Question about 2006 Buick Rendezvous

Open Question

Change alternator on 2006 buick rendezvous front wheel drive

3.5lt

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2002 Buick Rendezvous alternator removal

To get the alternator out, I had to move that large electical fuse / relay box out of the way,and remove washer bottle and battery. then use a 3/8" drive ratchet to move the tensioner forward to get the belt off. I used a small mirrow to get a view of the back bolts on the alternator and removed them.[ I used meteric # 15 open end & closed end combo wench. Keep turning the back bolts until the alternator become loose.]

Posted on Jul 04, 2009

Ad
c17hydro
  • 2984 Answers

SOURCE: How to change the fuel filter in fuel tank 2006

3.4L & 3.5L Engines

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
    • Fuel filter mounting bracket nut
    • Fuel filter and drain any remaining fuel

61788c9.gif
The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:
  1. Install or connect the following:
    • Fuel filter to the bracket
    • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
    • Inlet/outlet quick connectors to the fuel filter
    • Negative battery cable
  2. Start the vehicle and checks for leaks, repair if necessary.

Posted on Oct 11, 2009

Testimonial: "Thank you for your reply, but my car is not the fuel filter in the fuel line underneath the body."

  • 491 Answers

SOURCE: I want to change the battery in 2006 Buick

On most cars after 2000 it is recommended to keep a minimum of 9 volts in the system when disconnecting the battery.
You can buy a 9 volt battery unit to plug into your lighter socket.
Otherwise....if you have a battery charger....attach it to the alternator output and put it on its lowest setting....that should keep voltage in the numerous memory circuits while you change the battery.

When changing the battery.....(removing voltage from the system) it's a 50% chance of putting the radio into theft mode.
The codes to take it out of theft mode are available online.....just google.

Posted on Oct 29, 2009

  • 31 Answers

SOURCE: 2006 Buick Rendezvous cxl broken rear hatch strap!

I believe there is a recall for that feature. but i am not 100% sure. it was recalled on 2004 rendezvous

Posted on Feb 07, 2010

Tooldude1969
  • 106 Answers

SOURCE: how to change regulator motor on a 2003 buick

from Ehow.com. Long answer
All Buick automobiles now have powered windows for both front and back doors. These powered windows use a motor attached to a continuous screw that lifts and lowers a lattice device for opening and closing the window. Each window also has a window regulator to tell the motor when to stop both lowering the window and raising it into place. Occasionally, this regulator will become faulty and need to be replaced. Although not a difficult procedure, it does mean having to disassemble the Buick's door.
jQuery('.intro .thumbnail').each(function(i,e){ jQuery(e).find('img').one('error',function(){ jQuery(e).remove(); }); });

    Door Armrest
  1. The first thing to do is remove the Buick's armrest on the door. Underneath the armrest, hidden from view, are large screws that go all the way into the doorframe. Remove all of these screws and the armrest will come free. Once it's loose, carefully disconnect all the wires to the remote control switches. The driver door armrest will have more wires than the other doors. Door Panel
  2. Once you've removed the armrest, you can take off the inside door panel. Start by going all the way around the door's edges and removing all the fasteners. Once you've removed these may find some clips holding the panel tight, depending on your model Buick. Carefully unfasten these and then work the door panel up off its guide at the top of the door next to the window opening and around the car door handle. If your Buick has a door-mounted nightlight, disconnect the wires to the accessory. This will give you access to the door's interior. Removing the Old Regulator
  3. Inside the door there are two components with electrical wires: the motor and the regulator. The motor is attached to a long threaded bolt. Remove the wires connected to the regulator and then the screws mounting the regulator to the doorframe. Be careful not to scratch the window with the screwdriver when working in these close quarters. Once the regulator is free inside the door, lift it out of the door. Installing the New Regulator
  4. Installation is just doing the removal procedure in reverse: put the regulator in the door, secure it, connect the wires (no need to solder; the wires are connected with tabs), and reattach the door panel, the switch wiring and the arm rest.

    It should take no longer than an hour to complete this project. One quick warning, however---never force or strain any part to remove it. If a component does not come free easily, then check again for an extra screw or retaining clip. Don't get frustrated and break something that ends up being more expensive than the cost of the new regulator!


Read more: Best Way - Buick Window Regulator Installation Instructions | eHow.com http://www.ehow.com/way_6510604_buick-window-regulator-installation-instructions.html#ixzz0uQJxAMM2

Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the versa track awd located at in a 2002 Buick Rendezvous all wheel drive


the versa trac awd is located under your vehicle.. it is not one part.. it is many parts that all work together to turn all 4 wheels..it starts at the front wheels and runs all the way back.

Sep 22, 2014 | 2002 Buick Rendezvous

1 Answer

Cigarette lighter fuse


check under the steering wheel in the glove box or open either front door and check the ends of the dash

Dec 29, 2009 | 2006 Buick Rendezvous

1 Answer

Does the car 2006 Buick Rendezvous towing hook?


If your asking if it came standard with towing hooks the answer is no. Although there may be Dealerships that would add them if a customer asked. It would undoubtedly be expensive.
If you are asking whether you can add them the answer is maybe.
According to the link I included. Towing hooks are not available. However if you are willing to spend the money there are options available but it will mean modifications to your SUV. It will also mean money out your pocket. You may be able to have added supports underneath and attach tow hooks there.
Personally I think a wrap around brush guard with tow hooks and trail lights is just what the mechanic ordered.
Hope this helped and good luck.

http://www.web2carz.com/buick/rendezvous/2006/front-wheel-drive-cxl/USB70BUS011B0

Dec 21, 2009 | 2006 Buick Rendezvous

1 Answer

2004 Buick Rendezvous 6 cyl Front Wheel Drive speed and rpm issue


you have a connection problem going to your intrument cluster unless your real handy working on auto`s better take it to a mechnic

Oct 25, 2009 | 2004 Buick Rendezvous

1 Answer

Constant Vibration


Well, you may need a front end alignment for one. Two, who replaced the halfshaft?

Mar 16, 2009 | 2006 Buick Rendezvous

1 Answer

Can my 2005 Buick Rendezvous be towed by a motor home


If it has an automatic transmission it isnt the best thing to do.The transmission pump wont suply lube to parts that need it and stand a real good chace of causeing damage due to the lack of lubrication.

Mar 04, 2009 | 2003 Buick Rendezvous

2 Answers

My anti-lock brakes keep kicking on when i was driving last night then the light turned on and the awd disable light when on.


are awd light came on a few day ago...no change in the driving behavior. just had two wheel bearings replace last year. any idea what the awd disable light means now?

Thanks,
jim

Jul 31, 2008 | 2003 Buick Rendezvous

Not finding what you are looking for?
2006 Buick Rendezvous Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...