Question about 1998 Chevrolet Malibu
I need to know what size of freeze plug i have to buy so i get the rite one
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 98 chevy malibu:engine wont turn
Check with a battery tester if you have power at the starter, Are the Battery post clean, Are any fuses blown in the fuse Box, check for any corrision.
Posted on Aug 13, 2009
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Posted on Dec 01, 2009
Testimonial: "just what I needed, thank you so much."
1) Drain all coolant from the engine/radiator.
2) Drill a hole in the old plug to allow you to thread a lag bolt, which will then be used to pull the old plug out. Or use whatever means you can to remove the old freeze plug.
3) Thoroughly clean the hole with a wire brush attached to a drill motor.
4) Apply sealant to new freeze plug and locate into the hole.
5) Tamp the plug into the hole, flush with the block, with a hammer.
6) Refill radiator with coolant.
7) Check for leaks.
This isn't going to be easy with the engine in the car, but it can be done.
Posted on Dec 17, 2009
Tips for a great answer:
Nov 02, 2013 | 2003 Chevrolet Malibu
Apr 10, 2013 | 1998 Chevrolet Malibu
Dec 12, 2010 | 1998 Chevrolet Malibu
Aug 14, 2010 | 1998 Chevrolet Malibu
Dec 27, 2009 | 2001 Chevrolet Malibu
Oct 07, 2008 | 1998 Chevrolet Malibu
Aug 12, 2008 | 1984 Chevrolet Camaro
18 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: