Question about 2004 Chrysler Pacifica

1 Answer

Chrysler pacifica 2004 coolant keeps getting low with no visible leak

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 42 Answers

Look at your oil filer cap and if its milky looking then its possibly your cylinder head gascet

Posted on Jan 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 718 Answers

SOURCE: Where is starter located on 2004 chrysler

90e9c96.jpg
Look around the "back" of the engine beside the transmission. The Starter connects to the flywheel to start the engine.
If you are replacing the starter you may want to consider doing this first;
) Have the charging system checked. Many auto parts stores and Sears will do this for free.
) Clean the battery terminal/connectors.
) Check the wiring from the battery to make sure it's good.

If you replace the starter yourself;
) Does your car have an anti-thief alarm ? If so find how to reset it if the battery is disconnected. Some alarms will shut down the car if the battery is disconnected !!
) DISCONNECT THE BATTERY.
) Disconnct the wiring to the starter.
) Remove the bolts holding the starter. Remove the harder one to reach first.
) Pull out the old starter.
) Put it the new starter.
) Bolt the new starter in. Put the easier bolt to reach first.
) Connect the wiring to the new starter.
) Re-connect the battery.
) If necessary reset the thief alarm.
) Take the old starter back for a core charge refund.

Posted on May 15, 2009

  • 323 Answers

SOURCE: 2004 chrysler pacifica

It is for an oil change mainly and any other service your maintenance manual suggests at the mileage interval. It needs to be reset after each oil change to be accurate.

Posted on Jun 05, 2009

shadtremonky
  • 353 Answers

SOURCE: How do you replace the EGR valve on a 2004

check with you dealer, that part may have a manditory extended warranty by law

Posted on Jun 24, 2009

  • 1 Answer

SOURCE: 2004 Chrysler Pacifica Fluctuating Fuel Gauge Indicator

Hello, the answer to solve this problem is to take it to your nearest chrysler dealer and have them re-flash the updates to the ecu....since 2004, chrysler has had about 4-5 new updates since the date they were manufactured....you need to have the update that followed from your date of man. on your vehicle....They attempted to flash mine to the latest update and didnt work, turns out that they need the re-flash from back when...in order to get the gauage to stop fluctuating.....Hope this helps!!

Posted on Sep 21, 2009

  • 1024 Answers

SOURCE: serpentine belt routing for 2004 chrysler pacifica

here it is

98c85ed.gif

Posted on Apr 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What to do when 2006 Chrysler Pacifica engine temp warning light comes on?


Do not continue to operate. Operating an overheated engine will cause the engine to fail.

After the engine has cooled,
Confirm that the engine has coolant.
Confirm that the reservoir is full to the mark
Start engine and confirm as engine gets warm cooling fan at radiator turns on

Confirm that the rubber engine belt is working
Put in car heater to full hot and blower on.
Confirm heat is hot from car heater.
If heater is not hot possible water pump failure or air in coolant system keeping the coolant from circulating.
Allow to cool completely.
Remove cap start engine and observe coolant flowing at or near cap. Observe bubbling or exhaust gases coming from radiator

Check for water in oil by pulling dip stick
  • White smoke from the exhaust pipe
  • Overheating engine
  • Bubbles in the radiator or coolant overflow tank
  • White milky oil
  • Significant loss of coolant with no visible leaks
If milky likely a blown head gasket

Hope this helps?
headgasket001-hioxyjzsrsihrx1txyibv0ns-4-2.jpg

Jun 29, 2017 | Chrysler Cars & Trucks

3 Answers

If a water pump in a 2004 chrysler pacifica with 3.5l is leaking would it run out right below the crank pulley


This is common water pump failure on the pacifica, the bearings start to leak.
Since it is ran off the timing belt it is very common for the coolant to eat away at the timing belt, once that belt breaks your engine is destroyed.
This is not a repair that is OK to put off, replace the water pump timing belt and tensioner

Sep 20, 2014 | 2004 Chrysler Pacifica

1 Answer

RADIATOR COOLING FAN MALFUNCTION


maynor be pluggled in properly,why is it getting wet(do you wash the engine at the carwash with it on)is there a coolant leak leaking onto the fan cables/connectors?

Nov 30, 2012 | 2004 Chrysler Pacifica

1 Answer

What causes radiator water to be milky looking chrysler pacifica 2006


It could be an oil leak in your head gasket. when oil and water mix in your motor the result is a milky grey substance, I have only seen it in the block oil pan, not the coolant resevior.

Aug 26, 2012 | 2004 Chrysler Pacifica

1 Answer

How does the thermostat fit properly in the housing


selectachapter.gif

Pacifica, 2003-2005
Removal & Installation

Print Here is how to do it,if it does'nt fit right make sure you have the right thermostat.


3.5L Engine


CAUTION Never remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system.
  3. Disconnect radiator upper hose from thermostat housing.
  4. Remove thermostat housing bolts.
  5. Remove housing, thermostat, and gasket.

    0996b43f80204be2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
    View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine

  6. Clean gasket sealing surfaces.

To install:
  1. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
  2. Install thermostat and housing to the intake manifold. Tighten the bolts to 105 inch lbs. (12 Nm).
  3. Connect radiator hoses and install hose clamp.
  4. Refill cooling system.
  5. Connect negative cable to remote jumper terminal

May 02, 2012 | 2004 Chrysler Pacifica

1 Answer

My Chrysler Pacifica is running hot i have coolant what could be the problem


The overflow tank or radiator cap may not be holding the coolant under pressure. Try replacing the cap which would be cheaper than ant other fix.

Jan 09, 2012 | 2004 Chrysler Pacifica

2 Answers

Have 2004 pacifica heater is blowing cold air when driving turns warm then it changes to cold air. what would it be?


I would have to dealer ck the electronic controller in the dash. They use rebuilt ones but you could get one from a junk yard

Dec 12, 2011 | 2004 Chrysler Pacifica

1 Answer

I have 2004 pacifica. Heater not work, only cold air comes out. Inside windshield were frosted and I found water on bottom of inside of air filter on passenger side seat. Please, tell me how to fix it.


Heater core may be shot, not letting the coolant flow through correctly causing a leak, how's the engine temp? If it stays too high could be a water pump issue

Dec 12, 2011 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica and my blower is blowing only cold air. The heat does not work.


Tenia, the most likely cause is that you are low on engine coolant. The coolant from the engine also runs through your heater coil. Check the coolant level when the engine is cool. There is a line in the coolant resevoir that says 'Cold Max'. Add the premixed coolant until you reach that line.

If that works, I would monitor the coolant level over the next few days. If it drops again, you likely have a coolant leak somewhere.

Dec 05, 2011 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...