Question about 2006 Jeep Commander

1 Answer

Where is the thermostat in a 2006 jeep commander

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Passionate:

    Visited the website for 10 consecutive days.

    Habit-Forming:

    Visited the website for 3 consecutive days.

  • Expert
  • 73 Answers

Google will show u a diagram where is exactly located..picture of the piece and vehicle.

Posted on Mar 16, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

greg_margo
  • 1959 Answers

SOURCE: Jeep Commander Rear Brake Pad Installation

Per Chilton Auto repair manual:

Removal & Installation

  1. Raise and safely support the vehicle.
  2. Remove the rear wheel.
  3. Siphon a small amount of brake fluid from the master cylinder reservoir.
  4. Insert a small prybar through the caliper opening and pry the caliper cover (using the outboard brake pad) to bottom the piston in the caliper bore.
  5. Remove the caliper slide bolts.
  6. Remove the caliper from the anchor.

    WARNING Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
  7. Remove the brake pads from the caliper.
To install:
  1. Install the brake pads onto the caliper.
  2. Lubricate the slide pin bolts with grease provided with the brake pads, or suitable silicon grease equivalent.
  3. Install the caliper on the anchor and tighten the slide pin bolts to 18 ft. lbs. (25 Nm).
  4. Install the rear wheel.
  5. Lower the vehicle.
  6. Pump the brake pedal several times until a firm pedal is obtained in order to properly seat the pads.
  7. Refill the brake fluid reservoir to the proper level.

Posted on May 17, 2009

  • 432 Answers

SOURCE: 2006 4.7 Jeep Commander Overheating

Can you see the cooling fans come on? When the engine gets to 212 degrees the fans should come on. To test the fans, with the engine running turn the A/C on high, the fans should come on .
The system also has a 212 switch that screws into the intake manifold. This is what turns on the fans with no A/C.
I hope this helps you.

Posted on Sep 06, 2009

  • 645 Answers

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Posted on Feb 13, 2010

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

Gozer
  • 435 Answers

SOURCE: install a altenator for a 2006 jeep commander

I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.

Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.

Posted on May 21, 2010

alicantecoli
  • 22095 Answers

SOURCE: 2006 Jeep Commander inefficient catalyst

most likely the oxygen sensors (lambada) ,they need changing ,their are two one before the cat and one after,do not think you need a new cat unless it has a min of 150.000 miles on the clock

Posted on Jul 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is thermostat on 2006 jeep commander 5.7 hemi


see big hose?
water
the one that gets hot first goes to the thermostat housing
like shot.
see?
it is also (hot engine) 50 degrees hotter, than the cold one.
my IR gun tells me that.

click wk
read
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

chapter 9
its all there, for all usa ,engines.

Feb 25, 2017 | Jeep Cars & Trucks

1 Answer

Over heating problems with a 2006 jeep commander 4.7 liter


you should replace the radiator with one that has an extra row of core,they all have this problem.

Jun 18, 2015 | 2006 Jeep Commander

1 Answer

How to replace a thermostat for a 2006 jeep commander 4.7


the thermostat is located behind the housing that the lower hose is attached to. Remove the hose from the housing, remove the two bolts that hold the housing to the motor, and remove the housing. The bolts like to break so be prepaired for a simple job to turn into a major job.

Sep 05, 2013 | 2006 Jeep Commander

1 Answer

2006 Jeep Commander dash display reports "Service


It cant hurt to check your spare. It may need a bit more air.

:)

Dec 19, 2010 | 2006 Jeep Commander

1 Answer

Where is the thermostat?


Check this location diagrams...

zjlimited_70.jpg

Fig. Exploded view of the thermostat (3) showing the thermostat housing (1,2) location on the engine block (4)-3.7L & 4.7L engines


zjlimited_71.jpg

Fig. Exploded view of the thermostat housing (2) and mounting bolts (1), lower radiator hose (4) and hose clamp (3)-5.7L engine

I hope this helps (remember to comment and rate this answer).

Nov 16, 2010 | 2006 Jeep Commander

1 Answer

2006 Jeep Commander lost instrument panel power


check all fuses and battery connections start there.

Oct 13, 2009 | 2006 Jeep Commander

1 Answer

2006 Jeep Commander Scheduled Maintenace


Your Jeep dealer should be able to get you that

Mar 20, 2009 | 2006 Jeep Commander

Not finding what you are looking for?
2006 Jeep Commander Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...