Question about 2008 Chrysler Aspen

1 Answer

Car shifts but won't move

I was driving on my dirt road and tried to accelerate, my RPM's went up but I remained in the place. This is the case with all gears. Check engine light is not one and fluids are full?????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 379 Answers

What it sounds like is your brakes are stuck on

Posted on Jan 21, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Will not move from 2nd gear help PLEASE?

Your transmission is in a "limp in" mode. There are 2 sensors that need replaced. Total cost should be less than $100. I had it happen to me on my 99 300m. The sensors limit the speed to about 25 mph and the RPM rev's high. Just get the sensors replaced.

Posted on Sep 20, 2009

Testimonial: "That explains it thank you."

canbruce75
  • 1776 Answers

SOURCE: my check engine light comes on and my car will not

This sounds like a problem with the throttle position sensor. Take the car to an autoparts store and have them scan the computer for fault codes stored. Most parts stores will do the scan for free. Getting the codes will narrow down the cause of the problem and should eliminate the need for speculation. Sorry for your trouble and I hope this helped. Best wishes.

Posted on Oct 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 Nissan Altima Stuck in First Gear


1. check transmission fluid level or if you can change the fluid & filter.
2. check throttle position sensor (tps).
3. if fluid level & tps are ok & still not upshifting automatically, temporarily (so you can take it to a transmission specialist) , try to manually shift. starting from dead stop, shift to D1. at about 25mph shift to D2. (be gentle on the accelerator & don't over rev on each gear. release accelerator pedal & don't step on the brakes while shifting from D1 & D2).

Apr 08, 2013 | 1995 Nissan Altima

1 Answer

2007 g6 v6, new tires and alignment didn't help. Pulls abruptly during acceleration, shifting, and while on cruise control .


Why Because you failed to explain what you wanted to be
resolved & most likely went to the wrong shop,They took your
money bur never even diagnosed anything you told them,happens!

What about motor mounts,transaxle mounts,cv axles,worn suspension
parts? Was all that checked?

Was the car road tested with you driving & then switch &
mechanic driving

Don't do that--- no fix--- they don't care

Nov 29, 2012 | 2007 Pontiac G6

1 Answer

My rpm rev's past 3 car stalls then shifts...sometimes won't shift


Due for a transaxle rebuild,common on that veh

The fact you continued to drive it when it won't
shift correctly & has been slipping, your done

Aug 30, 2012 | 1998 Plymouth Grand Voyager

1 Answer

Unable to take out of park position


Do the brake light work? No brake lights and it won't shift out of park. Check your fuses and check for loose wires. Check your brake light switch. If that has failed, you won't be able to get out of park. The other one if the shift lock solenoid which is in the shifter assembly. The brake shift interlock switch prevents the car being shifted from park unless the brake pedal is depressed. Try to apply power/ground to the proper wires & see if it will activate.. If it does, then the problem is between the brake light switch & that solenoid. Could be the wires or the switch.Make sure the shifter cable is still held down in place at the shifter assembly & under the hood. It is the interlock switch that you hear/feel clicking.It is for the prior generation but may still apply.

Good Luck and hopefully you soon will be on the road again...;-)

porsche parts

May 27, 2012 | 1995 Ford Aerostar

1 Answer

2008 Nissan Altima won't shift gears while driving


If the RPM's Flare, youv'e gone too long without
recognizing a trans that slips

It will have to come out & be rebuilt,most likely.

May 21, 2012 | 2008 Nissan Altima

1 Answer

Hi, I have a 1999 Mercury Villager with the 3.3 Litre Nissan motor. Just recently my cousin replaced the timing belt, and distributor. When we got the van back it was having transmission problems. When you...


I would start by making sure the Trans Fluid level is correct. If the level is good, it sounds like your internal pressures are leaking down, and that is why it slips out of gear. Which means you have internal trans issue which would require the trans to be most likely removed and repaired.

Thanks Jay!

Jul 09, 2011 | 1999 Nissan Quest

1 Answer

Isuzu rodeo, RPM's shot up, pulled over, Problem with the Isuzu Rodeo 2002 Rodeo isuzu rodeo, RPM's shot up, pulled over, placed in park then shifted to drive, car would not move, shut off, car...


Isuzu rodeo, RPM's shot up, pulled over, Problem with the Isuzu Rodeo 2002 Rodeo isuzu rodeo, RPM's shot up, pulled over, placed in park then shifted to drive, car would not move, shut off, car would not restart

Jul 09, 2011 | 2002 Isuzu Rodeo

1 Answer

DEFINITE LURCH IN 1ST AND 2ND GEAR,


This may apply. ...............................

Carry out the adaptation drive cycle road test:

Note: This process must be carried out in normal mode (not sports mode). On a flat road, the transmission fluid temperature must be above 60° C (140° f) and below 100° C (212° f) (vehicle at normal operating temperature will ensure that the transmission fluid temperature is above 60° C (140° f)).
9. Accelerate from rest with light throttle (do not exceed the upper rev limit in appendix 1). 1-2, 2-3, 3-4 shifts must occur with engine speed between the following limits:.
Note: Do not move the accelerator pedal during shifts.

• 3.0L VIN ALL 1800 - 2000 rpm
• 4.2L N/A Prior VIN M96321 1450 - 1600 rpm
• 4.2L N/A From VIN M963221550 - 1700 rpm

10. Continue to accelerate gently to 50 mph (80 km/h) so that transmission shifts into 5th gear.
11. Go into overrun and let the transmission shift down into 4th gear without braking.
12. Brake gently to a standstill and hold footbrake on for at least 15 seconds.
13. This process should be carried out at least five times.

Page 2 of 3 Bulletin Number S307-17
________________________________________________________________________________

Jan 17, 2011 | Jaguar S-Type Cars & Trucks

1 Answer

95 dodge dakota having hard time shifting.


Try a tranny service change a place that changes the filter the pan gasket and fluid not some of these quick places that just drain a couple quarts out of the tranny lines and thats it that wont help but a complete tranny service should help.

Jul 30, 2009 | 1995 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...