Question about 2003 Land Rover Freelander

1 Answer

Brake lights not works

O/s and n/s brake lights not works centre light working ok, all new bulbs.thanks.

Posted by on

  • ri4chlee Jan 27, 2009

    yes checked fuse. reverse lights work and so does centre breke light.



    Thanks

  • Richard Delahant May 11, 2010

    Did you check the fuse?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 21,949 Answers

Have you fitted the right bulbs ???check contacts on bottom of bulbs one or two pins.if appear ok then a wire has come out of a connector where loom separates to go to back lights,now where this is in the car?? just follow the two looms back from back lights,sorry i do beleave you call them pigs tails

Posted on Jan 28, 2009

1 Suggested Answer

rickyrt441
  • 4399 Answers

SOURCE: right and left brake lights not working...centre

I would say it is your break switch. It is located under the dash and the break pedal actually hits it. It look chrome and it is a round cylinder. It has a button on it. When you press the pedal down, the button releases, therfore, it turns on your break lights. If the fuse is ok and the bulbs aer ok, this is your problem. Thank you very much for choosing FixYa. Good evening.

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my passenger tail light is out except when braking or turn signal. Just the running light is out but same bulbs work when instructed to brake an signal ? Can someone help please ? Thanks


Ok, 2 different elements in the light bulb. One you have turn signals and brake. Being they do not have a separate yellow lens for the turn signals. Now the light it self is on another element. When you purchase a new one you if you look at it closely you will see both elements. Sounds like you need a new bulb.

Jan 22, 2015 | Cars & Trucks

3 Answers

2011 ford feista se brake light out on drivers side. Running light and blinker work. Have replaced bulb and socket with same results what do I do now?


Did you try the passenger side brake bulb in the driver side socket (maybe the new lamp is bad)??

If it works, then the problem is either a bad ground connection / wire at / between chassis and the shell of brake lamp socket, or bad 12 volt wire at / between the common passenger 12 volt brake light wire in the harness to the center contact on the brake lamp socket.

My suggestion is if the brake lamp wire is ONLY for brakes - not the directional too, simply add a new wire spliced into the passenger side brake light wire and extend it to the brake light wire closest to the new socket that you recently installed on the driver side. Disconnect the vehicle brake wire from the new socket and wire nut it off or tape it up (so it can't short out if it somehow becomes energized again) and splice this new wire to the new socket.

Test & you're done!

May 21, 2014 | 2011 Ford Fiesta

1 Answer

BRAKE LIGHTS DON'T WORK BRAKE SWICH CHANGED BULBS CHECKED AND INSIDE FUSES OK


Do turn signals work ok? Do you have current at the brake switch?

Feb 07, 2014 | 1999 GMC Suburban

1 Answer

Rear brake lights not working


break switch above the break are needs to be replaced i think

Nov 21, 2013 | 2003 Ford Mondeo

1 Answer

2000 MAZDA 626 BRAKE LIGHT NOT ON


First check for blown fuse. If Ok check bulb, If ok use test light (computer safe led type)
Get someone to put on brake and earth test light lead to bold on vehicle and hold test light probe in centre of bulb holder. It should light up.
If not move earth lead to another bolt on vehcile and retest.
If light comes on in test light the bulb is broken.
If no light in test light the brake light switch connected to the brake pedal is broken. replace brake light switch.

Jun 12, 2011 | Mazda 626 Cars & Trucks

1 Answer

Right and left brake lights not working...centre light is fine....bulbs look ok any other fault to check?


I would say it is your break switch. It is located under the dash and the break pedal actually hits it. It look chrome and it is a round cylinder. It has a button on it. When you press the pedal down, the button releases, therfore, it turns on your break lights. If the fuse is ok and the bulbs aer ok, this is your problem. Thank you very much for choosing FixYa. Good evening.

Feb 19, 2011 | 2004 Mazda MX-5 Miata

1 Answer

Brake lights not working but centre mount is!!


the problem is most likely in the turn signal switch. the power for the left and right brake lights goes through the turn signal switch, but power for the center mount comes straight from the brake light switch. this allows the brake light to be turned of so the turn signal can operate as they use the same filimant in the bulb.

Jun 04, 2009 | 2000 Ford Focus

1 Answer

Left rear brake light stopped working but bulb and fuses are OK.


These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks!

Feb 05, 2009 | 1999 Ford Expedition

Not finding what you are looking for?
2003 Land Rover Freelander Logo

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...