Question about 1995 Ford Taurus

1 Answer

How to drain the tranny

How do you drain the tranny fluid from a

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Drop the pan.

Posted on Jan 20, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to drain and fill transmission fluid in 2012 chevy malibu?


GET NEW GASKET AND FILTER FOR TRANNY ALONG WITH THE FLUID (BEFORE YOU BEGINE)
GET A LARGE FLAT DRAIN PAN.
PUT CAR UP ON 4 JACK STANDS.
place drain pan under tranny pan.
undo tranny pan screws - allow one corner to hang lower than the other corner (to allow fluid to drain) slowly remove them all.
Its messy! empty tranny pan into drain pan. set tranny pan to the side. undo the filter clamp, carefully remove the filter - set into the drain pan, remove the gasket around the tranny body/tranny pan.
Clean tranny block surface with clean cloth. install new filter, install clamp tightly. Clean tranny pan, place gasket onto pan and then reinstall tranny pan. (this only change the fluid in the tranny body and pan) If you wan the fluid out of the torque convertor you have pull the pan under the torque convertor and turn the convertor so you can get at the drain plug. Allow fluid to drain into drain pan. Reinstall drain plug and pan. (you will need a lot of fluid) Check manual for qty. Place car back on to ground/floor. Refill tranny through filler tube. Do not start the engine until oil is at full mark, and when you do start it do not all it to run for than 4 minutes - stop and add more fluid and check full mark again (repeat until no longer sinks below full mark. gently test drive around you block -- come back and check level while engine running. Top up if needed.
Siphon out excess above full mark. Test drive around 3 block,
come back check full mark. Because the torque convertor was emptied it can take a while to get all the air out it.

Jul 19, 2014 | 2012 Chevrolet Malibu

1 Answer

Where do i drain tranny fluid


At the bottom of tranny there should be a drain plug. Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.

May 20, 2010 | 2001 Mitsubishi Galant

1 Answer

Automatic tranny with overdrive shifts hard and slips big time


If you're lucky, a fluid drain and refill may fix it. If not, then it's tranny rebuild time. Also, if you don't know when the last it was serviced, don't 'flush' the tranny fluid - just have it drained/refilled/drive for 5 minutes/repeat, 3 times to get most of the old fluid out. Flushing can make it worse.

GL,
TD

Apr 21, 2010 | 1998 Mercury Mystique

2 Answers

I need help, have tranny fluid in my radiator.... i have been rebuilding a 94 f-250, 2wd, e4od tranny, 5.8liter. , and my tranny fluid is milky, changed radiator, and problem still exists.. do i have my...


The only way that tranny fluid could get into the radiator is through the transmission cooler, which is inside the radiator. Maybe the replacement rad is NFG. In any case, the torque converter holds a lot of fluid, so just draining the tranny oil pan isn't enough. The torque converter needs draining as well to get all the bad stuff out. You probably just didn't get all of the old fluid out of it. Good luck with that.

Feb 11, 2010 | 1994 Ford F250 Supercab

2 Answers

Can you mix ATF Plus 3 with ATF Plus 4 transmision fluid?


No, this is more likely an indication that you have deeper problems within the transmission.

Oct 02, 2009 | Dodge Ram Pickup 1500 Cars & Trucks

1 Answer

1996 ford station wagon LX ,transmission fluid over filled,only drives well when over drive is turned off. how do i drain some of the transmission fluid, and do you think thats the problem


Yes, too much fluid will give you overpressure in the tranny. If its a ford then you probably don't have a drain plug on the bottom of the tranny. You might have to remove several of the pan bolts on the aft edge of the tranny and let it drain that way.

Sep 24, 2009 | 1996 Ford Taurus

1 Answer

Transmission on 2001 kia sephia has to much fluid added.Where is the drain plug on this tramission to remove the extra fluid


auto tranny,some have drain plugs,some dont ,have to remove tranny pan if theres no plug.on manual tranny drain plug is under tranny,both tranny plugs if equip. are under cars drivers side

Sep 05, 2009 | 1999 Kia Sephia

1 Answer

How do I drain transmission fluid (2000 sable ls(dohc))?


On an automatic tranny, the tranny oil pan is removed to drain the tranny fluid - a somewhat messy job. Typically when this done the tranny filler is replaced. A new pan gasket is installed in this procedure.
On the manual tranny, there is a drain plug at the bottom side of the tranny to drain the oil.
I have used a home made setup using a suction pump with small diameter tubing to **** the fluid out from the tranny filler tube. This is when I was replacing the filter and I dropped the pan. I did the suction routine to avoid all that fluid dripping out when you loosen the pan.
Have you located the leak? Is it from the tranny oil pan or maybe from a tranny cooler line?

Aug 10, 2009 | 2000 Mercury Sable

1 Answer

00' Kia Sephia LS not shifting past 1st gear


first you need to buy transmission fluid new filter and new gasket.you need 11.4 pints of transmision fluid.raise front of vechicle.set parking brake.block both back wheels.besure support vechicle weight with jack stands. get a drain pan.if your transmission pan dont have a drain plug.loosen rear pan bolts a few turns.remove the front and side transmission pan bolts. let fluid drain.remove tranny pan. then clean old gasket material from transmission and pan carefully.dont scratch or damage surface.clean old tranny bolts using brake cleaner or buy new tranny bolts.you have to put a tiny film of rtv silicone on tranny bolts so they wont leak.carefully remove old tranny filter and put on new filter.clean all grease grim away from tranny pan it should be **** and span because.you might need a little gasket adhesive to hold gasket in place while putting pan back on transmission.to line up bolt holes.loosely put all bolts in you have to move pan a little to get holes line up.when all is finish put tranny fluid back in.besure you put 11.4 pints back in that about 6.5 quarts. make sure tranny fluid level is right before driving vechicle.l

Jun 19, 2009 | 2000 Kia Sephia

1 Answer

PUT ABOUT HALF OLD OIL I HAD STORED IN TRANNY CONTAINER IN TRANNY


Improper fluids in a automatic transmission can cause severe results.
Drain the transmission fluid and change the filter.
If the car was running at the time you put engine oil in the transmission, I would also flush or drain the torque converter.
Replace with the proper amount and type of fluid.

Apr 21, 2009 | 1993 Ford Crown Victoria

Not finding what you are looking for?
1995 Ford Taurus Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...