Question about 1999 Mercury Villager

1 Answer

My mercury villager runs good at first and after warmed up she flutters and it feels like the whole front ends going to fall off

It stalls as i put in gear and at lights

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Replace ox-senser and feul filter had same problem with ford torus

Posted on Jan 20, 2013


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: car stalls while moving, then after 2-5 minutes starts back up

disconnect the fuel filter at both ends to see if the filter is clogged. If you are not getting any fuel on either end then you should get a new fuel pump.

Posted on May 25, 2009

  • 9 Answers

SOURCE: Transmission Knock

this is most likely a transmission filter being dirty and it needs to be changed regularly as does the oil in your van. this is inside the transmission and needs to be serviced to complete this job i do not recommend you trying this by your self as you could damage your transmission.

Posted on Jul 13, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Running rough& stalling

Brenda, this could be a lot of different things to cause hard start and stalling. Faulty crank sensor, idle air control valve, EGR, vacuum leak, injectors, fuel pump, ignition circuit, distributor faulty,plugs,wires,plugged exhaust, etc. Find a good technician check the codes and have them diagnose and give an estimate on repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info.
No Start Engine Stalls Mercury Villager Common Engine Problems
Nissan Quest Mercury Villager Starting Stalling Problems

May 06, 2016 | Cars & Trucks

1 Answer

Were is the map sencer on 2001 mercury villager and would this be the runs when u start it up and after it gets warm it wants to stall when u put it in gear ..or when u get it running it spi

possibly but it also could be mass air flow sensor,a fuel pressure problem ,faulty plug wires or even just a cracked dist.cap.
I would stop by a parts store ,Auto Zone or Advance will read the trouble codes for free. There are too many things that could be at fault.The code will give you a clue.If there are no codes(doubtful) suspect a fuel delivery problem.

Jan 29, 2014 | 2001 Mercury Villager

1 Answer

2002 mercury villager does not want to run when it gets warm back fires as if it is out of time but if fuel is sprayed in plunim it runs good

go here and we will get you going. Sounds like classic CMP senor going in Distributor. Get a New Rich Porter from the Import Experts on ebay. CMP is not replaceable.


Jun 04, 2011 | 2002 Mercury Villager

1 Answer

1998 Mercury Villiager stalls out when put into gear also at red lights unless it has been running for over 15 minutes?

I suspect your fast idle control is not working. Could be solenoid. Mounted on throttle body.

clean the throttle body passages and clean the MAF sensor with carb cleaner. disconnect battery for 2 hours to clear memory in computer, drive for 10 miles to relearn, may run rough for 10 miles.

also go here for Villager help

Dec 27, 2009 | 1998 Mercury Villager

1 Answer

2000 Mercury Villager ront end alignment

it i front wheel drive so you do not need 4 wheel alignment. There is no adjustment for the rear wheels. It should cost $50 to $60. Call a dealer, call a local shop, call Sears. Go to the best deal. Good luck.

Feb 05, 2009 | 2000 Mercury Villager

1 Answer

Heat blows cold when car is idling

You have an air pocket in the cooling system. To bled it out you will have to park vehicle on an incline or jack up the front end untill the radiator cap is higher than the heater core. The remove radiator cap and run engine until warm then hold rpm to about 1200 rpm's and top off coolant level until you have no more bubbles.

Feb 02, 2009 | 2001 Mercury Villager

Not finding what you are looking for?
1999 Mercury Villager Logo

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

76109 Answers


Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides