 wont go into 4x4. I shift the transfer ... Because on mydodge the light doesnt come on in 4 wheel drive sometimes.

    Diagnosing 4WD Engagement Problems on Dodge Ram ...

    dodgeram.org/tech/repair/4X4/4x4_engagment.htm
    Nov 1, 2000 - This shift will be easier if you momentarily release the accelerator pedal. Apply a ... Do not attempt to shift to or from 4L while transmission is in gear or clutch is engaged. ... OK, now when you shift into 4WD it gets a little more complicated. .... I have a 97 RAM 1500 Club Cab Sport 4 X4 and I am having‎CAD operation - ‎CAD alternatives - ‎Hard Low range shift

    my 2001 ram will not engage into 4wd nor will 4 low. no light ...

    www.justanswer.com > Dodge

Feb 08, 2016 | Dodge Cars & Trucks

1 Answer

On my 1998 dodge the transfer case wont engage in any range why?


it sounds like a linkage problem ? first check fluid level in transfer case , then remove linkage and try to engage transfer case manually , if it does then there is a shifter problem if you can't and fluid level is OK then there is a internal problem and transfer case has to be removed for internal inspection, good luck.

Aug 15, 2014 | 1998 Dodge Ram 1500 4WD

1 Answer

2007 chevy trailblazer won't go into 4 wheel drive


Have you had codes checked ? While connected to a good scanner that will check transfer case switch to show if switch is working, and it could be the switch on the side of the transmission.

Feb 10, 2014 | Cars & Trucks

2 Answers

1995 dodge 3500 4wd wont engage have shifter on floor light wont come on or 4wd wont engage


Any time your dealing with a 4x4 system the best start is at you front axle. Its primarily a vacuum leak so check to see if the 2 vac lines are hooked up (its good to check the electric connections.). When your 4 wheel drive is engaged and the motors running you should have vacuum at one or both of thee lines depending on if your in 4 hi or low .
If no vacuum at axle check the Vacum switchs(the plug with 4 vac lines) on top of the transfer case it will have 2 feed lines(grey & green) they conect in to the into the vacum harness on back of motor (passanger side). A vacum schematic is normally located on the raditor core support (right under the hood next to hood release)
Hope this helps

Jan 20, 2010 | 1999 Dodge Ram 2500 4WD

1 Answer

2500 ram 5.9 wont engage back into 2wheel drive


Mine was stuck in 4low. What a nightmare as I was out camping and had to tow my 5th wheel back to town at 40mph. Dodge says it is a stuck switch. At the same time though my A/C stopped blowing cold air. Checked on a couple of Google posts and found that this is a known problem. Apparently theTIPM (Total Integrated Power Module)is the culpruit. Everything seems to run through this.

May 25, 2009 | 2006 Dodge Ram 2500

1 Answer

94 Sonoma 4x4 won;t lock into 4WD.


yea its not shifting again like before ? sounds like your transfer case solonoid has possably gone bad again .. these are a sometimes dont work item .. It is what shifts the transfer case into gear and it might be a little worn or weathered and not letting the switch kick it in gear all the way from the N position. thanks Jerry holler if you need more.

Feb 05, 2009 | 1994 GMC Sonoma

1 Answer

4 wheel drive engages itself after rain or snow


I had that problem last year. Dodge fixed it for $500.00 it was the "Transfer Case Motor". Rock Auto Online http://www.rockauto.com/catalog/raframecatalog.php has them for $140.00. 3 bolts, two plugs, 15mins. and your done. Wish I had known it would have saved me $360.00.

Jan 10, 2009 | 2004 Dodge Ram

1 Answer

01 dodge 1500 4x4 Transfer case / transmission problem


check the rear differential as well as the transfer case...you may have broken something in both of them...i have seen it happen...since 4low uses a different gear it is possible for it to move in low and not 4 high

Oct 24, 2008 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
1999 Dodge Ram Logo

1,986 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...