Question about 1995 Honda Accord

1 Answer

Key In Ignition Won't Move 2002 Chrysler Town & Country

3 months ago, same problem but after leaving it alone for about 15 minutes, it started up fine. It hasn't happened since, but here I am again, it won't move at all. The steering wheel moves a little left and right, so it isn't locked. I can't move the vehicle out of park, so it's where it's supposed to be. I have no idea and am getting ready to have it towed!!! HELP?!

Posted by on

  • ddatmf Jan 29, 2009

    I'm thinking ignition issue. It's working again, but I'm having it checked out before it happens again. The wheel turned all the way but with force. Thanks.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 21 Answers

The steering column sounds locked. Try turning the steering wheel all the way left or right till you hear it unlock or until the key can turn. Note; You must use force to unlock the steering column and don't be scared because it won't break anything.

Posted on Jan 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 town and country shuts off immediately after being started


Start at the ignition switch for losing power in run position. then look at run relay.

Jun 15, 2014 | 2002 Chrysler Town & Country

1 Answer

1998 dodgeram 1500 won,t start won,t turn over


check for power from the ignition in the start position to the starter relay/ solenoid terminal.

Jan 28, 2014 | 1997 Chrysler Town & Country

1 Answer

I have a 2002 Chrysler town and country. I just put in a new battery 3 weeks ago and they checked the alternator and said it was fine. Now it won't start. When you turn the key the radio and lights...


I hate to say this to you but make sure the engine is not locked up. If you can turn the engine, either by pulling on the belt, or by putting a wrench on the crankshaft bolt, try another starter. If you can't turn it, try another engine. (sorry for the insensitive attempt at humor)

Aug 17, 2011 | 2002 Chrysler Voyager

2 Answers

I have a 2000 Chrysler town and country. The steering wheel locked, and the key won't turn in the ignition. I have tried everything from jiggling the wheel and the key, to rocking the van back and forth....


I have a 2000 town and country and 10 month ago we had the same problem .you have to go to the dealer and change an ignition key lock switch.i think the part was about $100. and the labor (at my mechanic) $40.hope it was helpful

Sep 27, 2010 | 2000 Chrysler Town & Country

1 Answer

My chrysler 2002 town and country will not change gears. The RPMs stay at 2 or 3 when going 40 mph. What do I do?


I have the same vehicle, is your engine light on or flashing? Put your key in the ignition, turn back and forth 3 cycles of on off. End in the on position. If you have a 0700 code come up, your transmission is "done". Sounds like it is in "limp mode". Thats what happened to me. Had tranny overhauled, $1800.

Jan 21, 2010 | 2002 Chrysler Town & Country

1 Answer

2002 town and country...how do i find the trouble codes


Cycle the key three times. (turn from off to on)

Basically, it goes like this.

Insert key into ignition.
Turn forward to the 'on' position, the one just before cranking.
Turn back to off.
Turn forward to on again, and then back off.

Forward once more, and leave it there.

You should get a DTC (Diagnostic trouble code) that displays on the odometer.

If all is well, (or deemed well by the computer) you'll receive a message of 'done' instead of a PXXX (xxx=numbers) Code.

If you relay the code to me, I can help you further!

Nov 30, 2009 | 2002 Chrysler Town & Country

1 Answer

Describe your 2002 Chrysler Town &


Safety neutral switch o.k.? Tried moving shifter through all gears while holding key in start position?

Aug 03, 2009 | 2002 Chrysler Town & Country

1 Answer

Starting problem


My van is doing exactly the same thing. It will crank, then cut right off, after I try 3 times it doesn't do anything. After that it may not start for a couple of days, but if I leave it alone after the first or second try it may start back in an hour or so. It was fine for about 4 months, then just started back up. If you found a solution, please help me....

Nov 20, 2008 | 1999 Chrysler Town & Country

Not finding what you are looking for?
1995 Honda Accord Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...