Question about Cars & Trucks
How to change head gasket
Purchase a Chilton repair manual for the year and make of your vehicle, or other repair manual from autozone or autoparts stores.
These will walk you through the steps necessary to replace head gasket.
Posted on Jan 21, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The egr valve has two sensors. One is an EGR position sensor which is physically attached to the EGR valve. The other sensor is the DPFE (Delta Pressure Feedback EGR) sensor, commonly called the EGR pressure sensor. It's location varies depending on the engine you have. You can fine this sensor by following the vacuum hose on the EGR valve. It will be with in inches of the EGR valve. The sensor will be black (plastic) or silver (metal), have two or three vacuum ports and an electrical connection on it.
The vacuum pressure sensor is a high failure item on fords. Any Ford parts department will have one in stock, as well as some aftermarket parts stores.
The new sensor may not look exactly the same as the old part, but will have all the hook ups as the old one. You may also need to replace the vacuum hose to the sensor as well
Posted on Feb 25, 2009
Sounds like your clutch is not releasing enough to allow you to engage or disengage. It is dragging which causes hard engagement and disengagement. Possible causes are, Low fluid in the master cylinder to the clutch, or bad slave cylinder down by the bell housing, or badly worn pressure plate, or air in the line leading to the slave cylinder. You will need to eliminate these items one by one by testing to find the bad item in the system. Good luck
Posted on Apr 14, 2009
looks like there is special sequence to reassemble and tightening, a quick note replace any bolts that have two punch marks.tighten as follows: x x x x x 10 4 2 6 8 x x x x x 7 5 1 3 9 torque all down to 15 ft lbs torque to 30 ft lbs plus 90 degrees. Good luck!
Posted on Sep 18, 2009
The light (on the key switch) that indicates whether the passenger airbag is on or off is, more than likely, burned out. You can either replace the whole switch ($$$) or you can take it apart and solder a new led into the circuit board. You can get the bulb at radio shack (make sure it is 12v). Good Luck!
Posted on Nov 17, 2009
Tips for a great answer:
Nov 02, 2015 | 2006 Ford Ranger 2.5
Mar 29, 2015 | Ford Ranger Cars & Trucks
Mar 20, 2013 | 1989 Ford Ranger
Oct 24, 2010 | 2001 Ford Ranger Regular Cab
Aug 04, 2010 | 2000 Ford Ranger SuperCab
Oct 24, 2009 | 2002 Ford Ranger Regular Cab
Jan 18, 2009 | 1986 Ford Ranger 2WD
Jul 18, 2008 | 1986 Ford Ranger 2WD
55 people viewed this question
Usually answered in minutes!