An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: turn signal switch does not work
You need to Check Both fuse Boxes for the Flasher Relay. Check the one Inside the Car and the Fuse Relay Box under the Hood. It is a Relay (Small Black Square with 3 or 4 Prongs on Bottom) and will be in one of these Boxes. It should be Labeled "Flasher" I Believe.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
on gms the brakes are hot always to fuse from it to brake switch from it to turn/hazard switch if both brake and turn dont work replace turn signal switch and it is hard to do ,remove bottom steering cover then top cover you need special inverted touqix socket to remove top and regular touqix bit for bottom lower cover must be removed two screws hold switch on one on top other turn wheel and you will see at bottom on front of switch . follow wires to big plug under dash loosen bolt in center pull plug apart section for turn switch slides in remove then replace on column wires may be hooked fight loose and pull up through along top and out with wires push new down down same spot and replace every thing takes me about 1 to 1/2 hours to do some times less.
no do not replace steering column, i have worked on countless models of this. if turn signal lever or switch is breaking often, then the work is not being done right. they are hard to do correctly. but most likely the turn signal switch or the wiper switch is binding. replace both. but them new and not used. used parts for this usually bind also.
if you rigged up a seprate switch and it stoped woring all together it sounds like you need to replace the motor and the turn signal switch isnt that hard to do by yourself if your looking for cheap good luck and i hoped i helped