Question about 1992 Cadillac DeVille

1 Answer

When turning and stopping quick car stales - 1992 Cadillac DeVille

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 660 Answers

May be an oil pressure issue. Happened all the time to 2 of my customers.
one was fixed with a new oil pressure probe.
The other was a new oil pump & pressure unit.
May not be your problem, but try again with a fresh oil change and see if it still does it.

Posted on Jan 20, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ariens don't works most of the time when I start throwing g snow it always stale


first adjust carbureted to the sweat spot, turn mixture screw in till it sounds like funny, turn it out till it stumble, set it half way between. Grease auger shaft if applicable, check oil in auger gear case. Then try again. If this does not work do a compression test

Dec 18, 2016 | Cars & Trucks

1 Answer

Stopping with out warning


well have you check the battery?

Jun 18, 2008 | 1999 Jeep Cherokee

1 Answer

Rough idle, staling, backfiring


You are going to need to do some testing to find this...first thing I'd look at is to check for any intake or vacuum line leaks, then check map sensor and tps. I can only offer a good guess, as I too would need to do testing before offering anything better. You can get test info in most inexpensive manuals.

Jul 14, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Transmission not going into gear


I see this is kind of a stale post, but i'll try anyway. First, check your clutch fluid reservoir. If it's full, you may have air in the line, a bad master cylinder, or slave cylinder, or your clutch is worn out.

May 11, 2009 | 1990 Toyota 4Runner

1 Answer

2000 jeep wrangler stopped running


First, re-check your repair to make sure it has not come apart. Check to see if the pump is running and pump relay is working. I'm pretty sure that your filter is incorperated into the fuel pressure regulator on top of the pump assembly..If the filter is not on the frame rail near the left rear wheel, that's where you will find it.check that you have proper flow and pressure. Your problem sounds like a possible plugged filter.
Don't forget that aside from fuel, you need spark as well. Make a quick check there to make sure you're not looking for the wrong problem. An easy way to check is to squirt carb cleaner into the throttle body while cranking. If engine starts, problem is on the fuel side.

Apr 13, 2009 | 2000 Jeep Wrangler

1 Answer

Driving down the road and staled


Is the car diesel or petrol?

If a diesel, you might check the diesel pump drive belt (at the right side of engine when looking at the engine from front of car). It's possible the teeth on the belt have stripped and put the pump timing out. An alternative may be a "stop solenoid" failure. The solenoid stops diesel getting to the injectors when the "ignition" is turned off and "stalls" the engine.

I don't know if the injector pump on a petrol engine has a similar setup as a diesel but it might be worth checking.

Regards

Mar 08, 2009 | 2000 Volvo S80

1 Answer

Staling or shutting off when stopping


tork converter locking when its not suposed to try having the codes read might be a sensor in the tranny hope this helps

Mar 03, 2009 | 2003 Mercury Sable

3 Answers

Car stales after about 20 mins


the fuel pump is the only thing it could be, its building up heat after running a while and is shutting off...

Dec 02, 2008 | 1994 Chevrolet Cavalier

1 Answer

Staling


Your EGR valve may need cleaning. Could be stopped up with carbon.

May 29, 2008 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
1992 Cadillac DeVille Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...