Question about 1995 Geo Tracker

1 Answer

How to replace heater blower switch on a 95 geo tracker

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Geo Master
  • 20,706 Answers

The whole truth, even better than alldata dot com.

http://www.fixkick.com/AirCond/heater.html

Posted on Oct 05, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 599 Answers

SOURCE: 1990 GEO trakcer window regulator

interior door panel is removed...window glass is removed from regulator...regulator (criss cross scissors shaped) with bolts or rivets holding it in place in window frame is removed....motor is removed from regulator if it is power window......reverse procedure with replacement with exception of bolts needing to replace rivets usually when DYI...good luck and hope that gives you a general picture of the job, which is rated at 1.5 hrs in the book for a pro to do

Posted on Dec 04, 2008

chiquititas
  • 1010 Answers

SOURCE: HOW DO YOU REMOVE THE RADIO FROM A 1995 GEO TRACKER????????

To remove the radio:
Remove the ashtray by raising the armrest cover and removing the two screws at the rear of the ashtray. Slide the ashtray back and then lift it out. Be careful of the two front tabs, as you don't want to break them.
Reach below the wood console, where the ashtray front tabs were inserted. Loosen and remove the two wing nuts.
With a small, long flat bladed screwdriver, pry out the leather shifter surround. The leather shifter surround has a center chrome retaining ring, the leather surround, and then finally a black plastic surround. The chrome retaining ring has 3-4 tabs which are locked in below the leather surround. It depends on the year of the Jaguar. Probably the 95 has three, but maybe four. They should be at the front and rear of the trim piece (2 front and 1 back, or 2 front and two back) but I've seen then on the sides. The point is, you have to be careful with the screwdriver and find the tabs. The screwdriver should be slid between the leather and the retainer. Pull upwards on the retainer gently, and as you loosen the tabs, it will come out.
Remove the leather surround. Once the chrome retainer has been removed, it should be easy to work it out of the console.
Loosen the black trim ring gently as it has tabs as well, but they are visible once the leather trim has been removed. Lift it upwards out of the wood trim and pull it to the side out of the way. You don't need to disconnect the wires, just lay the black trim to the side.
Lift the rear of the wood console trim and gently, gently slide it back and up. It will try to hang on the leather console, and can be difficult. Patience is important, as the walnut on the ski slope cracks easy (really easy).
Once the wood console trim (ski slope) is removed, you should have a row of screws up the side of the center control panel, where the radio and AC controls are. There are four to six on each side, depending on what Jaguar used at the time, as the 95 cars mechanically are somewhat of a blend of the XJ40 and the XJ300. Remove these screws, and note any spacers that were behind them. These spacers get lost quickly, and cause the ski slope to sit awkwardly on the console.
The radio will slide forwards once these screws are removed. Remove the radio harness and the antenna lead. As the books say, assembly is reverse of removal.
Good luck, and let me know if you have questions. If you are replacing the radio, let me know as I have the harness wiring codes and can help you with that as well.

Posted on Jul 01, 2008

  • 2 Answers

SOURCE: reset check engine light on 1995 geo tracker

I had the very same problem with my 94 tracker and it turned out to be something simple. My check engine light had popped on after it had hit 100,000. I went through all of the suggestions that people had suggested (unplug battery......etc) and still to no avail. Searching the internet, I came across a website called suzukiforum.com and there, this guy was able to help me with my problem. It turned out to be a maintenance switch that kicks on every 50,000 miles. This switch is like a secret that the auto manufactures use to ploy owners of their cars to bring to the dealer and then rack up the dollars in unnecessary "repairs". The switch is located under the dash and can be hidden anywhere. From the assistance of the guy on the forum, he was able to send me photos of this damn switch and possible locations where it may be mounted. I found mine in about 5 minutes, where it was attached to the steering column. It's a tiny switch, that you slide up or down, depending on what position it is in upon finding it. If it's up, then slide it in the down position and visa versa. Once you do this, the check engine light will go off. Make sure you do not have the car running and you can even unhook one of the battery posts, just to make sure you don't hit anything while rooting around under the dash. Good luck!

Posted on Apr 30, 2009

tbirdfan1
  • 3051 Answers

SOURCE: My 1995 Geo Tracker heater blower dont run,need to

Hello there the heater blower is located under the hood on the firewall on the passenger side you will see a round motor looking item there this is your motor and blower now if you have checked the fuses for this than make sure that the wires that this motor is connected to are all in good condition if so than yes replace the blower motor
ok best regards michael

Posted on Dec 04, 2009

Testimonial: "Thank you"

roniecon
  • 6918 Answers

SOURCE: 95 Geo Tracker - Automatic. Starts ok, but when

It needs a fluid change,and filter,in the transmission,also,add a additive called LUBEGUARD from napa auto parts,when you ask for the additive,be sure to get the one for gm,this additive keeps the valve body slick,and moving,this is the problem,your filter,and ,or,the fluid is dirty,and causing hydraulic problems,and valves to stick in the valve body in the transmission.

Posted on Mar 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What wires do I touch together to start a 95 Geo Tracker ignition switch going out


well there are 2 wires, like seen on "THE TERMINATOR"
one is ignition, and other is cranking.
its covered here , under how to do the hot wire. tests.
of starter. (we use a tool called a remote button)
http://www.fixkick.com/nocrank.html

the wiring is here.
page 1
see the center switch here, this is IGN
black-blue power feed, must go hot.

http://www.fixkick.com/power-elect/95%20electrics/95powersistra1.pdf


the new switch is here.
you will need new antitheft bolts,(or switch to generic)


http://www.rockauto.com/en/catalog/geo,1995,tracker,1.6l+l4,1142266,electrical-switch+&+relay,ignition+starter+switch,4700

May 21, 2016 | Geo Cars & Trucks

1 Answer

Changing a clutch in a 95 geo tracker


there are in fact 2 disks, one for 8v and one for 16v 95hp.
its all here, every step.
click clutch

http://www.fixkick.com/PULL-PAGE.html

Dec 16, 2012 | 1995 Geo Tracker

1 Answer

How do i replace heater blower switch in 92 geo


You may want to get the part from a junk yard. Get a chiltons manual for your year and make. It will have step by step in there.

Jan 14, 2011 | 1992 Geo Tracker

1 Answer

95 geo tracker, radio locked


get cpy of your title, remove radio, call dealer, and they give u unlock code for free

May 14, 2010 | 1995 Geo Tracker

1 Answer

Where is the heater blower on a 1995 Geo Tracker,Mine isnt blowing and I need some suggestions


( lower right pass firewall) Blower motor resistor

Blower motor : Behind RH Side of I/P

Dec 04, 2009 | 1995 Geo Tracker

1 Answer

My 1995 Geo Tracker heater blower dont run,need to know where its located and any suggestions would be appreciated


Hello there the heater blower is located under the hood on the firewall on the passenger side you will see a round motor looking item there this is your motor and blower now if you have checked the fuses for this than make sure that the wires that this motor is connected to are all in good condition if so than yes replace the blower motor
ok best regards michael

Dec 04, 2009 | 1995 Geo Tracker

1 Answer

94 & 95 Geo Tracker obd1 cable


you need the same brand cable.

Apr 03, 2009 | 1995 Geo Tracker

1 Answer

95 GEO Tracker stop running


hi there, your problem may lie within the fuel pump relay heating up and cutting out on you

Aug 28, 2008 | 1995 Geo Tracker

Not finding what you are looking for?
1995 Geo Tracker Logo

Related Topics:

876 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...