Question about 1997 Kia Sephia

1 Answer

My 97 kia sephia clutch has no pressure at all.it was fine the night befor and when i started it the cluch had no pressure.any ideas

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Most likely your hydraulic hose has sprung a leak. Otherwise your problem would be with the clutch master cylinder cup or the clutch release cylinder cup. Check your clutch fluid level, if it is low there may be air in the system and it will need to be bleeded.

Posted on Jan 20, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2000 kia sephia clutch

this is a big job for someone who is not mechanically inclined but....here it goes go buy a new clutch new tranny fluid and a haynes manual at the auto parts store your going to have to drain and drop your tranny ... BUY THE CLUTCH WITH THE TOOL theres an alignment tool needed to align the plates n bearings start by pulling off both tires, brakes and both cv axels be sure to remove the intermediate shaft from the tranny on the passenger side (should come out with the axel passenger side only) so do yourself a favor and buy an impact gun with at least 500 ft lbs torque youll need it also have handy your 14mm 17mm and 19mm impact sockets and remember this job usually runs around 1,200 bucks at firestone also DO NOT remove the bolt in the middle of the front springs under the hood just the four around it and the will pop out no prob and wont need to be clamped remove the starter behind your engine its under the oil filter also if your new to this sorta thing its gonna take you about 3 days to do it buy the impact gun if ur in a hurry look at a pawn shop have your flywheel machined its going to be accessible and it needs it hope this helps dont forget the book which you should already have bought anyway its good for your torque specs which you will also need a torque wrench for the clutch also dont crack open ur tranny this isnt a honda

Posted on Jan 05, 2009

  • 3 Answers

SOURCE: Clutch

There is a spring on the pedal up under the dash, if this has come undone then the pedal may not be able to come back up to the normal position. The spring connects directly to the pedal and to a bracket under the dash.

Posted on Feb 02, 2009

goofduck
  • 490 Answers

SOURCE: 98 kia sephia, will not start seems to be fuel pump

in the gas tank

Posted on Apr 16, 2009

  • 1619 Answers

SOURCE: 98 Kia Sephia, manual transmission, clutch is to

Slave cylinder or the line to it has a leak.

Posted on May 23, 2010

Testimonial: "Thanks!!!"

  • 277 Answers

SOURCE: I have a 2000 kia sephia, the clutch pedal is

is a master cylinder leaking inside or a slave cylinder leaking.
look under car and see if slave is leaking.
for my money I would replace both cylinders because if one is going bad the other will also be worn out.

Posted on Jul 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 1.8L Kia Mentor and my clutch pedal won't sink to the floor but I can't get any gears.


There are 3 progressively difficult and expensive steps you can take. I have to assume that the Mentor is the same as a Sephia.
First: Check the level of fluid in your brake/clutch canister. It MIGHT have 2 separate canisters (like the 1995 Sephia.) But I doubt it.
Second: Check your hydraulic clutch cable and the unit at the transaxle. It may need to be bled.
Third (and most expensive): Replace your clutch and pressure plate. This is the most expensive as it requires removal of the engine.

I hope this helps you find the source of your difficulties.

Jun 02, 2014 | 1998 Kia Sephia

2 Answers

I have a 99 Kia Sephia and it will not move in any gear the clutch seems to be engaging and disengaging but the transmission will not spin the wheels in any gear


It sounds like a bad clutch. It is the clutch if you can change gears with the clutch out and the engine running.

Jul 12, 2010 | 1999 Kia Sephia

1 Answer

My '99 kia sephia overheated, shut off, now wont start


You refilled the water so where did the water you lost go? I suspect it is in the engine combustion chamber. You need to see if you have a blown head gasket and to see why it overheated before trying to start it. Remove all spark plugs and turn if over. If coolant blows out of the cylinders you have a blown head gasket.

May 07, 2010 | 1999 Kia Sephia

1 Answer

Need to see diagram on refill clutch fluid in 97 kia


autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck

Jan 24, 2010 | 1997 Kia Sephia

1 Answer

How do you adjust the cluch


The clutch is self adjusting,there is no adjustment,it is a fluid system.If it is slipping,replace the clutch .If it just will not let you put it in gear,then the slave cylinder,or brake master is bad.

Jan 21, 2010 | 2000 Kia Sephia

1 Answer

97 kia sephia axel


if your talking about the main axle bolt then you can buy a breaker bar and a large socket but you still have to almost stand on the breaker bar or you can buy an impact wrench cheap at any pawn shop.

Dec 09, 2009 | 1997 Kia Sephia

1 Answer

2001 kia sephia the clutch has dropped to the


What did you do to fix the clutch fluid loss??? if it ran dry, you need to find out where it went. You will need to replace the clutch hydraulic master and slave cylinders.

Sep 21, 2009 | 2001 Kia Sephia

1 Answer

2001 Kia


is your tranny working good? if so disconect the batteri and see what happens.by the way has it show any lights on the dash also check the tranny fluids

Aug 28, 2008 | 2001 Kia Sephia

Not finding what you are looking for?
1997 Kia Sephia Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...