Question about 1993 Saturn SC2

1 Answer

93 sc2 stops after warmed up about 10miles

Had cam sensor replaced. ran tru two can of sea foam. The shoppe I take it to ran the computor on it nothing shows up as not working.

When you let the car cool it will restart. How ever the gages are not ready as the car is running hot.

colud it be a the coolent sensor.

sad saturn.

Posted by on

  • thomas thompson May 11, 2010

    may be the ing. module is going .check for spark at the plug when it shuts off



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Map sencer is going bad

Posted on Feb 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2010 Jeep Wrangler sport 3.8L engine constantly pings on acceleration or if there is any load on the engine. I think it has something to do with throttle body. Not sure what the issue is.

Try using a higher quality fuel use 93/91 and use the fuel for 2 tank fill's also add a bottle of sea-foam to the tank for the two times you filled with the higher quality fuel. Most likely it's the ethanol in the fuel slowly clogging you're injector's as well carbon build up. The sea-foam will help with this.

Oct 19, 2017 | Jeep Cars & Trucks

1 Answer

What would cause the engine to cut out miss when warm?

dirty injectors map senser if it has one water in the gas put a product called sea foam in it this stuff works clean water out and clean injectors both run 3 or 4 cans thruogh the car follow the instruction on the can

Sep 03, 2014 | Chevrolet Chevy Cars & Trucks

1 Answer

94 buick roadmaster stalls when stopping

Check for error codes (DTCs) - that will probably tell you what the problem is. After the engine warms up, the system goes into closed loop operation and depends on a number of sensors to adjust timing and fuel flow. If any of these sensors is malfunctioning, you will have this happening.

Apr 18, 2017 | Buick Roadmaster Cars & Trucks

1 Answer

I have a 93 blazer 4.3 i ran out of gas one day and nw have troulbe keeping it running?

Try a can of sea foam and change the fuel filter. You may have picked water or muck off the bottom of the tank.

Oct 14, 2010 | 1993 Chevrolet S-10 Blazer

2 Answers

93' Grand Cherokee, dont start, no spark,no gas preassure

my 1996 jeep grand cherokee lmtd. won't start did tune up. cranks but no fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith

Sep 10, 2009 | 1993 Jeep Grand Cherokee

2 Answers

Low idle when stopped

No there could be a number of reason, bad gas, pvc valve needs to be replaced, fuel filter plugging up, egr valve sensor needs to be replaced or the oxygen sensor . Best to have a diagnostic done before replacing a lot of expensive parts. Takes the guess work out .

Jul 28, 2009 | 2001 Ford Escape

1 Answer


The cylinders are numbered as on the spark pack you changed. You might have done better putting the seafoam in the tank as an injector cleaner. Not sure why you changed so many parts, you seem to know how to get the codes from test connector lead hookup and the blink pattern. You might also want to check the fuel rail pressure and the crank and cam angle sensors. Before replacing the injector, swap the #4 injector with the adjacent one and see it the code moves with the injector or stays put. If the code stays on #4, then check the injector wiring, if it moves clean or replace the injector.

Mar 16, 2009 | 1991 Subaru Legacy

3 Answers


Open the hood if it says efiohc or single cam on the valve cover then it is a sc1 if it says dohc or twin cam than it is an sc2

Jul 08, 2008 | 1993 Saturn SC2

Not finding what you are looking for?
1993 Saturn SC2 Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides