Question about 1997 Isuzu Rodeo

1 Answer

HOW TO REPLACE A POWERSTEERING BELT ON A 1997 ISUZU RODEO

HOW TO CHANGE A POWER STEERING BELT

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 2,100 Answers

If it is like a 94, the power steering belt is either middle or front, You might be able to sneak it past the fan, not sure, usually you have to take the fan off, Not the four bolts up front but the 3 bolts into the block holding the bracket. take the fan shroud out,2 srews/ bolts, and clips, getting the top radiator hose out of the way helps. Loosen the tension nut up front, and I believe you have a square hole for a half inch drive breaker bar, use it to move the pump left and right to loosen and tighten the belt. Then tighten the nut back up, put every back, you are all set. If the belt is in the middle, you have to take off the ac belt first. Loosen the tensioner on this belt, and wind it down, Then back up when you are done. Hope this helps.

Posted on Jan 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My belt tensioner pully is going bad. Today, I lost my power steering. Can the tensioner cause this?


If the belt came off/broken you will have no power steering. If the fluid is low/empty you will have no power steering.

Apr 12, 2015 | 2005 Dodge Neon SXT

1 Answer

Need to change power steering belt on 2003 Kia Rio


1st take and untighten the power steering bolt from the back it will be facing the drive side. now take and untighten the tension bolt be careful not to snap it. then get a 9/16 open end wench and put it on the power steering bolt form the front it is a tight to get to once you have it on push down on it and the belt will come off

Oct 21, 2012 | 2003 Kia Rio

1 Answer

How do you change a power steering belt


Loosen the bolts that attach the power steering pump to the bracket. then push the pump down. this should make the belt loose enough to get off. then put the new belt on. take a pry bar and stick between the motor and the power steering pump through the top. push on the pry bar to raise the power steering pump and tighten the belt. while pushing on the pry bar to keep tension on the belt tighten the bolts that you loosened and you've changed your power steering belt. this can be done by one person, but it's a lot easier with two.

Aug 24, 2011 | Dodge Stratus Cars & Trucks

1 Answer

Everytime i turn my steering wheel it sounds like something is wrong wit my power steering and there is fluid in there maybe tha belt?


Power steering pumps begin to make a loud whirring noise when you turn the wheel. As long as you have fluid and the power steering is working there is no damage occurring. But either gets worse it is time to change the power steering pump.
As for the belt if it is serpentine style. (Long and makes many turns) then the belt is fine. If it is the V-belt style (old style) only on 2-3 pulleys max then just make sure it feels snug.

Feb 19, 2011 | 2000 Chrysler LHS

1 Answer

Is it very difficult to change the power steering pump in a 2004 kia sedona?


  1. Remove the Power Steering belt.
  2. Disconnect the power steering hoses from the power steering pump. Take caution as there may be some pressure.
  3. Remove the bolts holding the Power Steering pump to the pump mount.
  4. Install the new Power Steering pump.
  5. Reconnect the power steering hoses.
  6. Reconnect the Power Steering belt.
  7. Top off with fluid.
  8. Start up the vehicle.
  9. Turn the wheel to the left.
  10. Top off with fluid.
  11. Turn the wheel all the way to the right.
  12. Top off with fluid.
  13. Repeat the last 4 steps until the fluid level doesn't change much, and is topped off.

Feb 18, 2011 | 2006 Kia Sedona

1 Answer

The power steering is out and I can hear a pulley going bonkers. There is a squealing sound like a belt isn't catching, and also an oscillating sound like a pulley is loose and moving back and forth or...


i am having a similar problem. my power steering pully is loose. im pretty sure i have to replace the pump and the pully however my power steering still works but the belt squeals.check all the pullys they drive the belt or belts. its usually always either the tensioner thats the pully that allows you to remove the drive belt or the power steering pully which sucks the most because you must remove the entire power steering pump to replace the pully and since you have to go through all that trouble you might as well replace the entire power steering pump as well. i am not a mechanic so try and find more information.

Jul 26, 2010 | 2002 Hyundai Accent

1 Answer

How do I change the serpentine belt on a 1998 Buick LeSabre, 3.8


My friend;
Try this;
  1. Check the belt pulley may have attaching tension bolts (Nuts), etc.
  2. Loose the belt pulley attaching tension bolts (Nuts), etc.
  3. Normally there are three bolts & or nuts u need to loose to allow u swivel the pulley side way.
  4. Once loose, swivel the pulley side way.
  5. Mostly, you don't have to remove the bolts & or nuts completely.
  6. You may need to remove other serpentine belt to reach the power steering belt.
  7. Removing those other belts work same as the power steering belts or other belts.
See those videos;
Playlist Results for How do I change the serpentine belt of power steering ?

http://www.youtube.com/results?search_query=How+do+I+change+the+serpentine+belt+of+power+steering+%3F&search_type=&aq=f

Try it, & PLZ; let me know if I add any benefits to you.
I hope I add some thing valuable to you.
Regards;

MAR;
soer2@yahoo.com

Nov 09, 2009 | 1998 Buick LeSabre

2 Answers

Change power steering pump


There is a dynamic tensioner roller, which you need to release before you remove the belt. See the manual, may be it can help you.
http://www.gigasize.com/get.php?d=y0xm4md7nwc

Oct 11, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
1997 Isuzu Rodeo Logo

794 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...