Question about Cars & Trucks

Open Question

Replace rear wiper arm toyota auris - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mastatech
  • 478 Answers

SOURCE: Removing 2004 Lexus RX330 Rear Wiper Arm

Use liquid wrench it will free up the corrosion, its the best, in every mechanics tools.

Posted on Mar 28, 2009

Ad
polarcycle
  • 1392 Answers

SOURCE: How to remove rear wiper arm

Remove the nut holding the arm. Should be able to lift up on the arm and loosen the joint at the motor.

Posted on May 30, 2009

  • 333 Answers

SOURCE: how to replace the wiper insert at the back of

moz-screenshot.jpg

  1. REMOVE RR WIPER BLADE
    1. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound. NOTE: Be careful not to break the claw.
    2. Pull straight the rear wiper blade to vehicle's left from the wiper arm. NOTE: Do not fold the rear wiper arm with the rear wiper blade removed from it.1722d05.gif

  1. REMOVE REAR WIPER RUBBER
    1. Place the rear wiper with the rear end of the rubber protruded from the blade stopper as shown in the illustration. NOTE: Do not pull out the wiper rubber forcibly, as the backing plates will become deformed or the blade claws will become damaged. HINT: The rubber can be easily pulled out by pushing the middle area of the blade.
f54b10a.gif
  1. INSTALL REAR WIPER RUBBER
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber. NOTE: Be careful to observe and keep direction of curvature for correct replacement.
0dd144d.gif
b. Insert the rear wiper rubber from the claw of the middle of the rear wiper blade into the rear end position.
8f40009.gif
c. After passing the rear wiper rubber through the rear end side claw, protrude it from the rear end stopper and pass it through the front tip side claw.

Posted on Sep 12, 2009

  • 85 Answers

SOURCE: How do I replace the rear wiper arm on a 2008 Kia Sedona

Your wiper arm has an interference fit which means it is essentially pressed on. The best way to remove it is to buy a wiper arm puller, which will have two arms that fit underneath the arm and a bolt that will push on the wiper post, they are pretty slick it should pop right off. Any auto parts store should be able to furnish you with the tool. If you're not going to use it alot, you might call your dealership (or friend with lots of tools) and see if they will pop it off for you.

Posted on Dec 07, 2009

  • 151 Answers

SOURCE: Can't remove rear wiper to replace on 96 caravan

Lift wiper arm from rear window. then release latch that holds the blade to the wiper arm.( It's small tab)

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rimove the rear bezel from toyota auris


Need more information! Not sure what you mean by bezel?

Feb 04, 2014 | 2007 Toyota Auris 1.6

1 Answer

Removing rear windshield wiper arm on 94 4Runner


on the wiper arm, there is a cap. remove cap and there is a nut underneath, remove nut spray wd40 oil on the threads that are exposed, then slowly wiggle arm and pull simultaneously to remove.

Jun 11, 2010 | 1994 Toyota 4Runner

1 Answer

How to remove windshield wiper arms on a 2008 toyota highlander


Front are standard clipon 26 inch and 20 inch. rear needs to be replaced by dealer.

May 20, 2010 | 2008 Toyota Highlander

1 Answer

How do you replace the rear windshield wiper blade? I bought a 13" wiper blade but I couldn't figure out how to change it.


like most hatchbacks, you hafta replace the whole rear wiper arm assembly. Go to a Toyota dealers' parts counter.

Jan 16, 2010 | 2005 Scion xA

1 Answer

How do I take a wiper arm of off the rear window of a Toyota celi


this either has a nut on the base of the arm that needs to be removed or if no nut. then pull the arm away from the glass and there will be a meatal tab at the base of the arm that will slide to the side with this slid to the side the wiper arm is unlocked and will pop right off

Jan 12, 2010 | 1984 Toyota Celica

1 Answer

How to replace the wiper insert at the back of


moz-screenshot.jpg
  1. REMOVE RR WIPER BLADE
    1. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound. NOTE: Be careful not to break the claw.
    2. Pull straight the rear wiper blade to vehicle's left from the wiper arm. NOTE: Do not fold the rear wiper arm with the rear wiper blade removed from it.1722d05.gif

  1. REMOVE REAR WIPER RUBBER
    1. Place the rear wiper with the rear end of the rubber protruded from the blade stopper as shown in the illustration. NOTE: Do not pull out the wiper rubber forcibly, as the backing plates will become deformed or the blade claws will become damaged. HINT: The rubber can be easily pulled out by pushing the middle area of the blade.
f54b10a.gif
  1. INSTALL REAR WIPER RUBBER
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber. NOTE: Be careful to observe and keep direction of curvature for correct replacement.
0dd144d.gif
b. Insert the rear wiper rubber from the claw of the middle of the rear wiper blade into the rear end position.
8f40009.gif
c. After passing the rear wiper rubber through the rear end side claw, protrude it from the rear end stopper and pass it through the front tip side claw.

Sep 12, 2009 | 2005 Toyota Matrix

1 Answer

Replace rear wiper 2007 RAV-4?????


Slide a small screwdriver under the tab in the middle of the blade and the arm, while pressing the tab in, pull blade away from the arm, this may need some extra wiggle. Remember you dont want it to fall off when driving..

May 07, 2009 | 2007 Toyota RAV4

3 Answers

Replace rear windshield wiper


I took it to a mechanis, who is a friend of mine. Toyota made that rear windshield wiper custom. So he took off the stopper and the screw in lock and I bought a 13" blade and we put the attachment on that came wih the wiper and slid it on to the arm.

Feb 11, 2009 | 1997 Toyota 4Runner

1 Answer

Rear windshield wiper


remove the cover cap that is by the base of the wiper arm. you can do this by just pulling off with your fingers. The wiper arm is attached with a 10mm nut. remove th nut and the wiper arm will slip off. When re-assembling, be certain to wipe all parts with a long lasting lubricant, like WD40.

Jan 13, 2009 | 2006 Toyota RAV4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...