Question about 2004 Ford Expedition

Open Question

2004 brake fluid level sensor

My Low Brake Fluid light/warning goes on and off. Level is fine, tried jumping across the pins at the reservoir but no change

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: brake level fluid low waringing keeps coming on

If you have to add brake fluid theres something wrong, you might have a fluid leak at one of your wheels, or a line, the master cylinder or you might need to have your brakes replaced, when your pads were down this pushes the piston in the brake caliper out causing the fluid in the brake reservoir to drop

Posted on Nov 21, 2008

  • 72 Answers

SOURCE: 2000 ford focus se wagon, brake light on dash comes and

does it have spongey petal ? if so it needs to be bled. check the emerg brake switch it can cause that light to come on.

Posted on Aug 04, 2009

  • 548 Answers

SOURCE: brake fluid low warning came on in 2004 Ford

Whoa, there is a line marked on the fluid reservoir that you do not fill above. Be careful to make sure that you don't get dust/debris inside the reservoir. The owners manual and the reservoir have markings to tell you what type of fluid should be used.

Posted on Sep 21, 2010

jturcotte
  • 8195 Answers

SOURCE: lowlevel brake fluid light comes on.-brake fluid

Try disconnecting the connector from the reservoir. Test the circuit by shorting the terminals in the connector. If putting a shorting pin (paper clip ok) in and out between the 2 terminals makes the light go off and on, the circuit is working, and the switch is bad. If the light stays on even with the connector off, there is a short in the wiring.

Posted on Sep 24, 2010

  • 289 Answers

SOURCE: brake fluid low level indicator comes on -- when

If you recently had a brake job done, they were not properly bled.
Air in the brake curcuit would cause this situation. If the brake feels spongey, it IS air. Have it rebled.

Posted on Sep 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The brake light on my dash stays on, on my 2006 dodge charger


replace the brake light sensor manual will state where it is located

Jan 02, 2017 | Dodge Cars & Trucks

1 Answer

IP Brake light has come on in my 2004 Kia Sorento.. what does this mean?


Kia Sorento parking brake or brake fluid dash warning light - this light is illuminated when the park brake is applied, the warning light should go out when the parking brake is released. If the light does not go out it indicates that the brake fluid level in the reservoir is low and you need to pull over and top up at your first opportunity.

1-check parking brakes not applied
2-check brake fluid
3-if it is too low have the brakes checked they might be wearing out it doesn't mean you have a leak but when the brakes wear out the become thin causing the caliber piston to push out more lowering the oil level in the reservoir

Nov 01, 2013 | Cars & Trucks

1 Answer

2006 Tacoma faulty Brake indicator light


Please note that the hand brake is NOT the only reason that this light will remain on. It is possible that the light is trying to warn you of an hydraulic failure in your brake system.

Check your brake fluid level to make sure the fluid level is not low. If you find that it IS low, you need to investigate to find out WHY it is low. You shoud never have to add fluid to your brake system reservoir. If it is low, there is a reason for it that needs to be repaired.
If the fluid level is not low and you are certain that the hand brake is fully released, then you could have a bad hand brake switch, a defective fluid level sensor, or shorted/damaged wiring.

Oct 23, 2011 | 2006 Toyota Tacoma

1 Answer

How do i fix or replace the break light inside my dash. It stays on even when there is nothing wrong with my breaks


Hi,
The brake light is a warning that your fluid level is low. Check the brake fluid reservoir if the fluid is in minimum level. If the level is okay and it is full, the problem would be float sensor in the reservoir.
Please check the connector of the float sensor if it is connected and try to clean the metal pins( might be full of dirt and grease ).
The float might be stuck to "low" thats why the brake light up( move the float up and down to free it ).
Hope that helps you out.
Thank you for using FixYa!

Jun 30, 2011 | 2002 Mitsubishi Diamante

2 Answers

My antilock brake system stopped working and my emergancy brake light is on even though the brake is down. the fluid is fine.


If the parking brake switch is not stuck and the fluid level is OK, try tapping on the fluid reservoir to see if the light flickers or goes off. (you need 2 people to do this) If it flickers or goes off then replace your fluid level sensor. (You may have to buy a complete reservoir or master cylinder depending on your car ) If this does not provide any results, then you may have an internal leak in your master cylinder or Antolock Hydraulic Control Module causing the Proportioning Sensor Switch to turn the light on. At this point. I would tow it to a shop and have the Antilock Control Module scanned to see why it has turned the light on and disabled your Antilock Brake System. I do not recommend driving the car at all until the RED brake warning lamp problem has been resolved. It is OK to operate the vehicle (cautiously) with the YELLOW Antilock brake lamp on.

Jan 16, 2011 | Pontiac Sunfire Cars & Trucks

1 Answer

(I)(P)Brake light on


hi from the uk this warning light has two functions 1st it comes on when park brake is on then goes off as p/brake released the other function of this light being on ? is a warning that the brake fluid level in the reservoir is low the sensor is on the fill cap however! low level may be a fliud leak ? orsimply the level has dropped over time due to as the brake pads and rear shoes wear down then the fluid displaces from reservoir and compesates for the wear and fluid keeps the w/cylinders always topped up automatically may i suggest you check your b/pads and shoes are not too low for safety if so then renew asap also make sure there is no sign of fluid leaking on brakes especially the rear cyl's and actual b/pipes hope this helps?

Mar 09, 2010 | 2003 Hyundai Accent

1 Answer

Brake light comes on dash when brakeing then off with acceleration


hi 1st thing to check is the brake fluid level is topped up as the reservoir has a sensor fitted to cap so as brake pads/shoes wear the fluid is displaced from reservoir to compensate cylinders hence fluid level falls and puts light on as you brake ? also possibility is that your pads may be fitted with low brake pads warning indicators/wires which also puts same light on as you brake and goes off when you let off to accelerate ? check both of these possibilities if you req more help/advice by all means come back with info

Feb 23, 2010 | 1999 Dodge Caravan

1 Answer

The parking brake light is on and the parking


hi from uk if as you say the brake fluid level is slightly above min ? then this is most probably the reason the warning light is on this light is also linked to both park brake when on and a visual warning via a sensor on the reservoir that brake fluid is low top reservoir up ? light should/will go off however! fluid level drops for two reasons = 1 fluid leak on b/system 2 or in your case the fluid level has dropped by displacement from reservoir to brake calipers/cylinders as the brake pads and/or shoes wear down to minimum safe thickness ? and if your car has brake pads wear indicators fitted to pads these sensors will put light on SO may i suggest you check your brake pads/shoes ASAP because if pads/shoes are very low ? you may not only damage the more expensive disc/rotors but pads may/will burn up resulting in brake failure with obvious results ? hope you heed this advice? it is for your safety and other drivers best wishes

Dec 29, 2009 | 2001 Kia Rio

4 Answers

Brake light on dash stays on but sometimes goes off when cornering. Whats wrong


Check your brake fluid level. If the level is low, it will cause this. Also- if the level is significantly low, have your brakes checked, or check them yourself. When brake pads or shoes wear down, the level of fluid in the reservoir will drop accordingly with it.

Nov 13, 2009 | 2004 Suzuki Aerio

Not finding what you are looking for?
2004 Ford Expedition Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...