Question about Cars & Trucks

Open Question

Where is the heater resistor on 2005 kw t800 - Cars & Trucks

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 651 Answers

SOURCE: Fuse panel on 93 kw t800

Should be under the steering wheel against the firewall. here is the layout for a 95 Kenworth T800 http://kipipo.com/kenworth-t800-fuse-box.html

Posted on Jan 02, 2018

Ad
  • 528 Answers

SOURCE: Windshield wipers don't work on 1993 kw t800 where is the fuse located in the fuse panel

May not be a fuse. May be a ground wire which is easy to test. Take a short ground wire or jumpe cable and connect to good ground and to the case of the wiper motor. May even be a bad wire. Not sure where the fuse panel is but if i had to guess it would be on the left side of you feet above them when sitting. In the cab. Maybe a panel that needs to Be removed to see the fuse panel. And then hope they are labeled. Look for the owners manual for that info.

Posted on Jan 02, 2018

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse panel on 93 kw t800


Should be under the steering wheel against the firewall. here is the layout for a 95 Kenworth T800 http://kipipo.com/kenworth-t800-fuse-box.html

Jan 02, 2018 | Cars & Trucks

2 Answers

Where is the heater resistor on a 2005 dodge dakota? Behind glove box?


should be just above the blower motor. You will need to remove the glove box door to gain access.

Dec 12, 2015 | 2005 Dodge Dakota Club

1 Answer

How do I reset my check engine light on my 1997 T600 Kenworth


2010 KW T800 How to reset engine check light ' TruckersReport.com ...

www.thetruckersreport.com > ... > Kenworth Forum
Nov 8, 2011 - Is there a way to reset Engine Check Light without going to dealer? ... Inmy case it was 3725. If I run with ... 2013 Kenworth Dash panel removal.Missing: 1997 ‎t600

DIY: Reset Check Engine Light without OBDII reader ...

? 3:31
https://www.youtube.com/watch?v=TvBcdjLkBhU
Jul 1, 2014 - Uploaded by Christian Macias
Learn how to reset your Check Engine Light (CEL) without using an OBD II 2 scanner / reader tool. ... Year ...

Nov 19, 2015 | Cars & Trucks

1 Answer

2012 kw t800 i have no heat in cab the fan blows full go at start up and stays full go all water valves are open i just replaced water temp sensor and the guages in cab water and tranny not showing te


You didn't say anything about changing the thermostat. I think this may be your problem. Also check your fluid level , there may be an air pocket in the system. GOOD LUCK FRIEND.

Nov 08, 2014 | Cars & Trucks

1 Answer

2004 canyon no voltage at heater resistor


The resistor provides the ground circuit for the blower motor. So you would need to have power at the blower motor first. Grounding the motor or resistor should make the motor run.
The blower motor gets power from a 30amp fuse which gets power from a relay.

Jan 18, 2014 | 2005 GMC Canyon

1 Answer

Heater fan only works on high


the resistor bar in the heater cover has burnt out 2 resistors . replace resistors

Jan 08, 2013 | 2005 Chevrolet Malibu

1 Answer

Where is the HEATER BLOWER MOTOR FAN CONTROL UNIT on the citreon Xsara picasso 2005


Resistor pack is located in the lower heater fan housing and is accessable from foot well either drivers or passangers (could be either side) plate held on by some Torque screws

Jan 04, 2013 | 2005 Citroen Xsara Picasso

1 Answer

Where is the blower resistor on a 2004 kenworth t600


Hello..
I'm paul
Am been trying to locate heater blower resistor for my 2004 kw t600 for days but no luck please helppppp..
Thank you

Jun 16, 2012 | Cars & Trucks

6 Answers

2005 Pontiac Vibe heater fan working on high only


My 2005 Vibe did the same thing it was the heater resistor. It is located to on the firewall behind the glove box on the lower left side of the blower assembly. Two 5.5mm screws hold it in place (1/4 inch socket works too). I used a socket attached to a socket swivel to replace mine in under 10 minutes. Heater now works as good as new. I purchase mine online for $30 from rockauto.

Jul 31, 2009 | 2005 Pontiac Vibe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13614 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...